Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 84 for “"Anodic dissolution"”.

  1. The anodic dissolution of cadmium in aqueous solutions

    … was to study the effect of cadmium ions on the anodic dissolution of cadmium in salt solutions of ·constant ionic strength. The concentration of the cadmium ions was varied from 0.001 to 1 N and the current density ranged from 0.001 to 0.1 amp•cm-2. The temperature was controlled at 25°C. ....A …

    must-thes Repository record for The anodic dissolution of cadmium in aqueous solutions (opens in a new tab)

  2. Anodic dissolution and electropolishing of copper in phosphoric acid

    … phenomena associated with the electrochemical dissolution of Cu in phosphoric acid. The investigation employs not only standard electrochemical methods, but also the purely physical methods of microscopy and schlieren analysis.

    uiuc Repository record for Anodic dissolution and electropolishing of copper in phosphoric acid (opens in a new tab)

  3. Anodic dissolution of zinc in potassium iodide-potassium iodate solutions

    "The anodic dissolution of Zn was studied in KI-KIO₃ solutions at 25ºC. In I⁻ solutions, it was found that the apparent valence of Zn ions going into solution is approximately two. Smaller values are obtained in IO₃⁻ solutions, with the most pronounced changes occurring in the higher …

    must-thes Repository record for Anodic dissolution of zinc in potassium iodide-potassium iodate solutions (opens in a new tab)

  4. Anodic dissolution of uranium dioxide in simple electrolyte solutions and simulated groundwaters

    The anodic dissolution of UO$\sb2$ has been studied in NaClO$\sb4$ NaCl, Standard Canadian Shield Saline Solution (SCSSS) and SCSSS + HCO$\sb3\sp-$ solutions using potentiostatic and cyclic voltammetry techniques. Under potentiostatic conditions two oxidation/dissolution regions were observed. Over …

    manitoba Repository record for Anodic dissolution of uranium dioxide in simple electrolyte solutions and simulated groundwaters (opens in a new tab)

  5. In situ stress measurements during anodic dissolution of cold spray AA6061 coating

    … induced residual stresses in the film through dissolution of tensile stress loaded region. While anodic dissolution at +0.3V above OCP in salt solution leads to formation of large pits and development of tensile stresses. The microstructure analysis of the corroded surfaces show pits with small …

    iastate Repository record for In situ stress measurements during anodic dissolution of cold spray AA6061 coating (opens in a new tab)

  6. The anodic dissolution of nickel in acid sulphate solutions containing organic sulphur compounds

    … solution, c) conditions of polarization on the anodic dissolution and passivation of Ni has been studied using potentiostatic, potentiodynamic and galvanostatic techniques. In particular the effect of pH and additions of sulphur compounds (sodium sulphide, thiourea, thioacetamide, …

    london-metro

  7. Fundamental Investigation of Magnesium Corrosion Using Experiments and Simulation

    … enhanced hydrogen evolution reaction (HER) with anodic polarization, the modeling of galvanic corrosion and the impact of hydrogen bubbles for galvanically coupled Mg are important aspects of Mg corrosion that need to be understood before any mitigation measures can be taken. The results …

    byu Repository record for Fundamental Investigation of Magnesium Corrosion Using Experiments and Simulation (opens in a new tab) Download PDF for Fundamental Investigation of Magnesium Corrosion Using Experiments and Simulation (opens in a new tab)

  8. Fundamental studies of the anodic behavior of thiourea in copper electrorefining

    The behavior of thiourea in the anodic process of copper electrorefining was investigated using various advanced electrochemical techniques with a view to establishing an accurate method to determine its effect on the anode process in certain highly concentrated copper sulfatesulfuric acid …

    ubc Repository record for Fundamental studies of the anodic behavior of thiourea in copper electrorefining (opens in a new tab) Download PDF for Fundamental studies of the anodic behavior of thiourea in copper electrorefining (opens in a new tab)

  9. Studies of Circumferential Stress Corrosion Cracking of Pipelines

    … behavior of the steels were investigated. The anodic dissolution at the crack tip was enhanced by stress, contributing to the crack propagation. The increase of corrosion rate was associated with the porous corrosion product. The mechanism of SCC was found to be stress dependent. The SCC …

    calgary Repository record for Studies of Circumferential Stress Corrosion Cracking of Pipelines (opens in a new tab)

  10. Anodic Metal Dissolution In Haloaluminate Molten Salts/Ionic Liquids

    … a mass transport-limited process governed by the dissolution of a passive layer of alcl3(s) and/or albr3(s) on the electrode surface. In alcl3-etmeimcl, the passive current density scales linearly with the concentration of alcl4- in the ionic liquid. The heterogeneous rate constant, referenced to …

    mississippi Repository record for Anodic Metal Dissolution In Haloaluminate Molten Salts/Ionic Liquids (opens in a new tab)

  11. The role of galvanic coupling effect in determining crevice corrosion morphology

    … the anode and cathode. It is found that when the anodic environmental aggressiveness exceeds certain value, the whole process is shifted from anode control to cathodic control and, therefore, the anodic dissolution rate is significantly enhanced. What complicates the process is the inevitably …

    mcmaster Repository record for The role of galvanic coupling effect in determining crevice corrosion morphology (opens in a new tab)

  12. The anodic behavior of zinc in aqueous salt solutions

    … in recent years. The basic mechanism of the anodic dissolution of metals such as zinc, cadmium, and magnesium in salt solution is not completely known. Many mechanisms have been proposed by different investigators but evidence is still lacking which would allow one to draw reliable …

    must-thes Repository record for The anodic behavior of zinc in aqueous salt solutions (opens in a new tab)

  13. Stress corrosion cracking of copper-base alloys

    … the aluminium bronze/ammonia system include; the anodic dissolution, the film rupture and the embrittlement theories, which are described in the literature review. The copper aluminium alloy system was selected for investigation as it exhibits a martensite transformation, making the cracking of …

    unsw Repository record for Stress corrosion cracking of copper-base alloys (opens in a new tab)

  14. Nuclear magnetic resonance and electrochemical studies of boron hydride derivatives

    … gave rise to B??H?? and B?H??[CH?CN]. Anodic dissolution of Cu in acetonitrile solution of [B??H??(PPh?)]? yielded a product which showed a weak interaction between Cu(I) and the BH? group at the B(9) position of the starting anion. Similar dissoIution of Cu in a solution of …

    strathclyde Repository record for Nuclear magnetic resonance and electrochemical studies of boron hydride derivatives (opens in a new tab)

  15. Chemical and electrochemical studies of Borane Anions and Metallaboranes

    … of some of these anions have been prepared by anodic dissolution of a suitable metal in a solution of the anion. The structures and dynamics of substituted derivatives of the [B?H??]? ion have been studied. The anions [B?H??(X)?(X = CINCSe, NCBPh?, NCBH?NCBH?, NCBH?CN, NCBH?CNB?H??, CN, and …

    strathclyde Repository record for Chemical and electrochemical studies of Borane Anions and Metallaboranes (opens in a new tab)

  16. Molybdenum Deposition and Dissolution in Ethaline with the Use of Fluoride Salts

    … of the newly introduced fluoride ion on the anodic dissolution of molybdenum in ethaline, linear sweep voltammetry was used. In addition, a chloride-free electrolyte composed of 1M KF in ethylene glycol was used to anodically dissolve Mo at a faradaic efficiency of 63%. The ability of Mo to …

    byu Repository record for Molybdenum Deposition and Dissolution in Ethaline with the Use of Fluoride Salts (opens in a new tab) Download PDF for Molybdenum Deposition and Dissolution in Ethaline with the Use of Fluoride Salts (opens in a new tab)

  17. In-situ stress monitoring during corrosion and electrodeposition

    … alloy, AA2024-T3 is vulnerable to IGC with the dissolution of S phase, Al2CuMg particles that precipitate along the grain boundaries. Similarly, Al-Mg alloy, AA5083 is susceptible to IGC with the precipitation of β phase, Mg2Al3 particles along the grain boundaries of the alloy when exposed to …

    iastate Repository record for In-situ stress monitoring during corrosion and electrodeposition (opens in a new tab)

  18. Effect of H2 Pressure on Hydrogen Absorption and Granular Iron Corrosion Rates

    … may occur by processes such as hydrogen enhanced anodic dissolution, hydrogen induced cracking, enhanced pitting susceptibility and reduction of iron oxides by hydrogen gas. In this study, the effect of hydrogen on iron corrosion rates was assessed by treating two iron materials (H2Omet56 and …

    waterloo Repository record for Effect of H2 Pressure on Hydrogen Absorption and Granular Iron Corrosion Rates (opens in a new tab)

Page 1 of 5