Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 63 for “"Compact Heat Exchanger"”.

  1. The Periodic Technique for Testing Compact Heat Exchanger Surfaces

    The transient technique of testing the heat transfer performance of heat exchanger cores is frequently being used because of certain advantages for highly compact surfaces over the more conventional steady-state technique. There are two methods of employing the transient technique, the single blow …

    marquette Repository record for The Periodic Technique for Testing Compact Heat Exchanger Surfaces (opens in a new tab)

  2. Performance of a liquid flow ultra-compact heat exchanger

    A numerical analysis of the performance of compact pin-fin array heat exchangers was carried out using water and JP-4 fuel as the working fluids. Three different configurations were used with hydraulic diameters ranging from 0.137 to 0.777 mm, and volumetric area densities varying between 4.5 and …

    nps Repository record for Performance of a liquid flow ultra-compact heat exchanger (opens in a new tab)

  3. DEVELOPMENT OF A COMPACT HEAT EXCHANGER WITH BIFURCATED BARE TUBES

    Heat transfer enhancement of air-to-fluid heat exchangers by novel surface or geometry design and optimization is a major research topic. The traditional way of reducing airside thermal resistance is to extend airside heat transfer area by adding fins and the conventional method of reducing fluid …

    maryland Repository record for DEVELOPMENT OF A COMPACT HEAT EXCHANGER WITH BIFURCATED BARE TUBES (opens in a new tab)

  4. Experimental Techniques to Determine Ntu of Compact Heat Exchanger Surfaces

    … when the value of N is less than 5.0. A heater system made of .001 inch diameter nichrome wire was designed and tested to determine its effect on the transient testing of matrix type heat exchangers. Because the design showed no improvement in the test results and was unreliable its use …

    nps Repository record for Experimental Techniques to Determine Ntu of Compact Heat Exchanger Surfaces (opens in a new tab)

  5. Effective material usage in a compact heat exchanger with periodic micro–channels

    … one thing in common: the use of some form of heat exchanger. This heat exchanger is used to pre-heat or cool the primary loop gas, from where the secondary power generation cycle is driven. The Compact Heat Exchanger (CHE) type offers high heat loads in smaller volumes. Various studies have …

    nwu-za Repository record for Effective material usage in a compact heat exchanger with periodic micro–channels (opens in a new tab)

  6. EHD Enhanced Heat Transfer in a Metallic and a Ceramic, Compact Heat Exchanger

    Electrohydrodynamic (EHD) heat transfer enhancement has enormous potential to increase heat transfer rates while minimizing heat exchanger size. The aircraft industry, for one, could benefit using EHD heat transfer enhancement. Engineers can change their design approach and plan for minimal loads, …

    maryland Repository record for EHD Enhanced Heat Transfer in a Metallic and a Ceramic, Compact Heat Exchanger (opens in a new tab)

  7. Material selection and optimisation of a high-temper[at]ure compact heat exchanger

    … employs a large conventional shell-and-tube heat exchanger as recuperator at the inlet to the heat source in order to preheat the nitrogen. The thermal inertia of the current PBMM recuperator influences the dynamic behaviour of the plant and the heat exchanger configuration is also different …

    nwu-za Repository record for Material selection and optimisation of a high-temper[at]ure compact heat exchanger (opens in a new tab)

  8. Numerical and Experimental Study of an Ambient Air Vaporizer Coupled with a Compact Heat Exchanger

    … analysis and experimental testing of a passive heat exchange system that uses ambient vaporizers coupled with compact heat exchangers to provide frost free operation while minimizing pressure drop.

    washington Repository record for Numerical and Experimental Study of an Ambient Air Vaporizer Coupled with a Compact Heat Exchanger (opens in a new tab)

  9. Experimental and Theoretical Investigation of a Multiphase Reaction in a Compact Heat Exchanger-Reactor (HEX Reactor)

    Heat transfer enhancement research has long been concerned with keeping pace to the rapidly increasing cooling demands of high performance electronics. In addition to requiring the removal of higher heat fluxes as device miniaturization continues, the operating temperature limits remain essentially …

    tamu Repository record for Experimental and Theoretical Investigation of a Multiphase Reaction in a Compact Heat Exchanger-Reactor (HEX Reactor) (opens in a new tab)

  10. An Experimental Determination of Heat Transfer and Flow Friction Characteristics of Perforated Material for Compact Heat Exchanger Surfaces

    … testing technique for the determination of heat transfer characteristics of a porous medium has been known since 1929. It requires a good deal of care and one of the important restrictions is a step change in temperature must be applied to the medium at the beginning of a test run. This …

    nps Repository record for An Experimental Determination of Heat Transfer and Flow Friction Characteristics of Perforated Material for Compact Heat Exchanger Surfaces (opens in a new tab)

  11. Experimental determination of heat transfer and flow friction characteristics for several plate fin type compact heat exchanger surfaces

    In this report, the heat transfer and isothermal flow friction characteristics for seven compact heat exchanger surfaces are presented and compared. Five of the surfaces were of a similar triangular fin configuration, differing in material and method of construction, and one of the surfaces, having …

    nps Repository record for Experimental determination of heat transfer and flow friction characteristics for several plate fin type compact heat exchanger surfaces (opens in a new tab)

  12. The use of the analog computer with the single blow transient testing technique for compact heat exchanger surfaces.

    … time derivative of the temperature response of a compact heat exchanger surface subjected to a step change in incoming fluid temperature; and to investigate the effect of the ratio of flow length to hydraulic diameter (L/DH) on the heat transfer and flow fricition characteristics of compact heat …

    nps Repository record for The use of the analog computer with the single blow transient testing technique for compact heat exchanger surfaces. (opens in a new tab)

  13. Experimental Investigation of a Compact Heat Exchanger for Thermal Energy Storage in Sustainability Applications (for Mitigating Energy-Water Nexus Issues)

    The application of a compact heat exchanger (CHX) as a latent heat thermal storage system (LHTESS) was explored in this study by employing phase change materials (PCM), for supplementing cooling loads of a dry-cooling platform. The melting and solidification times for a fixed mass of a chosen PCM …

    tamu Repository record for Experimental Investigation of a Compact Heat Exchanger for Thermal Energy Storage in Sustainability Applications (for Mitigating Energy-Water Nexus Issues) (opens in a new tab)

  14. Horizontal Two-Phase Flow of Air-Water Mixtures in Small Diameter Tubes and Compact Heat Exchangers

    … flow. Also, the flow patterns that exist in a Compact Heat Exchanger were determined in order to verify or refute the assumption that the flow pattern that exists in the Compact Heat Exchanger is an intimate mixture of the two phases with both the gas and the liquid travelling at the same …

    uiuc Repository record for Horizontal Two-Phase Flow of Air-Water Mixtures in Small Diameter Tubes and Compact Heat Exchangers (opens in a new tab)

  15. Measurements and Predictions of the Heat Transfer at the Tube-Fin Junction for Louvered Fin Heat Exchangers

    Compact heat exchangers are usually characterized by a large heat transfer surface per unit of volume. These characteristics are useful when thermal energy between two or more fluids must be exchanged without mixing. Most compact heat exchangers are liquid-to-air heat exchangers, with approximately …

    vt Repository record for Measurements and Predictions of the Heat Transfer at the Tube-Fin Junction for Louvered Fin Heat Exchangers (opens in a new tab)

  16. SOLUTION OF THE SINGLE BLOW PROBLEM WITH LONGITUDINAL CONDUCTION BY NUMERICAL INVERSION OF LAPLACE TRANSFORMS.

    … differential equations represent the transient heat transfer behavior of compact heat exchanger surfaces when subjected to a step change in fluid temperature. A solution is presented for this system which includes the effects of longitudinal thermal heat conduction. Also presented are the …

    nps Repository record for SOLUTION OF THE SINGLE BLOW PROBLEM WITH LONGITUDINAL CONDUCTION BY NUMERICAL INVERSION OF LAPLACE TRANSFORMS. (opens in a new tab)

  17. Heat Transfer Enhancement Using Tip and Junction Vortices

    This research is important in compact heat exchanger design. Enhancing heat transfer can lead to smaller, more efficient heat exchangers in a broad range of applications. A simplified heat exchanger performance evaluation method is considered to explore the heat transfer benefit and pressure-drop …

    uiuc Repository record for Heat Transfer Enhancement Using Tip and Junction Vortices (opens in a new tab)

  18. Heat Transfer Measurements and Optimization Studies Relevant to Louvered Fin Compact Heat Exchangers

    A compact heat exchanger is a device used to transfer thermal energy between two or more fluids. The most extensive use of compact heat exchangers occurs in the commercial trucking industry. Most compact heat exchanger designs contain tubes carrying one fluid and external fins through which passes …

    vt Repository record for Heat Transfer Measurements and Optimization Studies Relevant to Louvered Fin Compact Heat Exchangers (opens in a new tab)

Page 1 of 4