Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 49 for “"Drawbar"”.
-
Drawbar Eye Identification and Guiding
… mounted on the back of a truck to detect a drawbar eye under varying environmental, instrumental and lightning conditions. In order to achieve this, lab based and real world testing data was collected from a setup which simulated connecting a truck and a trailer. With these setup cases, …
-
Prediction of Tractor Drawbar Pull on Agricultural Soils
A new method of predicting the drawbar pull developed by agricultural tractors was designed and evaluated. A single wheel tester, similar to a rear tire of a tractor, was used to establish topsoil traction conditions by loading it with known loads and measuring the maximum transferable torque. This …
-
The effect of drawbar load and tire inflation on soil-tire interface pressure
Thesis (M.S.)--Michigan State University of Agriculture and Applied Science. Department of Agricultural Engineering, 1959
-
A Comparative Evaluation of Rear Tire Configuration on a Front Wheel Drive Assist Tractor
… tractor in three tractive conditions and at two drawbar load ranges. Tests results indicated that, single rear tires were capable of pulling a heavier load with higher fuel efficiency at every combination of tractive condition and drawbar load except in the loose tractive condition at the high …
-
Experimental Analysis of the Effects of the Variation of Drawbar Pull Test Parameters for Exploration Vehicles on GRC-1 Lunar Soil Simulant
A drawbar pull (DP) test procedure was developed at the NASA Glenn Research Center (GRC) for testing and developing designs for off-road vehicles. The motivation was to develop a procedure that would produce repeatable results and could be replicated by other researchers. While developing the test …
-
Tractive performance of high-horsepower wheeled tractors with low tire inflation pressures
… the minimum and the maximum of ballast. The drawbar pull produced by the tractor was measured by a drawbar pin load cell, while the axle torques were measured by means of strain gauges on their output shafts (bar axle), the tire deflections were measured by ultrasonic distance sensors mounted …
-
Tractive performance of integrated steering-drive systems
… input and power output to produce values for drawbar efficiency. theoretical analysis was conducted into the optimal slip conditions for maximum tractive efficiency. The analysis was conducted using a more rigorous mathematical analysis than previous researchers and used a thorough graphical …
-
Fiber optic interferometric torque sensor with applications to milling
… components mounted on the milling machine's drawbar. Before the drawbar sensor could be mounted on to the milling machine the laser diode source was damaged. Using the results of the tests performed on the bench top sensor and the drawbar sensor, the milling machine sensor was predicted to …
-
Experimental Evaluation and Semi-Empirical Modeling of the Tractive Performance of Rigid and Flexible Wheels on Lunar Soil Simulant
… contact length. For each test the normal load, drawbar pull, and driving torque were measured and recorded for further analysis. To measure the effect of the changes in the wheels' parameters on the contact patch under different loads, a pressure pad was embedded below the surface of the Lunar …
-
Comparative Study of the Effect of Tread Rubber Compound on Tire Performance on Ice
… the effects of the tread rubber compound on the drawbar pull performance of tires in contact with an ice layer near its melting point. A set of sixteen tires of eight different rubber compounds were considered. The tires were identical in design and tread patterns but have different tread rubber …
-
Tractor instrumentation for monitoring energy inputs to implements
… slip, fuel consumption per unit time and area, drawbar horsepower, axle horsepower, tractive efficiency, and implement energy requirement per unit area could be subsequently computed from these measurements.</p> <p>The data acquisition system was installed on a 2675 Massey- Ferguson (two-wheel …
-
Methodology for evaluating vehicle fatigue life and durability
… the HMT experiences a fatigue failure of the drawbar. For this analysis, experimental data was taken from a HMT traveling over known test courses. The data was used to validate a computer simulation, and to determine the feasibility of life consumption monitoring. Multivariate regressions and …
-
An instrumentation system for measuring tractor field performance
… fuel flow, travel speed, wheel rotational speed, drawbar pull, and rear axle torque. The data acquisition system included an interface board, an AIM 65 microcomputer and a digital cassette recorder (Techtran 817). The microcomputer program was developed with an assembly language so that the system …
-
Determining the effects of tire pressure and soil condition on the Brixius equations for predicting net tractive force
… soil condition, and ballasting. The actual drawbar pull produced by the tractor was measured by a load cell, while the deflection of the tire was found by ultrasonic distance sensors mounted inside the rim of the driving tires. A separate tractor was used to load the test tractor, which …
-
Effects of Calcium Based Surface Amendments on Hydraulic Conductivity and Selected Physical Properties of Subsurface Drained Sodic Soils
… changes in hydraulic properties. Lastly, a drawbar dynamometer was used to measure draft on a chisel plow as it was pulled across the plots by a tractor equipped with an auto-guidance system and instrumentation interfaced with the controller area network of the tractor. The results show that …
Page 1 of 3