Biofouling is an ongoing problem in the development and usage of biomaterials for biomedical implants, microfluidic devices, and water-based sensors. Antifouling coatings involving surface modification of biomaterials is widely utilized to reduce unwanted protein adsorption and cell adhesion. Surface modification strategies, however, are reliant on the working material’s chemical properties. Thus, published procedures are often not applicable to a wide range of material classes. This constitutes a serious limitation in using surface modification on assembled multi-material devices, i.e on whole device modification. The objective of this research is to develop an antifouling coating with non-aggressive reaction conditions that can universally modify polymers and other material classes. Two strategies using polydopamine (PDA) as an anchor for polyethylene glycol (PEG) surface attachment were investigated: (1) PDA-PEG backfilled with bovine serum albumin (BSA), and (2) PDA-PEG with light activated perfluorophenyl azide (PFPA) conjugated to the PEG. Three materials varying in surface wettability were studied to evaluate the coatings for multi-material applications: porous polycarbonate membrane (PC), polydimethyl siloxane (PDMS), and soda lime glass cover slips.
Atomic force microscopy (AFM) and ellipsometry studies revealed substantial structural differences of PDA. Differences in PDA surface roughness affected PEG grafting in solution (the first method), with higher PEG coverage achieved on PC with intermediate surface roughness to PDMS and glass. Radiolabeled Fg adsorption and E. coli adhesion experiments showed reduced fouling on all PDA-PEG modified materials when backfilled with BSA. The ability for BSA to penetrate the PEG layer indicated that low PEG grafting densities were achieved using this grafting-to approach. The use of a photoactive labeling agent, PFPA, to tether PEG was proposed to improve PEG grafting on PDA. The PFPA-PEG modification protocol was optimized by quantifying Fg adsorption. Two treatments of PFPA-PEG were required to fully block PDA active sites. Fg adsorption was not significantly improved on PFPA-PEG modified PC and glass when backfilled with BSA, indicating sufficient PEG coverage of PDA. High Fg adsorption on PFPA-PEG surfaces indicate that high density PEG brushes were still not achieved with this method. PDMS surfaces were damaged with this procedure due to increased surface handling in the protocol. This is the first, to our knowledge, successful demonstration of PFPA modification on PDA surfaces. Photopatterning of polymer-based materials can be achieved, providing opportunities for utilising new materials in cell patterned platforms. Due to low PEG coverage on PDA surfaces from solution and using PFPA, ultra-low protein adsorption cannot be achieved using these aqueous-based methods. Antifouling modifications using PDA and PEG should be applied for short-term cell studies. / Thesis / Master of Applied Science (MASc)
| Identifer | oai:union.ndltd.org:mcmaster.ca/oai:macsphere.mcmaster.ca:11375/21453 |
| Date | January 2017 |
| Creators | Goh, Sharon |
| Contributors | Fang, Qiyin, Brash, John, Biomedical Engineering |
| Source Sets | McMaster University |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0024 seconds