Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 43 for “"Defect-level"”.

  1. Defect-Level Condition Assessment of Sewer Pipelines in Auckland

    … in keeping sewer pipe performance at a desirable level. A sewer pipe condition score is normally assigned to each sewer pipe based on the type, quantity, and extent of defects observed through CCTV inspections. While the impact of different factors on the condition score has been considered in …

    auckland-ms Repository record for Defect-Level Condition Assessment of Sewer Pipelines in Auckland (opens in a new tab)

  2. The Defect Level Of Carbon Vacancy Carbon Antisite Pair In 4H-Sic Using Photo Induced Electron Paramagnetic Resonance

    … applications in high power devices. Point defects and the associated defect levels are important to understand if we are to produce high quality SiC wafers. While a lot has been done to understand point defects using electrical measurements, electron paramagnetic resonance (EPR) reveals …

    uab Repository record for The Defect Level Of Carbon Vacancy Carbon Antisite Pair In 4H-Sic Using Photo Induced Electron Paramagnetic Resonance (opens in a new tab)

  3. Intrinsic and Extrinsic Catalysis in Zirconium-based Metal-Organic Frameworks

    … site concentration through introduction of defects and macromorphological control, as well as utilization of molecular catalysts imbedded in the MOF structure for multicomponent, light driven reactivity. Chapter 1 introduces the history MOFs and the pursuit of the stable structures commonly …

    vt Repository record for Intrinsic and Extrinsic Catalysis in Zirconium-based Metal-Organic Frameworks (opens in a new tab)

  4. First-Principles Study on Mg DOPING OF ZnO

    … to intensify in the presence of magnesium (Mg) defects. Here, ab initio calculations are carried out on ZnO to investigate the mechanism for this increased green light emission. Knowing from other research works that oxygen vacancy is likely to contribute to green light emission in ZnO, a …

    nus Repository record for First-Principles Study on Mg DOPING OF ZnO (opens in a new tab) Download file for First-Principles Study on Mg DOPING OF ZnO (opens in a new tab)

  5. Optimization of p-layer interface in CdSe thin-film solar cells

    … CdSe performance has not reached a sufficient level to make it economically viable. This work aims to improve the efficiency of CdSe solar cells and investigate the parameters limiting performance. The interface between a PTAA hole-transport layer and gold contact was improved through the …

    iastate Repository record for Optimization of p-layer interface in CdSe thin-film solar cells (opens in a new tab)

  6. Radiation-induced Deep-level Defects in CCD Imaging and Spectroscopy Sensors

    … concerned with the analysis of radiation-induced defects within the silicon lattice of a Charge-Coupled Device (CCD) image or spectroscopy sensor and particularly those defects with energy levels which can trap charge as it passes through a device, ultimately leading to image quality degradation. …

    the-open-u Download PDF for Radiation-induced Deep-level Defects in CCD Imaging and Spectroscopy Sensors (opens in a new tab)

  7. Interaction of Plasmons and Excitons for Low-Dimension Semiconductors

    … nonlinear optical processes, SHG and TPE. Defect level emission had more contribution at high incident intensity. Emissions are different for pumping deep into the bulk and near surface. A new assumption to increase the TPE efficiency was studied. We thought by using Au nanorods localized …

    unt Repository record for Interaction of Plasmons and Excitons for Low-Dimension Semiconductors (opens in a new tab)

  8. Statistical modelling of skyrmion magnetic materials with defects

    … compact size and topological stability. However, defects introduced during the manufacturing process can unpredictably affect the stability and dynamics of skyrmions, compromising data reliability. To address this, we conduct a comprehensive study using statistical physics-based modeling and …

    soton Download PDF for Statistical modelling of skyrmion magnetic materials with defects (opens in a new tab)

  9. Analog Statistical Design for Manufacturability

    The manufacturing yield, overkill, and defect level limit the feasibility of analog circuits in SoCs. The conventional method of handling process and environmental variation is to assign a design margin such that the design meets specifications at several processes and environmental corners. …

    portland-state Repository record for Analog Statistical Design for Manufacturability (opens in a new tab)

  10. Data Driven Feed Forward Adaptive Testing

    … time at wafer sort while maintaining the product defect level. Test data from first insertion of wafer is statistically analyzed to make a decision about adaptive test flow at subsequent insertions. The data driven feed forward technique uses a statistical screen to analyze test data from first …

    portland-state Repository record for Data Driven Feed Forward Adaptive Testing (opens in a new tab)

  11. A Study on Structural and Optical Properties of Vertically Aligned Zinc Oxide Nanorods

    … A1 (LO) Raman active modes. A reduction in the defect level peak intensities can be analyzed from the PL spectra as the diameter of the VAZO nanorods has been increased, by changing the temperature and also been effected by annealing treatment. Molecular dynamics simulation studies were …

    mo-state Repository record for A Study on Structural and Optical Properties of Vertically Aligned Zinc Oxide Nanorods (opens in a new tab)

  12. Photoconductivity in amorphous silicon

    … in energy, extending from the dark Fermi level upwards to 0.6eV below E<sub>c</sub>. The capture cross section of these states was of a value expected for the neutral dangling bond, so they have been denoted as D states. States outside this energy were seen to be ineffective as …

    abertay Repository record for Photoconductivity in amorphous silicon (opens in a new tab) Download PDF for Photoconductivity in amorphous silicon (opens in a new tab)

  13. Decision Support System to Predict the Manufacturing Yield of Printed Circuit Board Assembly Lines

    This research focuses on developing a model to predict the yield of a printed circuit board manufactured on a given assembly line. Based on an extensive literature review as well as discussion with industrial partners, it was determined that there is no tool available for assisting engineers in …

    vt Repository record for Decision Support System to Predict the Manufacturing Yield of Printed Circuit Board Assembly Lines (opens in a new tab)

  14. Ceria Defect Engineering Using Thin-Films/ALD and Biological applications

    … engineering applications due to their unique defect structure, enabling them to have regenerative redox properties. The ability to shuttle between Ce3+ and Ce4+ oxidation states extends to unique properties. Defect level in ceria is usually expressed in the Ce3+/Ce4+ ratio. It can be achieved …

    ucf Repository record for Ceria Defect Engineering Using Thin-Films/ALD and Biological applications (opens in a new tab)

  15. Photoconductivity in one dimensional metal oxides nanostructures.

    … showed multiple photocurrent contribution from defect level excitations, surface states and thermal heating effects. Significant photoresponse was observed in vacuum condition. The time characteristic of the observed photoresponse was further analysed and revealed characteristic response time in …

    nus Repository record for Photoconductivity in one dimensional metal oxides nanostructures. (opens in a new tab) Download file for Photoconductivity in one dimensional metal oxides nanostructures. (opens in a new tab)

  16. Optical Absorption of Point Defects in Doped Gallium Oxide Determined by Photo-Induced Electron Paramagnetic Resonance Spectroscopy

    … to have a thorough understanding and control of defects, as well as knowledge of the defect’s thermodynamic transition energy or defect level. This work investigates Fe or Mg, which are used to make semi-insulating Ga2O3 substrates useful for device fabrication, and determines the defect levels …

    uab Repository record for Optical Absorption of Point Defects in Doped Gallium Oxide Determined by Photo-Induced Electron Paramagnetic Resonance Spectroscopy (opens in a new tab)

  17. Thermal transport in carbon materials: Effect of low temperature and nanostructures

    … graphene paper with different reduction level, and carbon nanotube bundles have been studied in detail by using phonon scattering mechanisms analysis. The effect of low temperature, different nanostructures and thermal strain are the focus.</p> <p>Specifically, for the first time, the …

    iastate Repository record for Thermal transport in carbon materials: Effect of low temperature and nanostructures (opens in a new tab)

  18. "Non-ideal" electrical characteristics of crystalline silicon solar cells

    … device voltage) of the recombination rate via defects located either in the bulk or at the oxidized surfaces of silicon (Si) solar cells. This impacts directly on the analysis of the measured dark and illuminated I-V curves of high-efficiency "Passivated Emitter and Rear Locally-diffused" …

    unsw Repository record for "Non-ideal" electrical characteristics of crystalline silicon solar cells (opens in a new tab)

  19. Optical absorption of defects in aluminum nitride

    … and high electrical resistivity. Point defects are known to hinder the material’s properties and are therefore a subject of interest in semiconductor materials research. The samples used in this work were grown by physical vapor transport (PVT) at Hexatech and they exhibit amber and …

    uab Repository record for Optical absorption of defects in aluminum nitride (opens in a new tab)

  20. Electrical characterisation of defects in wide bandgap semiconductors.

    Defects usually have a very large influence on the semiconductor material properties and hence on fabricated electronic devices. The nature and properties of defects in semiconducting materials can be investigated by applying electrical characterization techniques such as thermal admittance …

    sheffield-hallam Download PDF for Electrical characterisation of defects in wide bandgap semiconductors. (opens in a new tab)

Page 1 of 3