Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 10 of 10 for “"Accelerated creep"”.

  1. Assessment of alloy 709 accelerated creep properties for use in sodium cooled fast reactors

    … ranging from 550 to 650 °C. Constant load creep, stress dip, and stress relaxation tests were carried out to determine the minimum creep rate exponent and activation volume, as well as the activation energy of creep and stress relaxation. Constant load creep tests were interrupted close to …

    colo-mines Repository record for Assessment of alloy 709 accelerated creep properties for use in sodium cooled fast reactors (opens in a new tab)

  2. The Role of Bonding on the Tensile Creep Behavior of Paper

    The role of bonding in the tensile creep behavior of paper was analyzed. This was accomplished by producing handsheets at a range of different bonding levels through manipulation of relative bonded area and specific bond strength. This was done by varying the level of wet pressing (to change …

    gatech Repository record for The Role of Bonding on the Tensile Creep Behavior of Paper (opens in a new tab)

  3. Flexural Creep Behavior Of Adhesively Bonded Metal And Composite Laminates

    … behavior when subjected to constant load (creep). In this investigation, long-term creep behavior of adhesively bonded aluminum and carbon fiber composite beams under flexural loading was investigated. Three point bending test was selected because of its simplicity and the fact that bending …

    wayne-thes Repository record for Flexural Creep Behavior Of Adhesively Bonded Metal And Composite Laminates (opens in a new tab)

  4. Development of tension and compression creep models for wood using the time-temperature superposition principle

    To date there are no long-term creep models or practical methods to investigate the effect of creep on the safety and serviceability of modem wood structures and structural wood composites. Long-term creep models were developed for wood in tension and compression using the Time-Temperature …

    vt Repository record for Development of tension and compression creep models for wood using the time-temperature superposition principle (opens in a new tab)

  5. Creep behavior of natural fiber reinforced polymer composites

    Creep behavior of natural fiber/polymer composites (NFPCs) was studied in response to the increasing application of this material as structural building products. Factors that influence creep behavior of the composites were investigated by analyzing creep curves of several different NFPC systems, …

    lsu-thes Repository record for Creep behavior of natural fiber reinforced polymer composites (opens in a new tab)

  6. Toward Accelerated Qualification of ATF Claddings: An In-Situ Burst Testing Framework and Insights into Zr Alloy LOCA Behavior

    … insight into deformation mechanisms such as creep and plasticity during LOCA conditions. The framework was initially developed to evaluate accident-tolerant fuel (ATF) claddings, including Cr-coated Zr and FeCrAl alloys. However, testing of historic Zr claddings was conducted to demonstrate …

    utk-theses Repository record for Toward Accelerated Qualification of ATF Claddings: An In-Situ Burst Testing Framework and Insights into Zr Alloy LOCA Behavior (opens in a new tab)

  7. Numerical Modelling of the Time-Dependent Behaviour of Tunnels in Squeezing Ground

    … over time, essentially associated with the creep mechanism. This time-dependent behavior is usually not identified at the feasibility stage of tunnel development. Consequently, leads to high cost in rock reinforcement and support installation as well as time-consuming and unsafe …

    adelaide Repository record for Numerical Modelling of the Time-Dependent Behaviour of Tunnels in Squeezing Ground (opens in a new tab)

  8. Long-term creep modeling of wood using time temperature superposition principle

    Long-term creep and recovery models (master curves) were developed from short-term data using the time temperature superposition principle (TTSP) for kiln-dried southern pine loaded in compression parallel-to-grain and exposed to constant environmental conditions (~70°F, ~9%EMC). Short-term …

    vt Repository record for Long-term creep modeling of wood using time temperature superposition principle (opens in a new tab)

  9. Microstructural evolution and mechanical behavior in nickel based alloys for very high temperature reactor

    … time-dependent (plasticity) to time-independent (creep) deformations. At temperatures from 300 to 700ºC, the yield strength was found to be temperature independent as a result of additional strain hardening provided by dynamic strain aging. However, higher temperatures (>800ºC) activated …

    uiuc Repository record for Microstructural evolution and mechanical behavior in nickel based alloys for very high temperature reactor (opens in a new tab)

  10. Predicting Long-Term Creep Behavior Using Short-Term Stress Relaxation Data in Expanded Polyethylene Foam

    … leading to time-dependent deformation (creep). Creep reduces cushioning performance, making its understanding critical for effective protective packaging. Two standards, ASTM D3575 and ASTM D2221, define methods for conducting compressive creep tests on foam materials, with test …

    clemson Repository record for Predicting Long-Term Creep Behavior Using Short-Term Stress Relaxation Data in Expanded Polyethylene Foam (opens in a new tab)