Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 28 for “"Distributed Power System"”.

  1. Comparing Different Fault Identification Algorithms in Distributed Power System

    A power system is a huge complex system that delivers the electrical power from the generation units to the consumers. As the demand for electrical power increases, distributed power generation was introduced to the power system. Faults may occur in the power system at any time in different …

    wvu Repository record for Comparing Different Fault Identification Algorithms in Distributed Power System (opens in a new tab)

  2. Small-signal analysis and design of a distributed power system

    A small-signal analysis of a two-stage distributed power system is performed. Although the distributed power system is composed of conventional PWM converters, the analysis methods can be extended to systems using other converter topologies. The analysis focuses on two important features of a …

    vt Repository record for Small-signal analysis and design of a distributed power system (opens in a new tab)

  3. High frequency AC distributed power system for desktop computer applications

    … presents increasing challenges for the power demands, such as higher power density, lower supply voltage with very tight tolerance, and higher supply current with very high slew rate (di/dt). The existing dc distributed power system (DC DPS) suffers from low efficiency and poor transient …

    concordia Download PDF for High frequency AC distributed power system for desktop computer applications (opens in a new tab)

  4. Topology investigation of front end DC/DC converter for distributed power system

    … fast advance in VLSI technology, smaller, more powerful digital system is available. It requires power supply with higher power density, lower profile and higher efficiency. PWM topologies have been widely used for this application. Unfortunately, hold up time requirement put huge penalties on …

    vt Repository record for Topology investigation of front end DC/DC converter for distributed power system (opens in a new tab)

  5. Design guidelines for inverter fed motor drives in distributed power system applications

    A distributed power system (DPS) is made up of several subsystems. For example, a two-stage distributed power system is made of a source subsystem consisting of line conditioners and a load subsystem consisting of loads. Motor drives used as a load subsystem form an important type of load in …

    vt Repository record for Design guidelines for inverter fed motor drives in distributed power system applications (opens in a new tab)

  6. Investigation of High-density Integrated Solution for AC/DC Conversion of a Distributed Power System

    With the development of information technology, power management for telecom and computer applications become a large market for power supply industries. To meet the performance and reliability requirement, distributed power system (DPS) is widely adopted for telecom and computer systems, because …

    vt Repository record for Investigation of High-density Integrated Solution for AC/DC Conversion of a Distributed Power System (opens in a new tab)

  7. Modelling a distributed power system in Saber® - Focused on power conversion, cable characteristics and usability of Saber® for Saab microwave systems

    … Inc, and to design a model of an airborne distributed power system. By building a simple system from hardware measurements and model it a good start of the project was made, and thereby learning the basics of Saber®. The design was later expanded to be similar to the next generation of …

    chalmers Repository record for Modelling a distributed power system in Saber® - Focused on power conversion, cable characteristics and usability of Saber® for Saab microwave systems (opens in a new tab)

  8. New Techniques in the Design of Distributed Power Systems

    Power conversion system design issues are expanding their role in information technology equipment design philosophies. These issues include not only improving power conversion efficiency, but also increased concerns regarding the cost and complexity of the power conversion design techniques …

    vt Repository record for New Techniques in the Design of Distributed Power Systems (opens in a new tab)

  9. Stability of distributed power supply systems

    A comprehensive stability analysis of a distributed power system (DPS) is performed. The possible performance degradation and stability problems caused by the loading effect of cascaded converters are analyzed. The effect of impedance overlap on the system and individual subsystems is examined. By …

    vt Repository record for Stability of distributed power supply systems (opens in a new tab)

  10. Modeling, Control and Stability Analysis of a PEBB Based DC Distribution Power System

    Power Electronic Building Block (PEBB) concept is to provide generic building blocks for power conversion, regulation and distribution with control intelligence and autonomy. A comprehensive modeling and analysis of a PEBB based DC distributed power system (DPS), comprising of a front end power …

    vt Repository record for Modeling, Control and Stability Analysis of a PEBB Based DC Distribution Power System (opens in a new tab)

  11. Motors Fault Recognition Using Distributed Current Signature Analysis

    … signals is one of the important interests of the power industry. Motor current signature analysis is a modern approach to diagnose faults of induction motors. This thesis investigates the significance of propagated fault signatures through distributed power systems, aiming at explaining and …

    auckland-tech Repository record for Motors Fault Recognition Using Distributed Current Signature Analysis (opens in a new tab)

  12. STATE OF CHARGE BALANCING DROOP CONTROL

    … presents a load sharing method applied in a distributed micro grid system. The goal of this method is to balance the state-of-charge (SoC) of each parallel connected battery and make it possible to detect the average SoC of the system by measuring bus voltage for all connected modules. In …

    mtu Repository record for STATE OF CHARGE BALANCING DROOP CONTROL (opens in a new tab)

  13. Small-Scale Microgrid Energy Market Based on PILT-DAO

    With the installed capacities of Distributed Generations (DGs) dramatically increasing in power systems from Distributed Energy Resources (DERs) such as hydropower, wind, solar, geothermal and biomass, the operation methods of DERs tradings or transactions become more and more complicated. However, …

    denver Repository record for Small-Scale Microgrid Energy Market Based on PILT-DAO (opens in a new tab)

  14. Distributed Control, Optimization, and State Estimation for Renewable Power System

    The traditional power systems are usually centralized systems, in which the control, operation and monitoring are performed by the centralized control center, e.g., SCADA. However, with the development of renewable energy, power systems are getting more and more distributed. So, it becomes …

    denver Repository record for Distributed Control, Optimization, and State Estimation for Renewable Power System (opens in a new tab)

  15. Digital Control for Power Factor Correction

    … and improvement of a digital controller for a power factor correction (PFC) converter. The development of the telecommunications industry and the Internet demands reliable, cost-effective and intelligent power. Nowadays, the telecommunication power systems have output current of up to several …

    vt Repository record for Digital Control for Power Factor Correction (opens in a new tab)

  16. Foresight into emerging power system architectures, A scenario of maximised self-consumption in Sweden

    … a future scenario with an increasingly distributed power system in Sweden, in order to add to the discussion on possible and desirable development paths for the Swedish energy system. A household completely self-sufficient in electricity and heating is visualised and its economic and …

    chalmers Repository record for Foresight into emerging power system architectures, A scenario of maximised self-consumption in Sweden (opens in a new tab)

  17. Design and Implementation of High Efficiency, High Power Density Front-End Converter for High Voltage Capacitor Charger

    Pulse power system is widely used for medical, industrial and military applications. The operational principle of the pulse power system is that the energy from the input source is stored in the capacitor bank or superconducting inductive device through a dc-dc converter. Then, when a discharging …

    vt Repository record for Design and Implementation of High Efficiency, High Power Density Front-End Converter for High Voltage Capacitor Charger (opens in a new tab)

  18. Nonlinear system identification and control using a neural network approach

    … multi-layer perceptrons (MLPs) for a complex system are presented. The quasi-linear system to be controlled is both unstable and nonlinear. The complete nonlinear feedback control system is designed without a priori information of the plant dynamics, using only measured input/output data. The …

    vt Repository record for Nonlinear system identification and control using a neural network approach (opens in a new tab)

  19. Implementation of a 100kW Soft-Switched DC Bus Regulator Based on Power Electronics Building Block Concept

    Power electronics building blocks (PEBBs) are standardized building blocks used to integrate power electronics systems. The PEBB approach can achieve low cost, high redundancy, high reliability, high flexibility and easy maintenance for large-scale power electronics systems. This thesis presents …

    vt Repository record for Implementation of a 100kW Soft-Switched DC Bus Regulator Based on Power Electronics Building Block Concept (opens in a new tab)

  20. Equivalent Circuit Model of High Frequency PWM and Resonant Converters

    Distributed power system (DPS) is widely adopted in Power supplies for the telecom, computer and network applications. Constant on-time current mode control and V2 control are widely used as point-of-load (POL) converters and voltage regulators (VR) in DPS systems. Series resonant converters (SRC) …

    vt Repository record for Equivalent Circuit Model of High Frequency PWM and Resonant Converters (opens in a new tab)

Page 1 of 2