Return to search

Acoustic monitoring and control system to determine the properties of damping materials

Experience shows that the noise and sound quality in vehicles are often a recurring criticism. The bodies of modern vehicles consist predominantly of thin sheets of metal. It is hard to prevent the excitation of bending vibrations and the subsequent emission of disturbing noise while driving. The noise spectrum in a car that can be heard by the driver is from ”latent roar” to ”chattering” noise of the body and engine. In automotive vehicles damped materials, especially plastics or materials made from sheet metal and surface damping treatments, are used. Those have high internal energy losses and damp sound oscillatory systems found in the body or interior of cars. A further advantage of such treated components is that they are applied to existing components working over wide temperature and frequency ranges. Many companies provide such ”sound-absorbing compounds”. The requirements for these damping materials are high temperature-resistance, water repellence, fuel and oil-resistance and good adhesion to the base material [17]. The acoustic properties, especially the damping of the plate vibrations through rubber are of interest. the question arises how can the damping coeficient of coated metal sheets can be measured and secondly, by how much the road noise is reduced when built-in sheets are coated with a known damped material. With the Oberst Bar Test Method (named after Dr. H. Oberst) the properties are determined of the internal damping materials that can be used to simulate mechanical constructions to determine damping of larger surfaces. This method describes a laboratory test procedure for measuring the mechanical properties of damped materials. A block diagram of the test system consisting of a damped material bonded to a vibrating cantilever steel bar is shown in figure 2.1. This method is useful for testing materials such as metals, enamels, ceramics, rubbers, plastics, reinforced epoxy matrices and wood. In addition to damping measurement, the test allows for the determination of the Young’s modulus E of the material. E is calculated from the resonance frequency of a given mode and from the physical constants of the bar. By associating the damping factor with the Young’s modulus, a complex quantity is defined which is called the Complex Modulus of Elasticity. Measurements of dynamic mechanical properties are also useful in the research on the molecular structure of materials.

  1. vital:9658
Identiferoai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:nmmu/vital:9658
Date January 2012
CreatorsStahlberg, Martin
PublisherNelson Mandela Metropolitan University, Faculty of Engineering, the Built Environment and Information Technology
Source SetsSouth African National ETD Portal
LanguageEnglish
Detected LanguageEnglish
TypeThesis, Masters, MEngineering (Mechatronics)
Formatxi, 106 leaves, pdf
RightsNelson Mandela Metropolitan University

Page generated in 0.0021 seconds