Return to search

Optimisation of water-in-oil microemulsion formulation stabilised by nonylphenol ethoxylated phosphate ester

Water-in-oil (w/o) microemulsion systems, stabilised by either an anionic surfactant or a cationic surfactant were studied. The anionic system consisted of ethoxylated nonylphenol phosphate esters (Atpol), Shellsol oil and an alcohol. These microemulsions tolerated an increase in ionic strength of the water phase up to a point: Beyond this point no microemulsion could be obtained. However, adding amine salts, e.g. diethanolamine nitrite, improved the emulsification of the aqueous phase. Increasing the alcohol (cosurfactant) chain length up to octanol also increased the uptake of the aqueous phase. Thus octanol yielded the best results in terms of emulsifying large volumes of the water-phase, particularly at high salt concentrations. A key objective was to prepare stable microemulsions with high nitrite content. The maximum microemulsion nitrite contents (expressed as NaNO2equivalent by mass) achieved were: -- About 10% when a 30% NaNO2solution was emulsified -- 23% when neat diethyl ethanolamine nitrite (DEEAN) was solubilized, and -- 23% for mixtures of diethanolamine nitrite (DEtOHAN) and NaNO2 in water. The cationic microemulsion system was based on the double-chain cationic surfactant, didodecyldimethyl ammonium chloride (DDAC). In this case the solubilization of the following acetate salts were investigated: ammonium, sodium, magnesium, zinc and manganese. As with the Atpol system, it was found that increasing the ionic strength is detrimental to microemulsification of the aqueous phase. In the DDAC system, an increase in the alcohol chain length beyond butanol led to reduced aqueous phase uptake. Thus the natures and concentrations of the surfactant and the cosurfactant as well as the ionic strength of the aqueous phase determine the stability and the emulsification of large volumes of aqueous phase. In general there is an optimum ionic strength at which the salt content of the microemulsion formulation is maximised. / Dissertation (MSc (Chemistry))--University of Pretoria, 2007. / Chemistry / unrestricted

Identiferoai:union.ndltd.org:netd.ac.za/oai:union.ndltd.org:up/oai:repository.up.ac.za:2263/22973
Date06 March 2006
CreatorsMdhlovu, Johan
ContributorsProf W W Focke, upetd@ais.up.ac.za
Source SetsSouth African National ETD Portal
Detected LanguageEnglish
TypeDissertation
Rights© 2005, University of Pretoria. All rights reserved. The copyright in this work vests in the University of Pretoria. No part of this work may be reproduced or transmitted in any form or by any means, without the prior written permission of the University of Pretoria.

Page generated in 0.0022 seconds