This thesis focuses on the design of new high pressure injection system application on diesel engine. The design came from company Zetor’s demands. For this application was chosen system Common Rail supplied by company Bosch. Assignment was separated into several tasks. Research of suitable components for low pressure section, design of waste system and high pressure injection tubes design including injector clamping. Due to injectors used in this system was necessary to redesign cover for valves and even new system to lead wires from outside of the engine to injectors. Injector is attached by screw connection, which is composed from screw and clamping jaw. These parts are subjected to an analytic calculations. Clamping jaw of injector is even subjected to a FEM analysis, which focuses on fatigue life. Finally, the drawings were documented.
| Identifer | oai:union.ndltd.org:nusl.cz/oai:invenio.nusl.cz:378502 |
| Date | January 2018 |
| Creators | Ševčík, Ondřej |
| Contributors | Prokop, Aleš, Dundálek, Radim |
| Publisher | Vysoké učení technické v Brně. Fakulta strojního inženýrství |
| Source Sets | Czech ETDs |
| Language | Czech |
| Detected Language | English |
| Type | info:eu-repo/semantics/masterThesis |
| Rights | info:eu-repo/semantics/restrictedAccess |
Page generated in 0.0022 seconds