Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 23 for “"233U"”.
-
Pulsformsanalys för identifiering av fissionsfragment från 233U
… data insamlad från ett experiment med fission av 233U, utfört i juli 2025 vid ISOLDE Solenoidal Spectrometer vid CERN, Genève. Mer specifikt undersöks möjligheten att identifiera laddningen hos fissionsfragmenten med hjälp av PSA. En analysalgoritm i Python implementerades för att extrahera en …
-
The 233U Fission and Capture Cross Sections and Their Analysis at Low Engines
The 233U fission and capture cross sections were measured using a nuclear-device neutron source and time-of-flight techniques. Cross section data are presented from 20 to 106 eV for fission and from 20 to 63 eV for fission + capture. The resonance region (20 eV to 63 eV) was fitted with both a …
-
Mass Spectrometric Studies of the Stable Cadmium Isotopes in the Thermal-Neutron Fission of 233U and 235U
… produced in the thermal-neutron fission of 233U and 235U using a solid-source mass spectrometer. The results for 235U fission indicate that there is structure in the mass-yield curve for the region studied which takes the form of a depression around masses 112-114. The origin of this …
-
Nuclear charge distribution for the 131 and 133 mass chains from the thermal-neutron induced fission of ^233U
… were measured for the thermal-neutron fission of 233U. The measured values are 0.52[plus or minus]0.03, 0.08[plus or minus]0.04, 0.334[plus or minus]0.020, 0.135[plus or minus]0.020, 0.55[plus or minus]0.02, o.21[plus or minus]0.02, 0.014[plus or minus]0.003 and 0.155[plus or minus]0.010, …
-
An analysis of the MSRE U-233 initial criticality for benchmark problem development
… one with 235U-based fuel salt, and one with 233U-based fuel salt. This work assesses the feasibility of using experimental data from the 233U zero-power initial critical experiment for the development of a criticality benchmark problem. This includes a reconstruction of best-estimate values …
-
Fail-safe source-driven fission and fusion-fission hybrid reactor configurations
… A circulating liquid molten salt using the Th-233Ufuel cycle,where the fission products are continuously extracted,further contributes to the fail-safe characteristic by avoiding the cooling neededfor the decay heat or afterheat after reactor shut-down. Through the extraction of the …
-
Modeling Pa-233 Generation in Thorium-Fueled Reactors for Safeguards
… diversion of 233Pa which can then decay to 233U – special fissionable material that should be under International Atomic Energy Agency (IAEA) safeguards. To better understand the concern of this potential proliferation challenge of thorium, different nuclear material accountancy techniques …
-
Fission product mass yields in uranium-233 and plutonium-239 from fast-neutron-induced fission
… (2E) method. Mass yields, TKEs, and ∆TKEs of 233U(n,f) and 239Pu(n,f) were determined at energies up to 100 MeV and compared to literature values at the few energies available. Calibration yields of 252Cf(sf) were measured in order to benchmark the experimental setup. An improved quality of …
-
Isotope Ratio Triangulation: A Method for Determining Uranium Isotope Ratios and Application to the Search for Uranium Isotope Anomalies in the Mineral Titanite
… laboratories take advantage of a mixed 235U-233U spike for precise uranium isotopic measurements and current data reduction algorithms assume a uniform 238U/235U value of 137.88. Recent re-evaluation of the isotope ratio of “natural” uranium value used in geochronology has called into …
-
Impact of thorium based molten salt reactor on the closure of the nuclear fuel cycle
… salts as a nuclear fuel. It uses 232Th and 233U as the fertile and fissile materials, respectively. Fluoride salt of these nuclides is dissolved in a mixed carrier salt of lithium and beryllium (FLiBe). The objective of this research was to complete feasibility studies of a small commercial …
-
Development of a rapid, solvent extraction based radioanalytical technique for monitoring low-level actinide concentrations in water supplies
… Detectable Concentrations (MDC) for 238Pu and 233U of 3.5x10-2 Bq/L and 0.16 Bq/L, which equates to 2.3x10-16 and 2.0x10-12 mol/L, respectively. The MDC value for plutonium is an order of magnitude lower than the value set by the Environmental Protection Agency (EPA) for the Safe Water Drinking …
-
Analysis of multi-recycle thorium fuel cycles in comparison with once-through fuel cycles
… uranium dioxide (UOX) vs. thorium dioxide with 233UOX (233U-ThOX), natural uranium dioxide mixed with transuranic oxides (U-TRUOX) vs. thorium dioxide mixed with transuranic oxides (Th-TRUOX), natural uranium dioxide mixed with weapons grade plutonium dioxide (U-WGPuOX) vs. thorium dioxide mixed …
-
Fission fragment distribution measurements with time of flight - energy (ToF-E) spectrometers
… Single arm analysis of SPIDER data from 233U(nth,f) with the same operating conditions as the 235U(nth,f) run showed a potential lower limit on mass resolution of 2-3 amu FWHM for light products and 4-6 amu FWHM for heavy products. Again, using the 2E-2v analysis method resulted in …
-
Purification of Uranium Tetrafluoride Using Ammonium Bifluoride
… salts is uranium tetrafluoride (UF4) using 233U of the thorium fuel cycle. UF4 is extremely hygroscopic, meaning it will react with moisture and oxygen in its environment, so as-received powders contain significant levels of impurity. In order to have UF4 for use in experimental …
-
Criticality Safety Evaluation to Address Potential Over Conservative Restrictions in 49 CFR Fissile Materials – Exceptions
… array systems were modeled for fissile isotopes 233U and 235U. The research demonstrated that for fissile exception (a) there was significant over-conservatism applied and the max gram loading can be increased from 2 g per container to 4 g per container. The recommendation is that the revised …
-
The Preparation and Application of Thorium-based Nuclear Fuels
… irradiating thorium and converting it to fissile 233U. Thorium and uranium may be recovered from spent nuclear fuel by the Acid THOREX process, which uses TBP solvent extraction. However, TBP has a number of disadvantages. In this work several alternative solvent extraction systems were …
-
Advanced Fuel Cycle Scenarios with AP1000 PWRs and VHTRs and Fission Spectrum Uncertainties
… distorted fission spectrum tail is used. 233U, 236Pu and 237Pu inventories and activities are multiplied by 263, 523 and 34 but are still negligible compared to 239Pu mass or the total activity. The AP1000-VHTR system is in conclusion not dependent on the selected fission spectrum …
-
INVESTIGATION OF LATTICE PHYSICS PHENOMENA WITH UNCERTAINTY ANALYSIS AND SENSITIVITY STUDY OF ENERGY GROUP DISCRETIZATION FOR THE CANADIAN PRESSURE TUBE SUPERCRITICAL WATER-COOLED REACTOR
… depletion and the production of minor actinides, 233U and xenon. It was also found that a higher thermal energy barrier is recommended for the two-energy-group structure since the PT-SCWR is characterized by a large coolant temperature compared to the conventional water thermal reactors. Two, …
-
Analysis of specific design aspects of a thorium-uranium fuelled European Pressurised Reactor
… to be slightly more epithermal). The breeding of 233U increased. Also an increase in 239Pu caused the Xe and Sm concentrations to increase, which offset the addition of excess reactivity due to higher fissile content. However, the initial Th-EPR FAB1 design without the addition of moderation rods …
-
Lattice Physics Calculations for Alternative Fuels for the Canadian SCWR
… in the SCWR reactor. This leads to production of 233U that can significantly extend the lifetime of fuel in the reactor, compared to fuels with either 238U or no fertile source. Even though the plutonium-thorium fuel cycle seems generally advantageous compared to traditional uranium fuels, or even …
Page 1 of 2