Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 11 of 11 for “"Annular Combustor"”.
-
Heat Transfer and Flow Characteristic Study in a Low Emission Annular Combustor
Modern Dry Low Emissions (DLE) combustors are characterized by highly swirling and expanding flows that makes the convective heat load on the combustor liner gas side difficult to predict and estimate. A coupled experimental-numerical study of swirling flow and its effects on combustor liner heat …
-
Simulation of full-scale combustion instabilities in small-scale rigs using actively controlled boundary conditions
… to but smaller than the full-scale engines combustors. While testing with these small-scale setups reduced the cost of testing and produced important results, the acoustic modes excited in the small-scale setups had considerably higher frequencies that did not simulate the lower frequency …
-
Heat Transfer and Flow Measurements in Gas Turbine Engine Can and Annular Combustors
… radial swirler performance in a gas turbine can combustor was conducted by investigating the correlation between combustor flow field geometry and convective heat transfer at cold flow conditions for Reynolds numbers of 50,000 and 80,000. Flow velocities were measured using Particle Image …
-
Finite element analysis of acoustic wave transverse to longitudinal coupling during transverse combustion instability
… instability is a major issue facing lean combustor design in modern gas turbine applications. In this study, we analyze the complex acoustic field excited by a transverse acoustic mode in an annular combustor. This work is motivated by the need to understand the various velocity …
-
3D Numerical Simulation to Determine Liner Wall Heat Transfer and Flow through a Radial Swirler of an Annular Turbine Combustor
… heat transfer characteristics of a gas turbine annular combustor with radial swirlers, over a Reynolds number range from 50,000 to 840,000. A three dimensional hybrid mesh of around twenty five million cells is created for a periodic section of an annular combustor with a single radial swirler. …
-
Investigation of an Innovative Injector for Rotating Detonation Rocket Engines
… of the gases prior to their injection into the annular combustor of a rotating detonation rocket engine. The slot sizes can be made small enough to prevent detonation waves from propagating upstream and inhibit other types of flashback. The configuration investigated is readily fabricated and …
-
Radial Injector Mixing Effects on Detonation Zone Position in Rotating Detonation Engine
Radial propellant injection in the annular combustion chamber of a rotating detonation engine (RDE), done in a manner to promote maximum size scale of vortices, has proven to be effective for gaseous propellants. Experiments with an RDE having a 154-mm-diameter annular combustion chamber have …
-
Fundamental Study of Detonation Structure in Rotating Detonation Engine
… of Brayton-cycle engines has led to a plateau in combustor performance where improvements between successive generations are slight. Detonation-based heat addition, in place of deflagrations, may offer an opportunity to radically improve the performance of both air-breathing and rocket systems. …
-
Dynamics of premixed flames in non-axisymmetric disturbance fields
… are prevalent. During this process the combustor acoustics and combustion heat release fluctuations are coupled and can cause severe structural damage to engine components, reduced operability, and inefficiency that eventually increase emissions. In order to develop an engine without …
-
A conceptual methodology for the prediction of engine emissions
… are complexity of the phenomena involved in the combustor and relatively low priority of having a more detailed emissions model at the conceptual design phase. However, global environmental concerns and aviation industry growth highlight the importance of improving the current emissions …
-
Influence of Fuel Inhomogeneity and Stratification Length Scales on Detonation Wave Propagation in a Rotating Detonation Combustor (RDC)
… over the traditional constant pressure combustor. These detonation-based engines are also known as Pressure Gain Combustion systems (PGC) and Rotating Detonation Combustor (RDC) is a form of PGC, in which the detonation wave propagates azimuthally around an annular combustor. Prior …