Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 21 for “"Bridges--Live loads"”.
-
A simulation study of fatigue life of highway bridges
Thesis (Ph. D.)--Michiagn State University. Department of Civil Engineering, 1971
-
Computation of bridge strains: a comparison of the methods of wheel weights, and of uniform loads and engine excess
Made available in DSpace on 2016-11-09T23:47:59Z (GMT). No. of bitstreams: 2 5939463_opt.pdf: 13180326 bytes, checksum: 4b8e924317105777b83ca7ad79861ab6 (MD5) license.txt: 4183 bytes, checksum: 1dcc2037833d76bede73d5717587543b (MD5) Previous issue date: 1880
-
Ultimate strength of arch structures under two- and three- dimensional loading
Thesis (Ph. D.)--Michigan State University. Department of Civil and Environmental Engineering, 1992
-
Load capacity assessment of multispan bridges based on curvature influence lines
Includes bibliographical references (pages 76-77).
-
Dynamic effect of traffic loading on highway bridges
Thesis (M.S.)--Michigan State University. Department of Civil and Environmental Engineering, 1997
-
Development and verification of a novel technique for rapid military bridge load classification of transversely indeterminate bridges, The
Includes bibliographical references (pages 143-144).
-
Vibration of discretely stiffened skew plates and bridge/vehicle interaction analysis.
The vibration of orthogonally stiffened skew plates is studied by using the pb-2 Rayleigh-Ritz method. By minimizing the Rayleigh quotient, the natural frequencies and mode shapes are obtained. The dimensionless natural frequencies of orthogonally stiffened skew plates with different boundary …
-
Dynamic behavior of bridge structures under moving loads and masses using differential quadrature method
… structure subjected to moving heavy vehicular loads using simplified representative models such as Euler beams and Kirchhoff plates. The study also successfully implemented the application of a numerical procedure called Differential Quadrature Method (DQM) to solve transient dynamic systems …
-
Dynamic behavior of bridge structures under moving loads and masses using differential quadrature method
… structure subjected to moving heavy vehicular loads using simplified representative models such as Euler beams and Kirchhoff plates. The study also successfully implemented the application of a numerical procedure called Differential Quadrature Method (DQM) to solve transient dynamic systems …
-
A Bayesian Network-Based Methodology for Improved Bridge Load Rating and Asset Management
… of individual components and the external loads applied to those components, then an important piece of information becomes available. Through the BN, an asset manager can have an estimate of the component Probability of Failure (Pƒ). These component values for Pƒ can be compared directly, …
-
Response of orthotropic bridge decks to highway loadings
… The response of the deck to AASHO vehicle axle loads was compared with a discrete element computer program used to analyze orthotropic bridge decks continuous over flexible supports. Results indicate good correlation between measured and computed values for deflection and strains.
-
Comparative study of LRFR and LFR methods of rating for Missouri concrete bridges
… a bridge's capacity to safely handle traffic loads. The process is fundamental for both new and existing bridges, establishing weight restrictions on vehicles to prevent structural damage and potential failure of the bridge. Communicating these rated bridge loads to road users is achieved …
-
Comparative Study of LRFR and LFR Methods of Rating for Missouri Steel Bridges
… is a method used to check on the ability of bridges to carry a given live load. Bridge rating is important to ensuring public safety in that it helps the concerned agencies to enforce weight restriction on heavy vehicles to safeguard the structures from failure. Before the bridge is rated, …
-
Determination of probabilistic models for resistance of Missouri bridges
… project sponsored by MoDOT to calibrate the live load factor considering the typical bridge configurations in Missouri and state-specific traffic environment for the Strength I Limit State in AASHTO LRFD Bridge Design Specification, this thesis determines the distribution of resistance using …
-
Comparative Study of LRFR and LFR Methods of Rating for Missouri Prestressed Bridges
… bridge's capacity to safely accommodate traffic loads. For public safety, it is a crucial process for both new and existing bridges by establishing the weight restriction on heavy vehicles crossing the bridges to prevent structure damage and potential failure of the bridges. Rated bridge loads …
-
Experimental studies on shear connection systems in steel and lightweight concrete composite bridges
… There are some good examples of buildings and bridges where high strength lightweight concrete is used as the main material. The principal reason for using lightweight concrete is the advantage of reducing the concrete element self-weight. This weight saving permits larger spans or lower weight …
-
Nonlinear earthquake analysis of wall pier bridges
… have been developed are generally applicable to bridges whose substructures can be idealized as beam-columns. Bridges with wall piers do not belong to this category The major objective of this study is to develop an analysis tool capable of simulating the effects of earthquakes on monolithic …
-
Modern racism and affirmative action attitudes
… bridge joints under controlled representative loads. This type of model has recently been constructed by the Department of civil and Environmental Engineering at the University of Central Florida under the sponsorship of Florida Department of Transportation. The model is a 50 foot diameter …
-
The Design of a Full-scale Apparatus for Testing of Bridge Expansion Joints
… bridge joints under controlled representative loads. This type of model has recently been constructed by the Department of Civil and Environmental Engineering at the University of Central Florida under the sponsorship of Florida Department of Transportation. The model is a 50 foot diameter …
Page 1 of 2