Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 11 of 11 for “"Combustor model"”.
-
Heat Transfer and Flow Measurements on a One-Scale Gas Turbine Can Combustor Model
… cooling as the solution for modern DLE combustors. The idea is to provide more cooling to the deserved local hot spots and reserve unnecessary coolant air from local cold spots. Therefore, if accurate heat load distribution on the liners can be obtained, then an intelligent cooling …
-
Development and demonstration of a diode laser sensor for a scramjet combustor
… tests using a free-piston shock tunnel and a combustor model. These facilities provide a convenient location for fundamental studies and principles learned during ground tests can be applied to the design of a full-scale vehicle.¶ A wide range of diagnostics have been used for studying …
-
Heat Transfer and Flow Characteristic Study in a Low Emission Annular Combustor
Modern Dry Low Emissions (DLE) combustors are characterized by highly swirling and expanding flows that makes the convective heat load on the combustor liner gas side difficult to predict and estimate. A coupled experimental-numerical study of swirling flow and its effects on combustor liner heat …
-
The characterization of the flowfield of a dump combustor
… flowfield, a water-cooled, stainless steel dump combustor model was developed. A two-component Laser Doppler Anemometer (LOA) was used to measure the mean and turbulent velocities in the axial and tangential directions and provide a comparison between combusting and isothermal flows. However, …
-
Modeling the integration of thermoelectrics in anode exhaust combustors for waste heat recovery in fuel cell systems
… waste heat recovery in anode exhaust combustors to improve the fuel cell system efficiencies by as much as 4-5% points and further to reduce required battery power during system start-up. Two models were used to explore this. The first model simulated an integrated SOFC system with a …
-
An investigation of swirling flow mixing for application in an MHD pulverized coal combustor using isothermal modeling
<p>The purpose of this study was to investigate combustor reactant mixing with swirling oxidizer flow. The combustor configuration that was considered was designed to simulate a 4 lbm/sec mass flow pulverized coal combustor being tested in The University of Tennessee Space Institute MHD Facility. A …
-
Reduced-order model for prediction of staged-combustor NOx emissions with detailed chemistry and finite-rate mixing
… which can be achieved primarily through higher combustor firing temperatures. Because conventional combustors fail to meet NOx regulations at such temperatures, there is a pressing need for high-temperature, low-emissions combustors. In this regard, the staged combustion architecture is one such …
-
Optimization of Hypersonic Airbreathing Propulsion Systems through Mixed Analysis Methods
Accurate flow path modeling of scramjet engines is a key step in the development of an airframe integrated engine for hypersonic vehicles. A scramjet system model architecture is proposed and implemented using three different engine components: the isolator, combustor, and nozzle. For each …
-
INVESTIGATION OF SCRAMJET PERFORMANCE DURING COMBUSTION MODE TRANSITION
… quantifies the effects of these transitions on combustor stability and propulsion performance metrics.The mode transition is expected to occur near the start of the hypersonic flight regime. Combustion mode transition experiments were conducted using a laboratory-scale, direct-connect test …
-
FUEL NITROGEN CONVERSION DURING FUEL RICH COMBUSTION OF PULVERIZED COAL AND CHAR
… gases in the first, fuel rich stage of a staged combustor. The experimental apparatus includes a downflow combustor of 15 cm internal diameter and 180 cm length constructed of fibrous alumina insulation surrounding a central tube composed of vacuum- formed alumina cylinders. The combustion gases …
-
A methodology for the prediction of non-volatile particulate matter from aircraft gas turbine engine
… thrust. The prediction environment consists of a Combustor Flow Circuit model, Statistical Distribution Model with the unmixedness curve, Chemical Reactor Networks (CRN), and Soot Evaluation Model. The integrated prediction environment developed with the proposed methodology demonstrates good …