Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 9 of 9 for “"CoreLok"”.
-
Comparison of methods for determining bulk specific gravity of Hma specimens
… conducted using two methods, Parafilm(TM) and Corelok(TM). The measurements were compared for similarity and repeatability of results. The comparisons were made on two sets of specimens, unrutted and rutted specimens. The unrutted specimens were laboratory prepared beams and cores obtained from …
-
Evaluation of methods for determining bulk specific gravity of Hma specimens
… Water Displacement(TM), Parafilm(TM) and Corelok(TM). The evaluations were made on a total of sixty-two sets of two or three specimens, four different mix designs for rutted specimens, and three different mix designs for the unrutted specimens. The bulk specific gravity test results were …
-
Laboratory evaluation of cold in-place recycling asphalt mixtures using a balanced mix design
… test specimen was determined using the CoreLok device. The rutting susceptibility of these mixtures was then evaluated using the Asphalt Pavement Analyzer (APA) and Dynamic Complex Modulus (|E*|) while resistance to cracking was evaluated using the Indirect Tensile Strength (ITS) test …
-
Evaluating the protocol of the spectrum of hot mix asphalt mixes produced in West Virginia
… using three methods: Saturated Surface-Dry, CoreLok, and Dimensional (volumetric mass density). Moreover, assessing a mix's inherent capability to be uniformly compacted is integral in both laboratory and field evaluations. The nine mix designs were assessed for uniformity following AASHTO PP …
-
Unconfined Compression Tests on Basalt Rocks from Hawaii
… and apparent), unit weight through the use of a CoreLok machine, absorption, RQD, and percent recovered. Properties obtained from compression tests included unconfined compressive strength, Young’s Modulus, axial strain at failure or at 50% of ultimate load, failure type, and failure plane angle …
-
Analysis and Procedures for Conducting Laboratory and Field Dielectric Measurements for Asphalt Pavement Density Evaluation
… such as saturated surface dry (SSD) and Corelok vacuum sealing, require multiple pieces of equipment and multiple measurements. Not to mention, the utilized methods also differ based on the porosity of asphalt mixtures or the absorptive properties of aggregates. Ground penetrating radar …
-
Effect of Binder Modification and Aggregate Size on Modulus and Fatigue of Asphalt Concrete
… within the samples: Saturated Surface-Dry, CoreLok, and Dimensional (volumetric mass density). Finally, to evaluate samples for performance properties the Asphalt Mixture Performance Tester (AMPT) was utilized. The AMPT is a relatively new method to measure the performance of a mixture by …
-
Hot Mix Asphalt Concrete Density, Bulk Specific Gravity, and Permeability
… the AASHTO T166 is proven to be repeatable, and CoreLok is a viable device for determining the Gmb and corresponding air voids of field cores. Based on density data from the I-79 project, provided by the contractor and WVDOH, the thin-lift gauge had smaller correction factors than standard …
-
Permeability and Moisture Damage Characteristics of Asphalt Pavements
… and isolated pores are also determined using a CoreLok device. It is shown that permeable pores have a better correlation with permeability than the effective pore, which is defined as the sum of permeable and dead-end pores. In this study, an attempt is made to correlate laboratory permeability …