The necessary clearance at the tip of unshrouded rotors of axial turbines allows fluid
to leak from the pressure to the suction side of the blade and produces an important
component of loss that is ultimately responsible for approximately 25 % of the total
turbine rotor losses. Leakage fluid can pass through the tip clearance gap with either
high or low loss generation. It has been customary in turbine design to employ high
loss designs since it is only by the creation of loss that the gap mass flow rate can
be restricted. The present work, however examined the effect of streamlined tips
that have low entropy generation within the tip and high leakage flows.
An axial turbine followed by a second stage nozzle (ie one and a half stages) was
designed, built and instrumented and used to evaluate performance with particular
reference to the understanding of tip clearance effects in a real machine and possible
benefits of streamlined low loss rotor tips. A radiused pressure edge was found to
improve the performance of a single stage and of a one and a half stage turbine at
the selected tip clearances. This was in contrast to previous cascade results where
mixing losses reduced the benefits of such tips. Clearance gap flow appears to be
similar to other turbine flow where the loss mechanism of separation must be
avoided. Loss formation within and downstream of a rotor is more complex than
previously realized and does not appear to obey the simple rules used to design for
minimum tip clearance loss. For example, approximately 48 % of the tip leakage
mass flow within a rotor may be a flat wall-jet rather than a vortex.
Second stage nozzle efficiency was significantly higher than first stage nozzle
efficiency, and even increased with tip clearance. This was a surprising result since
it means that not only was there a reduction in secondary flow loss but also that
rotor leakage and rotor secondary flows did not generate significant downstream
mixing loss. The manner in which the second nozzle responds to the complex
leakage flows presented to it and how it completes the formation of tip clearance loss
for various rotor tip clearances was identified.
The tangentially averaged relative rotor flow in the tip clearance region differed
radically from that found in cascades which was seen to be underturned with a high
axial velocity. There was evidence rather of overturning presumably caused by
secondary flow. Axial velocity followed an almost normal endwall boundary layer
pattern with almost no leakage jet effect. Cascade tip clearance models are therefore
not accurate in predicting leakage flows of real rotors.
The reduction in second stage nozzle loss was seen to occur near the hub and tip
confirming a probable reduction in secondary flow loss. Nozzle exit loss contours
showed that the leakage flow suppressed the formation of the classical secondary flow
pattern and that a new tip clearance related loss phenomenon existed on the suction
surface. The second stage nozzle reduced the hub endwall boundary layer below that
of both the first nozzle and that behind the rotor. It also appeared to rectify the
secondary and tip clearance flows to the extent that a second stage rotor would
experience no greater flow distortion than the first stage rotor would.
Radial flow angles behind the second stage nozzle were found to be much smaller
than those measured in a previous study of low aspect ratio, untwisted blades. / Thesis (Ph.D.)-University of Natal, Durban, 1993.
| Identifer | oai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:ukzn/oai:http://researchspace.ukzn.ac.za:10413/6880 |
| Date | January 1993 |
| Creators | Morphis, George. |
| Contributors | Bindon, J. P. |
| Source Sets | South African National ETD Portal |
| Language | English |
| Detected Language | English |
| Type | Thesis |
Page generated in 0.0028 seconds