Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 27 for “"Depletion Flocculation"”.
-
Rheological Studies of Fully-Formulated Coatings Thickened with HEUR: Effects of Surfactants
… than the previous systems. It appeared that a depletion flocculation mechanism dominated at low surfactant concentrations for fully-formulated systems in this study as evident from syneresis; large HEUR aggregates appear to build enough osmotic pressure to drive aggregation of latex and pigment …
-
Studies of Labile polyelectrolyte at solid-liquid interfaces
… polymer concentration (> 0.1 g/L) because of depletion flocculation. Borate ions do not influence the depletion threshold polymer concentration. However, HPG provides gravitational stability for flocculated emulsions to against phase separation.</p> <p>p.p1 {margin: 0.0px 0.0px 0.0px 0.0px; …
-
Modeling of Asphaltene Precipitation and Deposition
… causes phase separation into two liquids due to depletion flocculation and is modeled using PC-SAFT EOS. The effects of temperature, pressure and polystyrene MW on the mixture phase behavior are investigated. The phase behavior was not sensitive to the range of pressures studied; however, …
-
Influence of calcium chloride addition on the properties of emulsions formed with milk protein products : a thesis presented in partial fulfilment of the requirements for the degree of Master of Technology
… increased above 2.0%. This was attributed to depletion flocculation occurring in these emulsions. Whey proteins did not retard this instability, due to depletion flocculation, in emulsions made with mixtures of caseinate and WPC When CaCl2 was added prior to or after emulsion formation, the …
-
Phase Behavior, Structure, and Properties of Colloidal Microsphere-Nanoparticle Mixtures
… the upper critical nanoparticle volume fraction, depletion flocculation induced by the presence of highly charged nanoparticles in solution led to the reformation of a colloidal gel phase. The structure and strength of the colloidal gel phases observed below and above the homogeneous fluid phase …
-
Mechanisms of stabilizing fibre-enriched acidified dairy products
… The driving force for phase separation was depletion flocculation of casein micelles in the presence of β-glucan. The phase separation responsible for textural defects in yogurt systems supplemented with high amounts of Glucagel can be avoided by the reduction of β-glucan molecular weight, a …
-
DEVELOPMENT OF LONG-TERM STABLE MIXED SODIUM CASEINATE AND PEA PROTEIN ISOLATE-STABILIZED NANOEMULSIONS FOR THE DELIVERY OF CURCUMIN
… postulated that excess unabsorbed protein caused depletion flocculation leading to creaming of oil droplets, which was confirmed using confocal laser scanning microscopy. Calculation of depletion interaction energy showed an increase in attraction with protein concentration and decrease with a …
-
Effect of Surfactant, Oil:Water Ratio and Temperature on the Rheology of Emulsion-Suspension Complex Fluids: Implications for Oil-Based Drilling Fluids
… properties. Phenomena such as phase inversion, depletion flocculation and wall slip were equally found to affect the mechanical properties of both fluids, albeit to different extents.
-
Design of high solids emulsions for dehydration and carotenoids stabilisation
… materials. The present study investigated (i) flocculation in high total solids layer-by-layer (LBL) emulsion and deflocculation at various pH conditions, and whey protein isolate (WPI) concentration and total solids content effects on LBL emulsions stability; (ii) stability and loss kinetics …
-
Effects of urea addition on the structural and material properties of caseinate solutions and emulsions : a thesis presented in partial fulfilment of the requirements for the degree of Master of Food Science and Technology at Massey University, Manawatū, New Zealand
… were above the critical threshold for onset of depletion flocculation, the addition of urea was seen to result in a reduction in depletion free energy of the emulsions. The effects of reduced depletion interaction on emulsion stability, structural and rheological properties were found to be …
-
Effects of Xanthan/Locust Bean Gum Mixtures on the Physicochemical Properties and Oxidative Stability of Whey Protein Stabilized Oil-In-Water Emulsions
… of XG/LBG mixtures. Microstructure images showed depletion flocculation for LBG (0.05-0.5 wt%), XG (0.05- 0.2 wt%) and XG/LBG mixtures (0.05 and 0.1 wt%) emulsions. Flocculation was decreased with the increased biopolymer concentration in the emulsion. The decrease in flocculation was much …
-
Impact of ingredient interactions on the physico-chemical stability of milk protein-stabilised oil-in-water emulsions
… in fact, faster creaming may occur due to depletion flocculation effects when adding a neutral polysaccharide to these protein-stabilised emulsions. This macroscopic demixing could be reduced by formation of a sufficiently strong three-dimensional network, which could be realised by further …
-
Influence of wetting agent chemistry on associative interactions in hydrophobically modified cellulose ether systems
… surfactant concentration, likely due to depletion flocculation. Dynamic light scattering (DLS) measurements supported the formation of larger aggregates at higher surfactant concentration, immediately after sample preparation. Over time, the method suggested adsorption of …
-
Effect of ingredient interactions and heat treatment on the structure and stability of dairy based oil-in-water emulsions : a thesis presented in partial fulfillment of the requirements for the degree of Doctor of Philosophy in Food Technology at Massey University, Palmerston North, New Zealand
… of the mechanisms of instability, such as depletion flocculation, bridging flocculation, aggregation, creaming and coalescence, in high solids emulsion systems and at understanding the colloidal forces that drive specific material/rheological properties and the storage stability of complex …
-
Characterizing Hydroxypropyl Guar - Borate Interactions with Model Tear Film Components
… concentrations close to clinical levels induced depletion flocculation ofthe anionic liposomes. This is the first example we have found depletion interactions were proposed for the tear film. </p> <p> To summarize the main implications for the ophthalmic application of HPG are: 1) under …
-
Sub-micron Patterning of ZnO-PMMA Hybrid Films
… of Van der Waals forces, steric stabilization, depletion flocculation, as well as the physical impediment of entangled polymer chains were considered. A similar agglomeration behavior was shown in the simulations compared to the physical experiments. This thesis shows that polymer-nanoparticle …
-
Self-Assembled Photoresponsive and Thermoresponsive Nanostructures
… we believe the micelles induce <italic>depletion flocculation</italic> of the laponite particles into a gel network. Interestingly, if the PF127 concentration is increased further, the thermogelling is eliminated - this is suggested to be due to the micelles providing depletion …
-
Emulsification properties of puka gum - an exudate of a native New Zealand tree (Meryta sinclairii) : a thesis presented in partial fulfilment of the requirements for the degree of Master of Food Technology in Food and Advanced Technology at Massey University, Palmerston North, New Zealand
… were observed to have a mixture of bridging and depletion flocculation, as confirmed by the microstructure images of the emulsion and after the addition of SDS. At pH 6.5, coalescence occurred in heated emulsions. The apparent viscosity of these emulsions was dependent on gum concentration …
-
Effect of biopolymer addition on the properties of rennet-induced skim milk gels : a thesis presented in partial fulfilment of the requirements for the degree of Master of Technology in Food Technology at Massey University, Palmerston North, New Zealand
… polysaccharide, and was explained in termsof a depletion-flocculation mechanism. For rennet gels made under cheesemaking conditions (pH 6.2 with addition of 0.68 mM CaCl2), it was found that the addition of xanthan, guar, HM pectin and gelatin had similar effect to that when added to samples …
-
Microstructure engineering with quinoa protein for the design of plant-based soft materials
… was found that the mixtures phase separated by depletion flocculation, where fractions of MD were entrapped within the aggregated QPI network. This behaviour does not allow for structure formation by droplet deformation under shear and limits the application of these mixtures in microstructure …
Page 1 of 2