Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 12 of 12 for “"Compression Simulation"”.
-
WASTE HEAT RECOVERY SYSTEM FOR A GAS TURBINE ENGINE AND CARBON DIOXIDE COMPRESSION SIMULATION
The U.S. Department of Defense has implemented an initiative to become more energy efficient across all services. The Naval Postgraduate School supported development toward this goal by studying the possibility of energy generation using waste heat recovery within shipboard engine exhaust. This …
-
Novel motion estimators for video compression.
… with the recently proposed MPEG-1 video compression standard. Simulation results indicate that the proposed algorithm provides a comparable performance (compared to the algorithms reported in the literature) at a significantly reduced computational complexity. In addition, the hardware …
-
Multiscale Analysis of Soil-Strap Interactions in Mechanically Stabilized Earth Retaining Walls
… macroscale structure. The general setup of the simulation is a steel specimen encased in a rectangular apparatus filled with particles. A normal pressure is applied to the top layer of particles while the strap is slowly removed from the box until it reaches a prescribed displacement.The …
-
Evaluation of the Best Equation of State for Enhanced Oil Recovery Use in Ultra-high Pressure Hydraulic Calculation
… design starts with EOS selection, process simulation, heat and material balance calculation, equipment sizing and finally detailed engineering. This study focuses on the investigation of the most probable and applicable equations of state (EsOS) such as GERG-EOS, BWRS-EOS, LKP-EOS and …
-
Development of a Component Based Simulation Tool for the Steady State and Transient Analysis of Vapor Compression Systems
Computer simulations have become a commonly used tool to aid engineers design and optimize vapor compression systems. Generally, the simulation of vapor compression heat pump systems falls into one of two categories; steady state and transient. Steady state simulations are typically very accurate …
-
Computational Modeling of Hard Tissue Response and Fracture in the Lower Cervical Spine under Compression Including Age Effects
… response of a C57 (C5-C6-C7) segment model under compression loading. Two sets of material properties were identified that corresponded to the lower age of the experimental test samples (younger than 50 years old (YO)) and the higher age of the test samples (older than 70 YO). The available …
-
Investigation of Hydraulic and Mechanical Cement Integrity: An Advanced Computational Study
… efficiency via a numerical approach. Diametric compression simulation indicates that cement sheath is likely to fail at the casing interface before the formation interface. Along with the casing-cement interface, failure would initiate at the location parallel to the direction of applied load (θ …
-
A methodology of calibrating flexible fibers in the discrete element method for simulating wheat straw shear
… for use in discrete element method (DEM)</p> <p>simulations was developed, specifically for crop-machine simulations of wheat straw. The</p> <p>calibration procedure utilized three different tests, the cantilever beam test, the 3-point-bending</p> <p>test, and the uniaxial compression test. The …
-
Temporal Registration of Mammograms by Finite Element Simulation of MR Breast Volume Deformation
… times are often obtained under different compressions, orientations or body positions. A temporal pair of mammograms may vary quite significantly due to the spatial disparities caused by the variety in acquisition environments, including the 3D position of the breast, the amount of the …
-
Simulation and Validation of Vapor Compression System Faults and Start-up/Shut-down Transients
… models for each of the components of the vapor compression systems. However, there has been very little information on developing simulation models that have been validated for the conditions of start-up/shutdown operations as well as vapor compression system faults. This thesis addresses these …
-
Desenvolvimento de monitor para o ensino baseado em simulação de manobras de ressuscitação cardiopulmonar com monitorização hemodinâmica em manequins
… accuracy and efficiency of external chest compression. OBJECTIVES: To develop a device for hemodynamic monitoring during the teaching of Cardiopulmonary Resuscitation maneuvers on mannequins in a simulation laboratory.METHODOLOGY: This is a quasi-experimental study for the development of an …
-
The Effect of Paramedic Position on External Chest Compression Quality: A Simulation Study
… have emphasised the performance of quality chest compressions. With this in mind this thesis sought to investigate whether the position of the paramedic performing chest compressions, either from-the-side (FTS) or over-the-head (OTH), influenced the quality of cardiopulmonary resuscitation (CPR). …