Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 38 for “"1.8 GHz"”.
-
A 1.8-Ghz CMOS Fractional -N Frequency Synthesizer With Randomized Multiphase VCO
… demonstrate the concept, a fully integrated 1.8-GHz frequency synthesizer with randomized multiphase VCO was designed. The prototype, implemented in a standard 0.6-mum CMOS technology, achieves -118 dBc/Hz phase noise at 1-MHz offset and exhibits close-in phase noise between -80 and -90 dBc/Hz up …
-
The effects of a 1.8 GHz continuous electromagnetic fields on mucociliary transport of human nasal mucosa
… study was to investigate the effects of a 1.8 GHz continuous electromagnetic fields (EMF) on human nasal mucociliary transport and to determine the pathophysiology of ciliary beat frequency (CBF) during an EMF-induced change. Human nasal mucosa cells were exposed to a 1.8 GHz EMF (SAR= 1.0 …
-
Measured and Modeled Time and Angle Dispersion Characteristics of the 1.8 GHz Peer-to-Peer Radio Channel
In an extensive outdoor propagation study, low antenna heights of 1.7 m are used at both the transmitter and the receiver to measure over 3500 wideband power-delay profiles (PDPs) of the channel for a peer-to-peer communications system. Rural and urban areas are studied in 22 different …
-
A 1.8 GHz LC-Voltage Controlled Oscillator Using On-Chip Inductors and Body Driven Varactors in CMOS 0.35 μm process
… is to design a completely integrated 1.8 GHz LC-VCO for a GSM or DCS-1800 receiver in standard CMOS 0.35μm technology. The major challenge in a completely integrated LC-VCO is to develop an fully integrated inductor. In this research various means of implementing an integrated inductor …
-
A Fully Synthesized Injection Locked Ring Oscillator Based on a Pulse Injection Locking Technique
… free running oscillator is from 210 MHz to 1.8 GHz with a 1.1 volt power supply. The tuning range from 1.0 to 1.8 GHz can be achieved with 215 tuning steps with a maximum step size of 11.2 MHz, that is well within the worst case 75 MHz (3rd sub-harmonic) and 32 MHz (9th sub-harmonic) locking …
-
All-Passive Composite Right/Left-Handed (CRLH) Antenna Array for Sum and Difference Patterns
… has been designed for in-phase output at 2.5 GHz and a phase difference of 180o at 1.8 GHz by injecting a CRLH unit cell in one of the output arms. In addition, microstrip power dividers are designed to implement the amplitude distribution. These are incorporated with dual-band microstrip …
-
Design of broadband vector-sum phase shifters and a phased array demonstrator
… demonstrated beam steering capability at 1.8 GHz.
-
Characteristic Mode Approach to Understanding a Capacitively Fed Crossed Bow-tie Antenna
… mode which reduced their modal resonances by 1.8 GHz and 25 MHz respectively. Three characteristic modes were found to make up the response of the capacitively fed crossed bow-tie antenna. Each mode was decoupled into auxiliary modes to remove coupling effects from eigenvalue crossing avoidances. …
-
Novas técnicas de otimização de casamento de impedância de antenas planares para sistemas de comunicação sem fio
… lines and designed for operation at 1.8 GHz, 2.45 GHz, and 3.5 GHz. Simulation and parametric analyses were performed using Ansoft Designer and Ansoft HFSS softwares, that implement the method of moments (MoM) and the finite element method (FEM), respectively. In addition, the wave …
-
Optimisation of a compact cold-atoms interferometer for gravimetry
… here can achieve fast frequency sweeps over 1.8 GHz within 2 ms, making it widely applicable in compact atom-interferometry experiments with rubidium atoms. This is shown by creating a Mach–Zehnder type interferometer with counter-propagating Raman beams, thus enabling measurements of …
-
Multi-gigabit low-power wireless CMOS demodulator
… IF-to-baseband conversion gain of 25 dB with 1.8 GHz of baseband bandwidth and a dynamic range of 23 dB while consuming only 46 mW from a 1 V supply voltage. Several different demodulators using analog signal processor (ASP) are implemented: (1) an ultra-low power non-coherent ASK demodulator is …
-
A PLL frequency synthesizer and Gilbert cell multiplier for a 916 MHz ISM band transmitter realized in 0.5 [mu]m [i.e. micrometer] CMOS technology
… signal with a maximum operating frequency of 1.8 GHz. An off-chip LC tank voltage controlled oscillator was prototyped with a tuning range of 120 MHz, dissipated 3.3mW, -15dBm single-ended output signal, and had a phase noise performance of -60dBc at a 10 kHz offset and -80dBc at 100 kHz offset is …
-
Monolithic integration of semiconductor ring lasers
… as short as 120 ps at a repetition rate of 1.8 GHz are obtained by injecting only a few mA of current into the tuning section.
-
Design and implementation of band rejected antennas using adaptive surface meshing and genetic algorithms methods. Simulation and measurement of microstrip antennas with the ability of harmonic rejection for wireless and mobile applications including the antenna design optimisation using genetic algorithms.
… to operate at frequencies 1.0, 1.8 and 2.4 GHz respectively. The microstrip patch antenna with stub tuned microstrip lines was also employed at 1.0 and 1.8 GHz to meet the design objectives. A new sensing patch technique is introduced and applied in order to find the accepted power at …
-
Implementation of MPICH on top of MPLi̲te
… Ethernet connections. The PC cluster has two 1.8 GHz Pentium 4 PCs and the Alpha cluster has two 500 MHz Compaq DS20 workstations. Different network interface cards like Netgear, TrendNet and SysKonnect Gigabit Ethernet cards were used for the measurements. Both the blocking and non-blocking …
-
Bias Circuit for RF Power Amplifiers
… mainly for class AB operation in the 1.8 GHz band. The transistor with internal decoupling seems to alleviate the baseband impedance variation problem thus making it easier to pre-distort. Simulation result gave a baseband impedance of 0.3Ω at 11 MHz and 11Ω at 194 MHz for the transistor …
-
Modelo 2,5D de predição de propagação para ambientes interiores utilizando o método do traçado de raios
… are compared with the measured values at 1.8 GHz ftequency. The results were obtained for the main corridor and room classes adjacent to it. A reasonable agreement is observed. The numerical predictions are also compared with published data at 900 MHz and 2.44 GHz frequencies showing good …
-
Modeling and wideband characterization of radio wave propagation in microcells
… × 8 uniform linear array system operating at 1.8 GHz shows that S 4W is able to reproduce fading statistics and that the estimation of MIMO channel capacity using ray-tracing method is dependent on the accuracy of the input propagation environment.
-
Cryogenic Noise-Parameter Measurement and the Design of Cryo-CMOS Circuits
… from 15K to 325K for frequencies up to 6 GHz and achieves a noise-temperature uncertainty of less than 1 K. The designed cryo-CMOS LNA operates at 20K over a frequency band of 0.9-to-1.8 GHz and achieves an average noise temperature of 5.4 K, an average gain of 37.2 dB, and an input return …
-
A Broadband Variable-Gain Amplifier and a Broadband Self-Calibrated High-Sensitivity Power Detector for the Square Kilometre Array
… dB error, an upper 3 dB cutoff frequency of 2.1 GHz and a power consumption of 1.1mW. Both S11 and S22 are less than -10 dB from 100 MHz up to 4.2 GHz. This VGA achieved the lowest power consumption among comparable VGAs published to date. A differential broadband self-calibrated RMS PD using the …
Page 1 of 2