Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 16 of 16 for “"Distributed Feedback (DFB) Laser"”.
-
MATLAB simulation of a distributed feedback (DFB) laser with chirp effects
A model of a distributed feedback (DFB) laser was implemented in MATLAB and SIMULINK. Using the laser rate equation, the model was simulated to obtain general characteristics of the chirp of the lasers frequency. The simulations were controlled by using different drive current waveforms, based on …
-
Distributed-Feedback (DFB) laser stabilization using a ring resonator in silicon on insulator
… processing applications, stabilizing on-chip laser sources remains a critical challenge, especially in systems where isolators are not desired. Distributed Feedback (DFB) lasers are commonly used due to their low-cost and compact form factor. Still, their sensitivity to back-reflections from …
-
Extraction of semiconductor laser rate equation parameters for simulation of fiber-optical communication system purpose
… to extract modal parameters of semiconductor laser diodes based on a general zero-dimensional rate equation model. Three experiments, namely: the steady-state power versus injection current, small signal intensity modulation response and measurement of small signal response through dispersive …
-
Photonic front-end and comparator processor for a sigma-delta modulator
… The IO approach uses a continuous wave (CW) distributed feedback (DFB) laser diode at a peak wavelength of 1550 nm to oversample two Mach-Zehnder interferometers (MZIs). The MZIs are part of sigma-delta modulator-based analog-to-digital converter (ADC) oversampling architecture. A ring …
-
Fiber Bragg Gratings Strain Sensors for Railway Applications
… a low cost fiber-optic sensor system with a distributed feedback (DFB) laser as the light source has been implemented. We show that it has superior noise and sensitivity performances compared to strain gauge sensors. The design has been extended to accommodate multiple sensors with negligible …
-
Reconfigurable silicon photonic integrated circuits
… isolators, which are required to integrate lasers on Si as they block back-reflections from flowing back to the laser and destabilizing its operation. This dissertation addresses the aforementioned challenges as follows. By slightly doping the Si waveguides, defect states are introduced …
-
2 um Lasers for Cryogenic-Silicon Gravitational Wave Detectors
… linearly-polarised, high power laser with a wavelength in the 1.5-2.05 μm band must therefore be developed. The preferred architecture is a master oscillator followed by a chain of power amplifiers, sometimes referred to as a master-oscillator-power-amplifier (MOPA). …
-
Fiber optic sensing technology for measuring in-cylinder pressure in automotive engines
… The use of a Vertical Cavity Surface Emitting Laser (VCSEL) diode as a light source in an FFPI optic sensor system was investigated. Reflected light from the FFPI sensing element was used to measure the optical path difference. With a 1550nm VCSEL as the light source in a 12mm cavity length …
-
Noise Analysis and Reduction in a Fiber-Grating-Based Acoustic Emission Detection System
… wavelength shift to intensity variations of a laser whose wavelength is set on the slope of the grating’s reflection spectrum. Disturbance in such a sensing system, including the wavelength shift introduced by the components inside the system, and the response of the system to external …
-
Colloidal quantum dot and hybrid lasers
… research on solution-processed semiconductor lasers, with an emphasis on colloidal quantum dot (CQD) lasers, aimed at progressing the state of the art of the technology. A particular focus is placed on demonstrating such lasers under long (>nanosecond) pulse pumping in order to bring this …
-
Study of Passive Optical Network (PON) System and Devices
… division multiplexing (OOFDM)-PON. The colorless laser diodes are used at the optical network units (ONUs), and the overlapped channel spectrum of orthogonal subcarrier multiplexing provides high spectral efficiency. At the optical line terminal (OLT), optical switch and all optical fast Fourier …
-
One-Dimensional Simulation Methods for Distributed Feedback Semiconductor Lasers
<p> The semiconductor distributed feedback (DFB) laser is mainly characterised by the single-longitudinal-mode operation with a narrow spectral linewidth, which leads to its wide application in fiber-optic communication systems. Several numerical models ranging from physics-based to …
-
Label-free biosensor based upon a vertically emitting distributed feedback laser
… for the fabrication of solid state organic distributed feedback laser (DFB) biosensors. The combined techniques enable the organic DFB laser to be uniformly fabricated over large surface areas upon a flexible plastic substrate, with an approach that is compatible with roll-based …
-
High resolution optical coherent-channel analyzer using balanced-coherent detection and temperature-tuned DFB laser as local oscillator
… interest, such as the transmission spectrum of a laser and modulation spectrum of a channel require sub-picometer resolution, which cannot be achieved by conventional methods using a diffraction grating. High resolution spectrum analyzers (HRSAs) have been built based on heterodyne detection where …
-
IMPACT OF GRATING DUTY-CYCLE RANDOMNESS ON DFB LASER PERFORMANCE
… randomness (DCR) lying the Bragg grating of the distributed feedback (DFB) lasers introduced by the fabrication process is inevitable even with the state-of-the-art technologies such as the electron beam lithography and dry or wet etching. This thesis investigates the impact of grating DCR on DFB …
-
Wachstum und Charakterisierung von GaInNAs-basierenden Halbleiterstrukturen für Laseranwendungen in der optischen Telekommunikation
… als GaAs-basierende Alternative für herkömmliche Laser auf InP-Substrat hergestellt und untersucht. Zunächst wurden durch Optimierung der Substrattemperaturmessung und RF-Plasmaquelle die Voraussetzungen für gutes GaInNAs-Wachstum geschaffen. Thermisches Ausheilen ist essentiell, um eine gute …