Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 47 for “"CANDU Reactor"”.

  1. Power Transient in a CANDU Reactor

    … effectiveness of a proposed Shutoff Rod System a CANDU Reactor was investigated. A full core simulation was done, to study the neutronic power transient following a change in coolant conditions.

    mcmaster Repository record for Power Transient in a CANDU Reactor (opens in a new tab)

  2. Xenon Transient Studies for a CANDU Reactor

    … studies the xenon transient behaviour in a CANDU reactor as a function of time after shutdown, start-up and power setbacks. In addition, load cycling transients were obtained for typical daily load requirements. </p>

    mcmaster Repository record for Xenon Transient Studies for a CANDU Reactor (opens in a new tab)

  3. Optimization of Shutoff Rods in a CANDU Reactor

    <p> In CANDU reactors, mechanical devices called shutoff rods are used to shutdown the reactor if required. These rods are made of high thermal neutron absorbing material such as cadmium. The number and the locations of the shutoff rods are optimized for a given reactor configuration. Optimization …

    mcmaster Repository record for Optimization of Shutoff Rods in a CANDU Reactor (opens in a new tab)

  4. Simulation of in-core dose rates for an offline CANDU reactor

    … system for the pressure tubes of an offline CANDU reactor. Simulations were performed using the Monte Carlo N-Particle (MCNP) radiation transport code, version 6.1. The radiation fields within the reactor, even when shut down, are very high, and can cause significant damage to certain …

    uoit Repository record for Simulation of in-core dose rates for an offline CANDU reactor (opens in a new tab)

  5. Proliferation resistance evaluation of CANDU reactor systems with different fuel cycles

    … of exploring the thorium fuel application in CANDU reactors, it is important to consider the proliferation resistance level as a parameter for comparison with current natural uranium fuel. The concept of a whole fuel cycle was introduced to show the variations in the proliferation resistance …

    mcmaster Repository record for Proliferation resistance evaluation of CANDU reactor systems with different fuel cycles (opens in a new tab)

  6. The feasibility of using supercritical carbon dioxide as a coolant for the CANDU reactor

    … supercritical carbon dioxide as a coolant for a CANDU-type reactor. A new concept of supercritical cooling loop is proposed in this study. The reactor is cooled by a single phase coolant, which is pumped at a high density liquid-like state. The supercritical-fluid-cooled reactor has the advantage …

    ubc Repository record for The feasibility of using supercritical carbon dioxide as a coolant for the CANDU reactor (opens in a new tab) Download PDF for The feasibility of using supercritical carbon dioxide as a coolant for the CANDU reactor (opens in a new tab)

  7. Adjuster Rod Design in a CANDU Reactor and Flux Distributions Due to an Arbitrary Source of Neutrons

    This report consists of two separate studies. The first part deals with the calculation of the tube thickness of the Bruce B adjuster rods. The incremental cross-section for four tube thicknesses were obtained using the SUPERCELL Method. The tube thicknesses were then calculated so that the flux …

    mcmaster Repository record for Adjuster Rod Design in a CANDU Reactor and Flux Distributions Due to an Arbitrary Source of Neutrons (opens in a new tab)

  8. Closing the Fuel Cycle with a CANDU Reactor: A Feasibility Study of Recycling Used Fuel by Reprocessing and Re-Enriching to Determine the Impact on Nuclear Proliferation Resistance

    … discharged from a Canadian Deuterium Uranium (CANDU) reactor with regards to the accumulation of 236U and 238Pu was conducted. Reduction in the spent fuel waste on reactor sites and at interim storage facilities can be achieved based on the analysis carried out on the recycling of used fuel …

    tamu Repository record for Closing the Fuel Cycle with a CANDU Reactor: A Feasibility Study of Recycling Used Fuel by Reprocessing and Re-Enriching to Determine the Impact on Nuclear Proliferation Resistance (opens in a new tab)

  9. An Experimental Investigation of Critical Heat Flux on a Vertical Surface Abutting a Coarse Porous Medium

    A postulated severe accident in a CANDU reactor may involve the collapse of core materials to the bottom of the calandria vessel. Avoidance of further degradation of the reactor state would require retention of these materials within the vessel. Successful retention depends upon transport of …

    mcmaster Repository record for An Experimental Investigation of Critical Heat Flux on a Vertical Surface Abutting a Coarse Porous Medium (opens in a new tab)

  10. A Magnetic Flux Leakage NDE System for CANDU Feeder Pipes

    … (NDE) of residual (elastic) stresses in CANDU reactor feeder pipes. The stress sensitivity of three MFL inspection techniques was examined with flat plate samples, with stress-induced magnetic anisotropy (SMA) demonstrating the greatest stress sensitivity. A prototype SMA testing system …

    queens Repository record for A Magnetic Flux Leakage NDE System for CANDU Feeder Pipes (opens in a new tab)

  11. Effect of non-uniform axial heat-flux distribution on critical heat flux

    … in directly heated tubes at the Freon-equivalent CANDU reactor conditions of interest. CHF measurements were obtained on test sections with four nonuniform AFD profiles as well as a uniform AFD profile using HFC-134a as a test fluid. Each of the non-uniform AFD test sections had a stepped cosine …

    ottawa-retro Repository record for Effect of non-uniform axial heat-flux distribution on critical heat flux (opens in a new tab)

  12. MODCONV: A Computer Code to Predict the Local Velocities and Temperatures Inside a Moderator

    … distribution in the moderator of a typical CANDU reactor under normal and shut down operations, as well as postulated LOCA for which the rupture in the system is external to the core. Appropriate velocities are imposed at the boundary walls so that the free convection equations set can be …

    mcmaster Repository record for MODCONV: A Computer Code to Predict the Local Velocities and Temperatures Inside a Moderator (opens in a new tab)

  13. Heat transfer in rod bundle subchannels.

    … of heat transfer in a model of the 37-rod CANDU reactor bundle. Localized heat was provided by a narrow heated strip mounted on the central rod, which could be traversed within the duct and rotated about its axis. The relative variation of the "apparent" local heat transfer coefficient …

    ottawa-retro Repository record for Heat transfer in rod bundle subchannels. (opens in a new tab)

  14. The Optimal Placement of Shutoff Rods in CANDU Nuclear Reactors (Part A)

    … optimal placement of shutdown systems in power reactors is investigated, in particular, the placement of mechanical and liquid shutoff rods. Two CANDU reactor cores were used as a basis for evaluation. The optimal shutdown system was defined here to be one which, with the least number of rods, …

    mcmaster Repository record for The Optimal Placement of Shutoff Rods in CANDU Nuclear Reactors (Part A) (opens in a new tab)

  15. Design and enhancements for a CANDU robotic fuel channel inspection system

    … for use inside Canadian Deuterium Uranium (CANDU) reactor fuel channels. A dual cable management system was developed to hold the necessary cables for the robotic crawler to operate and provide additional odometry data. A deployment scheme for the robotic inspection system integrated into …

    uoit Repository record for Design and enhancements for a CANDU robotic fuel channel inspection system (opens in a new tab)

  16. A Mechanistic Model to Predict Fuel Channel Failure in the Event of Pressure Tube Overheating

    Under normal operating conditions a CANDU reactor pressure tube (PT) is insulated from its outer calandria tube (CT) by a CO2 gas annulus. If the primary loop coolant flow is compromised the PT can overheat and, if still pressurized, balloon into contact with the CT. At this point the moderator …

    mcmaster Repository record for A Mechanistic Model to Predict Fuel Channel Failure in the Event of Pressure Tube Overheating (opens in a new tab)

  17. A Computational Fluid Dynamics based model that predicts wall shear stress in CANDU outlet feeder pipes

    Wall thinning of carbon steel in CANDU reactor outlet feeder pipes due to Flow Accelerated Corrosion (FAC) is identified as one of the challenges for CANDU reactors since it would force them to shut down due to safety reasons. Several models have been developed over time to predict the corrosion …

    uoit Repository record for A Computational Fluid Dynamics based model that predicts wall shear stress in CANDU outlet feeder pipes (opens in a new tab)

  18. A Barkhausen Noise Testing System for CANDU Feeder Pipes

    … evaluation (NDE) of residual stresses in CANDU reactor feeder pipes. The system consists of a four-channel arbitrary waveform flux control system (FCS), and the spring-loaded tetrapole prototype (SL4P) BN probe. The combination of the FCS and SL4P was shown to provide repeatable BN …

    queens Repository record for A Barkhausen Noise Testing System for CANDU Feeder Pipes (opens in a new tab)

Page 1 of 3