This dissertation involves the experimental investigation of commercially pure titanium (CP Ti) which was subjected to laser forming and mechanical forming processes. Commercially pure titanium grade 2 was formed to a radius of curvature of approximately 120 mm using three forming procedures, i.e. i) laser forming; ii) mechanical forming (stretched forming) and iii) a combined forming process (laser-mechanical forming). Fatigue testing revealed, for all the forming processes, that samples produced by laser forming performed the best at high load settings. However, mechanically formed specimens performed the best at low load settings, whereas the laser-mechanical process resulted in midway performance between laser and mechanical processing. Considering microstructure vs fatigue; impact vs fatigue; and residual stress vs fatigue; at high load settings it is evident that the microstructure is the dominant contributor to crack initiation and growth. Crack morphology of fatigue samples revealed that secondary cracks (parallel to main crack front) followed the grain boundaries of the Widmanstätten microstructure, whereas irregular secondary cracks grew parallel and through the twinning planes and along the grain boundaries of the equiaxed microstructure. Laser forming resulted in microstructural changes from equiaxed grains to a Widmanstätten structure due to fast cooling rates. Excessive twinning is developed within the equiaxed microstructure after the mechanical forming procedure. This is due to cold working / strain hardening. The combined process shows a combination of equiaxed grains and Widmanstätten microstructure. Residual stress relieved for all forming processes revealed an increase in the magnitude of the residual stress compared to the parent plate and that the maximum values were obtained at the inner radius of curvature (i.e. 118.4 mm). Laser forming revealed the highest values in residual stress whereas the other two processes i.e. mechanical and laser-mechanical forming exhibited an increase midway between the parent plate and laser forming. The second most influential factor with regards to fatigue was the magnitude of the residual stress, especially at medium to low load settings. When considering theoretical models to predict fatigue life it was found that the Goodman model showed the closest relation to the actual fatigue data when considering the entire theoretical curve. Vickers microhardness profiling was applied to the thickness of the samples for the parent plate and all forming processes. No significant hardening occurred due to the forming processes and differences in hardness were considered negligible. Charpy impact testing revealed that the laser formed specimens exhibited the most brittle behaviour when compared to the parent plate results. Mechanical formed specimens showed a slight increase in brittleness compared to parent plate whereas the combined process yielded results midway between the laser and mechanically formed specimens. Mathematical equations are formulated and presented for predicting the fatigue life of CP Ti grade 2 for the parent plate and the three forming processes. This study proved that the laser forming process can be successfully used as a production stage in the forming of CP Ti grade 2.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:nmmu/vital:9634 |
| Date | January 2012 |
| Creators | Fidder, Herman |
| Publisher | Nelson Mandela Metropolitan University, Faculty of Engineering, the Built Environment and Information Technology |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Thesis, Masters, MTech |
| Format | xxviii, 184 leaves, pdf |
| Rights | Nelson Mandela Metropolitan University |
Page generated in 0.0096 seconds