Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 58 for “"Copper films"”.
-
Nanoscale Growth Twins in Sputtered Copper Films
… development of high strength, high conductivity copper films. Pure copper is soft and traditional strengthening mechanisms cause substantial decrease in conductivity. To address the challenge, epitaxial nanotwinned copper films are synthesized on HF etched Si (110) substrates. These films show …
-
Microstructure and mechanical properties of electrodeposited copper films
… counterparts. Nanostructured electrodeposited copper film, for example, is of interest for applications in ultra large-scale integrated (ULSI) devices. However, the microstructure evolution of the copper film at room temperature, which is termed self annealing, can cause reliability problems. …
-
Experiments on thermal relaxation of copper films for nano-calorimetry
… investigate thermal relaxation in evaporated copper films at sub-kelvin temperatures. We characterize the thermal transport properties of the copper film in both steady-state and dynamic regime. First, we give a short introduction to the nano-calorimeter and theoretically describe the relevant …
-
Superconducting characteristics of thin tin films in contact with copper films
Copper films of calculated thicknesses between 200 and 500° have been evaporated on tin films about 1000 and 2000° thick and the superconducting properties studied. In every case, the critical current for the coated specimen was reduced substantially from the value for an identical tin specimen …
-
The influence of additives on microstructure evolution of electrochemically deposited copper films
… of deposition and microstructure evolution of Cu films, which were electrochemically deposited (ECD) on Au substrates. The rate of bulk Cu deposition was quantified with cyclic voltammetry. The self-annealing of the as-deposited Cu films was recorded at room temperature with resistivity …
-
Dependence of stress and morphology of sputtered copper films on deposition conditions
… can be used to control stress in sputtered metal films. We worked with sputtered copper on polyimide (Kapton H) as a film-substrate combination which occurs frequently in the microelectronic packaging industry. Stress and film growth in sputtered films were studied as a fuction of: (1) argon gas …
-
Dependence of stress and resistivity of sputtered copper films on deposition conditions
Stress and resistivity in sputtered copper films on glass and polyimide (Kapton H) substrates were studied as functions of deposition rate and argon working gas pressure. For deposition rates from 1 A/sec to 5 A/sec, three regions were studied at different argon gas pressures : (1) a compressive …
-
X-ray diffraction analyses of electrolytic and electroless copper films for circuit boards
<p>Electrolytic and electroless deposited copper films from different baths and with different polymeric substrates (ABS, polyimide, and FR-4) were analyzed by x-ray diffraction (XRD). The sin<sup>2</sup>φ method was employed for determining macrostresses in those films. Separate contributions to …
-
Low pressure chemical vapor deposition of copper films from CU(I)(HFAC)(TMVS)
Recently, copper has been found as a possible substitute for Al alloys because of its low resistivity (1.67 u[Omega] cm) and potentially improved resistance to electromigration. Conventional physical vapor deposition (PVD) method do not provide the conformal deposition profile for the high density …
-
Instrumentation For the Study of Tantalum Diffusion Barriers Between Silicon Substrates and Copper Films
… for future reduction of silicon devices. Copper is better suited for sub-micron sized interconnects because of its lower electromigration and lower electrical resistance as compared to aluminum. However, copper has a tendency to readily diffuse into silicon; therefore, a diffusion barrier …
-
Study of stress relaxation and electromigration in Cu/low-k interconnects
… and SiC, which were incorporated into blanket copper films and line structures. The thermal cycling stresses of passivated and unpassivated blanket copper films showed higher yield strengths for passivated copper films, implying that the passivation restrained the plastic deformation in the …
-
Growth Monitoring of Ultrathin Copper and Copper Oxide Films Deposited by Atomic Layer Deposition
Atomic layer deposition (ALD) of copper films is getting enormous interest. Ultrathin Cu films are applied as the seed layer for electrochemical deposition (ECD) of copper in interconnect circuits and as the non-magnetic material for the realization of giant magnetoresistance (GMR) sensors. …
-
The optical properties of evaporated metal films
… investigation of the optical constants of metal films formed by evaporation under vacuum. Two methods of optical investigation were employed. In the first method the equations of Drude were applied to polarimetric measurements of the relative phase change and relative amplitude reduction of a …
-
Electrodeposition of Cu and Cu-Pd alloys from aqueous and liquid crystal media and their activity for nitrate reduction
… preparation and characterisation of palladium, copper and copper-palladium alloy films for nitrate and nitrite electroreduction. Palladium, copper and copper-palladium films were prepared by electroreduction of the respective salt precursors within the aqueous domain of the hexagonal …
-
Plasma Enhanced Chemical Vapor Deposition on Living Substrates: Development, Characterization, and Biological Applications
… such as polymeric, metallic, and composite films, can be readily synthesized through this technique. Second, the PMMA and copper films deposited using DBD jets were characterized. High-rate (22 nm/s), low-temperature (39 ºC) PMMA deposition was achieved and the film surface morphology can be …
-
Spontaneous metal deposition from organic solutions for electronic materials applications
… unpatterned pure aluminum and Al(0.5wt%Cu) thin films using this immersion displacement process. The Cu and Pd deposits were effectively used as catalytic sites for subsequent conventional electroless or electrolytic copper deposition. Further studies were performed to modify and optimize the …
-
Adhesion enhancement of metal films deposited onto excimer laser treated ceramic substrates
… on the adhesion strength of gold, nickel or copper films sputter deposited onto polished polycrystalline alumina substrates and high purity amorphous fused silica have been studied. The effects of oxygen content of the laser irradiation atmosphere as well as the effects of thermal annealing …
-
Graphene-based composite conductors for aerospace applications
This thesis explores the utilization of copper-graphene composite conductors as an alternative to traditional copper conductors for aerospace applications. Previous studies have indicated that copper-graphene composites can achieve higher electrical conductivity compared to traditional copper …
-
The reduction of nitrate at copper, cadmium and copper-cadmium alloy electrodes
… study of the reduction of nitrate at cadmium and copper films electrodeposited onto a gold rotating disk electrode (ROE). Our goal is to find an electrode material that supports the reduction of nitrate to nitrite but not the further reduction of nitrite to ammonia. The electrochemistry between …
Page 1 of 3