Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 103 for “"Critical flow"”.

  1. Open channel transitions with sub-critical flow

    Inlet transitions with sub-critical flow from trapezoidal to rectangular sections are studied. The water depths range from 5 to 10 feet and the bottom widths range from 5 to 12.5 feet. Graphs were constructed to design these types of transitions. The behavior of a given transition with different …

    vt Repository record for Open channel transitions with sub-critical flow (opens in a new tab)

  2. Critical flow velocity in super fluid 3He-B

    … an object in uniform linear motion at the Landau critical velocity. The experiments were performed in a “Lancaster style” nested experimental cell at ultra-low temperatures within the ballistic limit. In the first set of experiments we studied two almost identical quartz tuning fork resonators …

    lancaster Download PDF for Critical flow velocity in super fluid 3He-B (opens in a new tab)

  3. Computational Study of Critical Flow Discharge in Supercritical Water Cooled Reactors

    <p>Supercritical Water-cooled Reactor (SCWR) is a Generation-IV nuclear reactor design that operates on a direct energy conversion cycle above the thermodynamic critical point of water (374<sup>0</sup>C and 22.1 MPa), and offers higher thermal efficiency and considerable design simplification. As …

    mcmaster Repository record for Computational Study of Critical Flow Discharge in Supercritical Water Cooled Reactors (opens in a new tab)

  4. A Study of a General One-Dimensional Two-Fluid Critical Flow Model

    <p>Accurate modelling of critical two-phase flow is important for the simulation of Loss-of-Coolant-Accidents in the nuclear industry and for the sizing of emergency relief valve systems in the chemical industry. A large body of experimental and theoretical work including the development of many …

    mcmaster Repository record for A Study of a General One-Dimensional Two-Fluid Critical Flow Model (opens in a new tab)

  5. Two-Phase, One-Component Critical Flow At Sub-Atmospheric Pressures using Freon-11

    Low pressure one-component two-phase critical flow studies in long cylindrical tubes were undertaken using Freon-11. Critical discharge pressures from 3.0 to 13.5 psia were observed with measured mass fluxes from 250 to 2100 lbm/ft2 sec in tubes ranging from 25 to 300 length to diameter ratio for …

    marquette Repository record for Two-Phase, One-Component Critical Flow At Sub-Atmospheric Pressures using Freon-11 (opens in a new tab)

  6. Aspects of two-phase critical flow of water in short nozzles under flashing conditions

    The phenomenon of choking or mass limiting flows of two-phase mixtures is well known. The particular case of choking two-phase flow in which mass transfer takes place between phases is designated two-phase critical flashing flow, and has been the subject of many theoretical and experimental …

    glasgow Download PDF for Aspects of two-phase critical flow of water in short nozzles under flashing conditions (opens in a new tab)

  7. Validation and Sensitivity Studies of Thermal-Hydraulic Code Predictions of Critical Flow Experiments Using RELAP5/Asyst

    Critical flow plays a fundamental role in nuclear safety analysis, particularly during loss-of-coolant accidents (LOCA), where it determines the discharge rate of coolant from the reactor system. This study reviews the physical principles and experimental investigations of critical and blowdown …

    mcmaster Repository record for Validation and Sensitivity Studies of Thermal-Hydraulic Code Predictions of Critical Flow Experiments Using RELAP5/Asyst (opens in a new tab)

  8. A sensitivity study of the critical flow models used in RELAP4/MOD5 blowdown analysis of a General Electric BWR

    … 5 Computer Code to analyze the effects of critical flow modeling on the thermal-hydraulic transient response of a General Electric boiling water reactor to a major primary coolant line rupture. Included in the study is a presentation of the equations, assumptions, and limitations of the …

    nps Repository record for A sensitivity study of the critical flow models used in RELAP4/MOD5 blowdown analysis of a General Electric BWR (opens in a new tab)

  9. Stationary wave trains in steep channels: experimental hydraulics and velocity estimation

    … have been interpreted as indicators of near-critical flow and associated with undular hydraulic jumps (UHJs) in steep rivers. However, the hydraulic conditions under which these waves form, and the extent to which their observable properties reflect flow characteristics, remain incompletely …

    colostate Repository record for Stationary wave trains in steep channels: experimental hydraulics and velocity estimation (opens in a new tab)

  10. Some factors affecting journey-times on urban roads.

    … relationships between journey-time and traffic flow during peak periods on two sections of urban road, each about 0.4 miles in length, and (b) of relationships between journey-times and a number of land-use variables over about 50 miles of suburban main roads in off-peak periods. The results of …

    middlesex Download PDF for Some factors affecting journey-times on urban roads. (opens in a new tab)

  11. Modelling and prediction of flashing flow in short tubes

    … a physically realistic method for predicting the flowrates in short tubes. A physically realistic model, though based on tests with one refrigerant, could be extrapolated to other refrigerants and to other refrigeration systems. Most of the existing methods of predicting flowrates are achieved by …

    vt Repository record for Modelling and prediction of flashing flow in short tubes (opens in a new tab)

  12. Analysis of the Critical Flows of One-Component Fluids in Tubes

    Two-phase critical discharge phenomena have been under investigation for some time now. Most models developed so far have necessitated a knowledge of the critical pressure to predict the critical flow rate. This type of analysis has limited application, as in most cases, only the stagnation …

    marquette Repository record for Analysis of the Critical Flows of One-Component Fluids in Tubes (opens in a new tab)

  13. Experimental Investigation of Self-Pressurizing Propellant Injection Into a Rocket Motor Combustion Chamber

    … study of nitrous oxide (N2O) two-phase-flashing flows using carbon dioxide (CO2) as an analog. An experiment was designed and performed to replicate the flashing flow through a sharp-edged rocket injector. Pressure, temperature and mass flow rate were measured across the injector channel. Data …

    calgary Repository record for Experimental Investigation of Self-Pressurizing Propellant Injection Into a Rocket Motor Combustion Chamber (opens in a new tab)

  14. Mechanisms Controlling Non-Steady Plume-Wall Interactions in Rocket Launch-Tubes (Gas, Fluid Dynamics, Rocket Systems, Base Flows, Supersonic Flows)

    … controlling the interactions between base flow induced irreversibilities with downstream effective critical flow conditions within rocket launch tubes due to friction and/or cross-sectional obstruction are studied here in detail. The analytical treatment by the flow component approach using …

    uiuc Repository record for Mechanisms Controlling Non-Steady Plume-Wall Interactions in Rocket Launch-Tubes (Gas, Fluid Dynamics, Rocket Systems, Base Flows, Supersonic Flows) (opens in a new tab)

  15. Investigation of solution methods suitable for modelling steam collapse and pressure peaks using RELAP5

    … and homogenous solution and deactivation of the critical flow model. In addition to these changes some further solution approaches, not anticipated to affect the results in a higher degree, are investigated. The results showed that one solution approach were more suitable to use as steam collapse …

    chalmers Repository record for Investigation of solution methods suitable for modelling steam collapse and pressure peaks using RELAP5 (opens in a new tab)

  16. Investigation of solution methods suitable for modelling steam collapse and pressure peaks using RELAP5

    … and homogenous solution and deactivation of the critical flow model. In addition to these changes some further solution approaches, not anticipated to affect the results in a higher degree, are investigated. The results showed that one solution approach were more suitable to use as steam collapse …

    chalmers Repository record for Investigation of solution methods suitable for modelling steam collapse and pressure peaks using RELAP5 (opens in a new tab)

  17. The hydraulics of steep streams.

    … the presence of steps increased resistance to flow at lower than step-forming flow and decreased resistance at above step-forming flows. In the field, flow resistance was found to be controlled by sediment characteristics and the amount of step protrusion. The hydraulic geometry of the steep …

    whiterose Download PDF for The hydraulics of steep streams. (opens in a new tab)

  18. Implications of Shallow Water in Numerical Simulations of a Surface Effect Ship

    … at various depth Froude numbers resulting in subcritical, critical, and supercritical flow regimes. Resistance, pitch response, and free surface response of the SES were compared between the shallow water simulations. The SES produced wider wakes, perpendicular to the craft, at simulations closer …

    vt Repository record for Implications of Shallow Water in Numerical Simulations of a Surface Effect Ship (opens in a new tab)

Page 1 of 6