Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 50 for “"Back-flow"”.

  1. Molecular back flow from the exhaust plume of a space-based laser

    Back flow from the exhaust of a chemical laser in low earth orbit may be detrimental to the integrity and operation of the self same system. Difficulties arise in the calculation of exhaust plume properties and molecular flux as the gas expands from continuum to free-molecular flow. The solution of …

    nps Repository record for Molecular back flow from the exhaust plume of a space-based laser (opens in a new tab)

  2. Suction recirculation mitigation in a double-suction centrifugal pump

    … can be described as the separation of the flow field and the presence of a separation cell in the suction half of the impeller between-vane cavity with a back-flow of fluid from impeller to suction volute. Two scenarios were investigated: the unmodified pump, and the modified pump geometry …

    nwu-za Repository record for Suction recirculation mitigation in a double-suction centrifugal pump (opens in a new tab)

  3. Interdendritic fluid flow

    … investigation of interdendritic liquid flow was carried out on pre-cast Pb-20Sn ingots at temperatures where the casting was partially liquid. The liquid flow was found to be preferential in nature, and strongly dependent on surface tension effects. Castings of Cu-8Ag and Al-30Ag were …

    ubc Repository record for Interdendritic fluid flow (opens in a new tab) Download PDF for Interdendritic fluid flow (opens in a new tab)

  4. Pressure screening studies with wood pulp

    … uses a single one row of tanks to model steady flow from feed to accept and from feed to reject streams of a screen. A back-flow model, which had two rows of well-mixed tanks, one for the feedside and another for the accept-side of the screen, was also developed. The passage ratio for back-flow …

    waikato-masters Repository record for Pressure screening studies with wood pulp (opens in a new tab) Download file for Pressure screening studies with wood pulp (opens in a new tab)

  5. Modeling and Design of an Integral Squeeze Film Damper for Rotor Vibration Amplitude Reduction

    … were adjusted for machine tolerance and put back into a rotor model which results in a reduced vibration peak and critical speed. This damper was then manufactured and assembled onto a test rig. A parametric model of the end seal clearance and orifice diameter showed the safe operating …

    tamu Repository record for Modeling and Design of an Integral Squeeze Film Damper for Rotor Vibration Amplitude Reduction (opens in a new tab) Embargoed until 2026-12-01

  6. DESIGN & DEVELOPMENT OF HETEROTOPIC TRANSCATHETER TRICUSPID VALVES TO AMELIORATE TRICUSPID REGURGITATION

    … superior and inferior vena cava will prevent the back flow of blood into the venous structures and minimises the detrimental effect of reverse flow. The hemodynamic characteristics of these valves were tested in a mock circulatory system (MCS) which emulated the patho-physiological pressure and …

    nus Repository record for DESIGN & DEVELOPMENT OF HETEROTOPIC TRANSCATHETER TRICUSPID VALVES TO AMELIORATE TRICUSPID REGURGITATION (opens in a new tab) Download file for DESIGN & DEVELOPMENT OF HETEROTOPIC TRANSCATHETER TRICUSPID VALVES TO AMELIORATE TRICUSPID REGURGITATION (opens in a new tab)

  7. Design, Fabrication, and Implementation of a Single-Cell Capture Chamber for a Microfluidic Impedance Sensor

    … be designed to capture a single cell and permit back-flow to flush out excess cells in the chamber. The device will be designed to use syringe pumps and the syringe-controlled channel will also be used to capture and release the cell to ensure cell control and device reusability. We hypothesize …

    calpoly Repository record for Design, Fabrication, and Implementation of a Single-Cell Capture Chamber for a Microfluidic Impedance Sensor (opens in a new tab)

  8. Gas-solid transport and reaction via intervened evaporating sprays

    … based models which cost too much on emphasizing flow dynamics yet not suitable for real time on-site monitor/control/optimization in industry. This work shows the efforts in developing an FCC model that strikes a right balance between the kinetics- and CFD-dominated approaches. Specifically, the …

    njit Repository record for Gas-solid transport and reaction via intervened evaporating sprays (opens in a new tab)

  9. Thermal non-Newtonian elastohydrodynamic lubrication of line contacts under sliding-rolling and simple sliding conditions

    … roller bearings and cams. The inlet region with back-flow is treated with a control volume scheme to obtain the temperature solution. A computationally-simple formulation for the stationary surface temperature is developed for simple sliding conditions. The most influential dimensionless groups …

    uiuc Repository record for Thermal non-Newtonian elastohydrodynamic lubrication of line contacts under sliding-rolling and simple sliding conditions (opens in a new tab)

  10. Biokinetic Modeling and Dosimetry of Radiopharmaceutical Extravasation in Lu-177-PSMA Therapy for Metastatic Castration-Resistant Prostate Cancer

    … by log‑normal sampling of the extravasation and back‑flow rate constants using a coefficient of variation (CV) of 50%. Across 1,000 simulated patients, the median dose to the extravasation site was 2.65 mGy. These results further support the conclusion that, under standard clinical conditions, …

    gatech Repository record for Biokinetic Modeling and Dosimetry of Radiopharmaceutical Extravasation in Lu-177-PSMA Therapy for Metastatic Castration-Resistant Prostate Cancer (opens in a new tab)

  11. Nonlinear imaging assisted ultrafast laser microsurgery for the treatment of vocal fold scarring

    … hamster cheek pouch samples. We observed a back-flow of the injected biomaterial along the point of injection and this condition prevented localization of the biomaterial at the desired locations without creating any void. In contrast to the biomaterial injection outcomes without any voids, …

    texas Repository record for Nonlinear imaging assisted ultrafast laser microsurgery for the treatment of vocal fold scarring (opens in a new tab)

  12. Thin-film flows on cylinders

    Three different problems concerning thin- film flows on horizontal cylinders are studied. Firstly, steady two-dimensional gravity-driven flow with prescribed volume flux of a thin lm of Newtonian fluid with temperature-dependent viscosity (i.e. thermoviscous flow) over a uniformly heated or cooled …

    strathclyde Repository record for Thin-film flows on cylinders (opens in a new tab)

  13. DESIGN, FABRICATION, AND TESTING OF A PDMS MICROPUMP WITH MOVING MEMBRANES

    … of fluid velocity, pressure distributions, and flow rate during the operating cycle of the micropump. The design simulation results showed that the movement of the wall membranes combined with rectification behavior of three nozzle/diffuser elements can minimize back flow and improve net flow in …

    vcu Repository record for DESIGN, FABRICATION, AND TESTING OF A PDMS MICROPUMP WITH MOVING MEMBRANES (opens in a new tab)

  14. In vitro comparative hydrodynamic study of heart valve bioprostheses under accelerated fatigue conditions and under physiological conditions

    … them.</p><p>Pressure drop and pulsatile flow across valves are measured, using a real-time on-line data acquisition system, which includes, in addition to the fatigue tester and the pulse duplicator, a DC amplifier, an analog-to-digital converter and a digital microcomputer. Special …

    njit Repository record for In vitro comparative hydrodynamic study of heart valve bioprostheses under accelerated fatigue conditions and under physiological conditions (opens in a new tab)

  15. The structure of the central recirculation zone in enclosed swirling flow.

    Swirling flows are widely used in fuel burners and combustors to provide a central recirculation zone which intensifies mixing and stabilizes the flame. In general, in a flow with sufficiently high swirl entering through a sudden expansion, the change of the tangential velocity produces an axial …

    ottawa-retro Repository record for The structure of the central recirculation zone in enclosed swirling flow. (opens in a new tab)

  16. The potential of flexible micro pillars to investigate near wall flow

    … flexible micro pillars for measuring near wall flow phenom- ena was theoretically and experimentally investigated. The bending of the micro pillars is a measure for the local wall shear stress (WSS) or a visualisa- tion of near wall flow phenomena. Polydimethylsiloxane (PDMS) was chosen as …

    qucosa-diss

  17. Structure of 2-D and 3-D Turbulent Boundary Layers with Sparsely Distributed Roughness Elements

    … distribution, thus studying the response of the flow to a sequence of perturbations; and in Part 3, the distributions were subjected to 3-D turbulent boundary layers, thus examining the effects of streamwise and spanwise pressure gradients on the same perturbed flows as considered in Part 2. The …

    vt Repository record for Structure of 2-D and 3-D Turbulent Boundary Layers with Sparsely Distributed Roughness Elements (opens in a new tab)

  18. Inverse segregation and centreline shrinkage

    … castings is the extent of interdendritic fluid flow which occurs during solidification. Interdendritic flow results from movement of liquid to fill the voids left by solidification and thermal shrinkage, which in the case of many alloys cast against a cold chill, results in inverse segregation. …

    ubc Repository record for Inverse segregation and centreline shrinkage (opens in a new tab) Download PDF for Inverse segregation and centreline shrinkage (opens in a new tab)

  19. Mesoscopic lattice Boltzmann nemato-dynamics.

    … as. well as investigations into nematic flow in interesting geometries. The model is based upon two coupled LBE schemes, the standard momentum density distribution and a new link angle distribution. To achieve evolution, the link angle distribution undergoes a Bhatnagar-Gross-Krook (BGK) …

    sheffield-hallam Download PDF for Mesoscopic lattice Boltzmann nemato-dynamics. (opens in a new tab)

  20. An Experimental Study of Temperature Separation in Swirling Flow

    … internal surveys of a Ranque-Hilsch swirling flow test rig at the condition when the vortex whistle was attenuated or excited. This control of the vortex whistle was accomplished by two methods.</p> <p>In the first method where the vortex whistle was attenuated by placing a restriction at the …

    utk-theses Repository record for An Experimental Study of Temperature Separation in Swirling Flow (opens in a new tab)

Page 1 of 3