Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 101 for “"28 GHz"”.

  1. Diffraction by Building Corners at 28 Ghz: Measurements and Modeling

    This thesis presents the results of a 28 GHz continuous-wave (CW) diffraction measurement campaign in the Washington, DC area. It describes the measurement approach including information on equipment and testing methods. Also described are the various parameters that affected the diffraction loss. …

    vt Repository record for Diffraction by Building Corners at 28 Ghz: Measurements and Modeling (opens in a new tab)

  2. Design of 28 GHz 4x4 RF Beamforming Array for 5G Radio Front-Ends

    … and harnessing the necessary bandwidth below 6 GHz is not feasible. A move to higher frequencies sees not only increased fractional bandwidth, but also significantly enhanced antenna apertures as a result of beamforming capabilities. Due to device level complications with frequencies nearing the …

    waterloo Repository record for Design of 28 GHz 4x4 RF Beamforming Array for 5G Radio Front-Ends (opens in a new tab)

  3. Performance Comparison of Harmonically Tuned Power Amplifiers at 28 GHz in SiGe BiCMOS

    … class-F and inverse class-F (class-F-1) at 28 GHz. The PAs have identical input networks: input matching, base DC feed, and base stabilizing networks. At the load side, there is a different load network for each PA. Class-AB PA load network has a single inductor with a parasitic capacitor to …

    vt Repository record for Performance Comparison of Harmonically Tuned Power Amplifiers at 28 GHz in SiGe BiCMOS (opens in a new tab)

  4. A Study of Rough Surface Scattering Phenomena in the LMDS Band (28 GHz)

    … phenomena were investigated in the LMDS band (28 GHz). We used the newly developed sampling swept time delay short pulse (SSTDSP) sounder to collect field data in certain locations on the Virginia Tech campus. The sounder collected the channel impulse response analog waveform, sampled, …

    vt Repository record for A Study of Rough Surface Scattering Phenomena in the LMDS Band (28 GHz) (opens in a new tab)

  5. Channel Impulse Response and Its Relationship to Bit Error Rate at 28 GHz

    … high bandwidth wireless communication system at 28 GHz (Local Multipoint Distribution Service frequency). This system provides a large bandwidth radio link to a disaster zone up to 5 km away and puts Ethernet speeds and 802.11 accesses to users within hours. Because of the possible variability in …

    vt Repository record for Channel Impulse Response and Its Relationship to Bit Error Rate at 28 GHz (opens in a new tab)

  6. RF and GIS: Field Strength Prediction for Frequencies between 900 MHz and 28 GHz

    … strength for frequencies between 902 MHz and 28 GHz. The model approximates diffraction using the knife-edge concept and equations proposed by Lee (1985). LOS pathways are calculated using the Bresenham algorithm and the corresponding elevations are obtained from a 30m DEM base map. The base …

    vt Repository record for RF and GIS: Field Strength Prediction for Frequencies between 900 MHz and 28 GHz (opens in a new tab)

  7. Efficient and Linear CMOS Power Amplifier and Front-end Design for Broadband Fully-Integrated 28-GHz 5G Phased Arrays

    … mm-Wave mobile services, especially in the 28-GHz band. Previous widely-held perceptions of fundamental propagation limitations were overcome using phased arrays. Equally important for success of 5G is the development of low-power, broadband user equipment (UE) radios in commercial-grade …

    tamu Repository record for Efficient and Linear CMOS Power Amplifier and Front-end Design for Broadband Fully-Integrated 28-GHz 5G Phased Arrays (opens in a new tab)

  8. A Radio-Propagation-Measurement-Based Study of the Capacity of Multi-User Distributed-MIMO Indoor Channels at 18 and 28 GHz

    … same or greater system capacities as current 2 GHz systems. In the interest of avoiding obstruction losses, the focus was on the use of directive antennas at frequencies above 2 GHz to receive radio signals from reflectors and scatterers that could be stronger than those received over direct …

    carleton Repository record for A Radio-Propagation-Measurement-Based Study of the Capacity of Multi-User Distributed-MIMO Indoor Channels at 18 and 28 GHz (opens in a new tab)

  9. Palydovinių žemės stočių bei penktos kartos judriojo radijo ryšio stočių elektromagnetinio suderinamumo analizė su fiksuotojo radijo ryšio stotimis, radijo dažniuose: 28 GHz ir 1,5 GHz /

    … Starlink, ESIM, mobile service in the 1.5 GHz band. Tolerated threshold degradation for FS links is 0.4 dB. Starlink earth stations’ caused interference was calculated using rec. ITU-R P.452, time percentage probability set to 20 % and taking into account earth surface topography and …

    vilnius Repository record for Palydovinių žemės stočių bei penktos kartos judriojo radijo ryšio stočių elektromagnetinio suderinamumo analizė su fiksuotojo radijo ryšio stotimis, radijo dažniuose: 28 GHz ir 1,5 GHz / (opens in a new tab)

  10. Fire Detection using RF Signals

    … fire detection. We focus on RF signals in the 5 GHz frequency band in the first part of the thesis, which corresponds to the same frequencies that have been used in previous research on Wi-Fi fire detection. We then move on to the 28 GHz frequency band since there is some existing work on fire …

    waterloo Repository record for Fire Detection using RF Signals (opens in a new tab)

  11. Reconfigurable Microwave/Millimeter-Wave Devices Using Liquid Crystal Technology

    … quality factor ranging from 44 to 123 at 1 GHz. With a biasing control voltage from 0 V to 40 V, the fabricated micromachined capacitor demonstrates an 18% capacitance shift. The LC-based series capacitor, demonstrated with an integrated bias line, isolates voltage control from RF terminals, …

    waterloo Repository record for Reconfigurable Microwave/Millimeter-Wave Devices Using Liquid Crystal Technology (opens in a new tab)

  12. Millimeter Wave Dual-Polarized Energy Detection Backscattering RFID for 5G IoT Energy Autonomous Applications

    … of this thesis is to design and evaluate a 28 GHz backscattering Millimeter Wave Identification (mmID) system for detecting cross-polarized power sources. The research focuses on optimizing the system’s detection sensitivity, modulation, and reliability across diverse operational …

    gatech Repository record for Millimeter Wave Dual-Polarized Energy Detection Backscattering RFID for 5G IoT Energy Autonomous Applications (opens in a new tab)

  13. Isolation improvement and user-effect modeling for antenna arrays in 5G and beyond

    … body to mm-wave handset antennas operating at 28 GHz and 60 GHz. The effect of the proximity of fingers to handset antennas is studied giving novel approaches how to mitigate the effect by utilizing beamsteering and by a thin reflector decreasing the shadowing over 20 dB. Furthermore, …

    aalto Repository record for Isolation improvement and user-effect modeling for antenna arrays in 5G and beyond (opens in a new tab)

  14. Millimeter-wave and sub-terahertz on-chip antennas, arrays, propagation, and radiation pattern measurements

    … towards unused carriers fre- quencies such as 28 GHz, 60 GHz, and 180 GHz will alleviate network conges- tion while simultaneously providing massive bandwidths to consumers. This dissertation summarizes research in understanding millimeter-wave wireless propagation, the design and fabrication …

    texas Repository record for Millimeter-wave and sub-terahertz on-chip antennas, arrays, propagation, and radiation pattern measurements (opens in a new tab)

  15. Digital Predistortion of Millimeter-Wave Phased Antenna Arrays

    … of a 4-element and 64-element array at 28 GHz with 800 MHz modulated signals using a single over-the-air feedback signal. The SISO DPD uses different sets of coefficients to cope with changes in both linear and non-linear distortions as the beam is steered. Second, the SISO DPD …

    waterloo Repository record for Digital Predistortion of Millimeter-Wave Phased Antenna Arrays (opens in a new tab)

  16. Metasurface-augmented gradient-index lenses for millimetre-wave applications

    … was achieved across a frequency range of 26 – 28 GHz. The operational bandwidth extended to 24 – 38 GHz with a wideband Phoenix reflectarray. The half-circle Maxwell fisheye lens (HMFL) beamformer maintained its focal axis and achieved a maximum angle of 45° within a frequency range of 26 – 28 …

    qu-belfast Repository record for Metasurface-augmented gradient-index lenses for millimetre-wave applications (opens in a new tab) Download PDF for Metasurface-augmented gradient-index lenses for millimetre-wave applications (opens in a new tab)

  17. Novel Hardware Systems and Signal Processing Techniques for Propagation Measurement in IoT, Microwave and mmWave Channels

    … performance, portable sounders for VHF / UHF and 28 GHz are created and subsequently used in novel use cases to elicit new channel propagation models. The VHF / UHF sounder had a measurement floor of -130 dBm. In suburban settings, it showed channel reflection delays did not exceed 1 μs over 4 km. …

    whiterose Download PDF for Novel Hardware Systems and Signal Processing Techniques for Propagation Measurement in IoT, Microwave and mmWave Channels (opens in a new tab)

Page 1 of 6