Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 8 of 8 for “"316SS"”.
-
Radiation Response, Mechanical Property Changes, and Corrosion Behavior of Molten Salt Reactor Materials
… for molten fluoride salt conditions, and 316SS, a widely used austenitic alloy, are among the leading candidates for immediate deployment in MSR systems. Data collected during initial development of Hastelloy N suffered from limitations in available microscopy and spectroscopy techniques, …
-
Prediction of Dislocation Density During Casting of 316 Stainless Steel Based Alloys as a Function of Chromium and Nickel Composition
… variations in 316 stainless steels (316SS). 316SS is well-characterized experimentally and is important economically. Slight deviations in both Ni and Cr contents of our samples enabled us to establish their role on the dislocation density. This study included both nominal 316SS …
-
Diffusion Couple Alloying of Refractory Metals in Austenitic and Ferritic/Martensitic Steels
… tantalum, and tungsten to 316 stainless (316SS) and alloy HT9 steels. Refractory elements have been previously studied as alloying candidates to mitigate problems such as radiation-induced segregation, void swelling, and irradiation creep in reactor steels. Diffusion couples were …
-
Understanding the mechanisms controlling stress corrosion cracking through high-resolution characterization
… dependence of crack growth rate (CGR) in 316SS and Alloy 600 in the temperature range of 320-360ºC. It was found that the two proposed mechanisms seem to have different weights on each alloy at “low” and “high” temperatures.</p> <p>The third objective was to explain the effect of Ni …
-
THERMAL PROBE SCANNING OF LASER-POWDER BED FUSION ADDITIVE MANUFACTURING 316 STAINLESS STEEL
… to observe changes in thermal signatures on 316SS parts printed by L-PBF AM. By performing a low-power laser scan as a post-melt heat source, the surfaces of printed parts were thermally probed without remelting. A design of experiments (DOE) was performed to investigate parameters for the …
-
Iridium-4'-Phenyl-Terpyridine, Ruthenium-Triphos, and Ruthenium-N-Triphos Complexes as Homogeneous Catalysts for Hydrogenation of Biomass-Derived Substrates in Aqueous Acidic Medium at High Temperature
… of the Fe and Ni was metal leaching from the 316SS reactor body. [Ru(triphos)(CH3CN)3](OTf)2 on the other hand was an effective homogeneous catalyst for the hydrogenation of 2,5-hexanedione and 2,5-DMF at temperatures between 150 and 200 °C. This catalyst became deactivated by formation of the …
-
Surface engineering : advanced materials for aggressive environments
… the highest wear resistance,especially on 316SS-BM, while SiC-reinforced deposition outperformed others on LCS-BM.Both significantly reduced material loss and outperformed HF600 coatings. The formation ofoxide-rich tribo-layers on LCS-BM under high load conditions was key in …
-
Microstructure, mechanical properties and irradiation response of CrMnFeCoNi-(Y) high-entropy alloys
… resistance, over conventional alloys such as 316SS. Irradiation-induced hardening was likely caused by a synergistic effect of defect clusters, RIS, and precipitates. Using TKD, deformation twinning, usually rarely observed in unirradiated CSW, occurred after irradiation, likely due to the …