Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 33 for “"Continuous-time filters"”.
-
Automatic tuning of continuous-time filters
Integrated high-Q continuous-time filters require adaptive tuning circuits that will correct the filter parameters such as center frequency and quality factor (Q). Three different automatic tuning techniques are introduced. In all of the proposed methods, frequencyand quality factor tuning loops …
-
Linearity improvement technique for CMOS continuous-time filters
… applied in the implementation of low-distortion continuous-time filters in complementary metal-oxide-semiconductor (CMOS) technology. This work is motivated by the fact that to date, most of the techniques in continuous-time, electronically tunable filters perform quite poorly in linearity. The …
-
Asymptotic convergence of non-linear, continuous-time filters
Thesis (Ph. D.)--Michigan State University. Department of Electrical Engineering, 1969
-
High frequency and high dynamic range continuous time filters
… very demanding high-performance analog filters are typically used to block interferers and provide anti-aliasing before the subsequent analog to digital conversion stage. For frequencies higher than 10MHz, Gm-C filter implementations are generally preferred due to the more efficient …
-
High performance continuous-time filters for information transfer systems
Vast attention has been paid to active continuous-time filters over the years. Thus as the cheap, readily available integrated circuit OpAmps replaced their discrete circuit versions, it became feasible to consider active-RC filter circuits using large numbers of OpAmps. Similarly the development …
-
Automatic Synthesis of VLSI Layout for CMOS Continuous-Time Filters
… part of the design industry as the window of time from conception to production shrinks with ever increasing competition. However, automatic synthesis of analog VLSI layout remains rare. With digital circuits, there is often room for signal drift. In a digital circuit, a signal can drift …
-
Automatic Synthesis of VLSI Layout for Analog Continuous-time Filters
… part of the design industry as the window of time from conception to production shrinks with ever increasing competition. However, automatic synthesis of analog VLSI layout remains rare. With digital circuits, there is often room for signal drift. In a digital circuit, a signal can drift …
-
A digital tuning scheme for digitally programmable integrated continuous-time filters and techniques for high-precision monolithic linear circuit design and implementation
… scheme for digitally programmable integrated continuous-time filters (4), (8) - (10). Emphasis of this research is on development of a more general tuning scheme which can be applicable to various filter functions as well as high-frequency applications. The tuning scheme consists of two …
-
A bipolar, semi-gaussian pulse shaping amplifier based on transconductance-C continuous time filters for use in a high resolution, small animal x-ray CT system
… using transconductance-C (G<sub>m</sub>-C) filters has been developed for use with the Oak Ridge National Laboratory (ORNL) MicroCAT small animal <i>x-ray</i> CT imaging system. The MicroCAT system employs Cadmium Zinc Telluride (CZT), a relatively new semiconductor detector material. The …
-
A 1V 8th-order 250MHz current-mode butterworth lowpass filter
<p>Continuous-time filters can be used as preprocessing blocks in front of an analog-to-digital converter (A/D) in the receiving data path of a disk-drive read-channel system and as post processing blocks after a digital system. High-frequency continuous-time filters with low supply voltage are …
-
Filter Design Considerations for High Performance Continuous-Time Low-Pass Sigma-Delta ADC
Continuous-time filters are critical components in the implementation of large bandwidth, high frequency, and high resolution continuous-time (CT) sigma-delta (ΣΔ) analog-to-digital converters (ADCs). The loop filter defines the noise-transfer function (NTF) and hence the quantization noise-shaping …
-
Parameter uncertainty in stochastic filtering
… We focus in particular on two finite-dimensional continuous-time filters, namely the Kalman-Bucy and Wonham filters. In each case, we present novel comparison results for the viscosity solution of the associated Hamilton-Jacobi-Bellman equation.</p> <p>To enable this analysis we consider pathwise …
-
ΔΟΜΕΣ MOS ΕΞΙ ΑΚΡΟΔΕΚΤΩΝ ΚΑΙ ΕΦΑΡΜΟΓΕΣ ΤΟΥΣ ΣΕ ΗΛΕΚΤΡΟΝΙΚΑ ΕΛΕΓΧΟΜΕΝΕΣ ΑΝΤΙΣΤΑΣΕΙΣ
… RESISTORS, COMMON BUILDING BLOCKS OF CONTINUOUS-TIME FILTERS, MULTIPLIERS, AGC CIRCUITS ETC. THE PROPOSED TECHNIQUE REQUIRES SIMPLE PERIPHERAL CIRCUITS AND YIELDSHIGHLY-LINEAR RESISTORS. THE LINEARITY IMPROVEMENT IN COMPARISON TO CONVENTIONAL MOSFETS IS BETTER THAN 3000. (ABSTRACT …
-
Design techniques for high intermediate frequency bandpass (sigma/delta) modulator.
… with a step size of T/30 seconds, where T is the time period (1.25 nanoseconds) of sampling signal (800 MHz) in high IF (200 MHz) Bandpass [sigma delta] ADC. The implementation details of the element rotation scheme used to calibrate the multi-bit DAC static error mismatch are also presented. Also …
-
CMOS current amplifiers : speed versus nonlinearity
… In this work, two 1 MHz 3rd -order low-pass continuous-time filters are realised with a 1.2 μm CMOS-process. These filters use a differential CCII∞ with linearised, dynamically biased output stages resulting in performance superior to most OTA-C filter realisations reported. Similarly, two …
-
Robust filtering / Garry Allan Einicke.
This study is concerned with filters that are robust to uncertainties in either the signal models or the noise statistics. Extensions to an interpolation approach to solving a continuous-time, linear, stationary filtering problem are presented. A robust extended Kalman filter is developed.
-
Design and Automatic Calibration of Analog Filters for VLSI Applications
A bandstop filter is required in broad-band receivers to attenuate the interference signal from the wanted signal. Due to the voltage, temperature, and process variation, automatic tuning circuitry is required to maintain filter characteristics and improve the filter performance. This research …
Page 1 of 2