Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 53 for “"Driven Piles"”.
-
Driven piles in central Texas expansive soils
… that is under utilized in this application, driven piles. The main objective of the study is to present pile test results and analysis from four driven pile project sites in three types of expansive soils found in central Texas: Del Rio formation, Taylor/Navarro formation, and expansive …
-
Ground heave around driven piles in clay
Large diameter piles have increasingly been used, especially for offshore foundations. Most of the piles that have been used offshore have been open-ended. There is evidence from previous work that closed-ended piles have merits over open-ended piles; they have a greater ultimate axial capacity and …
-
The axial capacity of driven piles in clay
… the fundamental behaviour in clay soils of driven cylindrical steel piles used for offshore structures. Four test-bed sites were chosen; two in stiff heavily consolidated clays, and two in normally/lightly overconsolidated clays. Data from these sites confirm that a residual shear surface is …
-
Predicting the ultimate axial resistance of single driven piles
… the ultimate side resistance of single driven piles were evaluated against the uplift tests compiled from the archives of the California Department of Transportation (Caltrans). These methods included methods based on standard penetration tests (SPT), laboratory tests, electric cone …
-
System reliability for bridge bent foundations on driven piles
Modern day bridge foundations are often designed for the maximum loading condition on a single member and each following foundation member often follows the same design. A 4-pile and a 2-pile foundation system were analyzed with an upperbound plasticity model in an attempt to approximately …
-
Reliability-Based Design and Acceptance Protocol for Driven Piles
… Highway Construction Manuals (2003, 2014) for driven pile foundations faces various limitations which result in designs of questionable reliability. These specifications are based on the Allowable Stress Design method (ASD), cover a wide range of uncertainties, do not take into account pile and …
-
Shaft Resistance of Driven Piles in Overconsolidated Cohesionless Soils
Piles are structural members that transfer the applied load of superstructures to deep supportive layers of soil or bedrock. Besides controlling the settlement of structures, piles provide sufficient capacity that other foundations cannot provide or provide only at a high cost. Despite ample …
-
Insitu stresses and capacity of driven piles in sand
… Pile foundations can be categorized as bored and driven piles. Bored piles installed in sand are known to provide relatively low capacity as compared to driven piles under the same condition. This is due the effect of the pile driving process. The estimation of the shaft resistance of driven piles …
-
Pile Setup Effects on Driven Piles In Southeastern Coastal States
The resistance of driven piles typically increases with time after installation, a phenomenon known as pile setup. This behavior is primarily associated with the dissipation of excess porewater pressure and the progressive reconsolidation of soil surrounding the pile shaft, particularly it is …
-
Case pile wave equation analysis: CAPWAPC. Evaluation of driven piles.
… is the bearing capacity of the individual piles. Correct quantitative evaluation of the pile capacity during pile driving requires the use of dynamic monitoring by means of the Pile Driving Analyzer. These monitoring data are combined with a wave equation analysis and processed using a …
-
Elastic analysis of axial load-displacement behavior of single driven piles
… the applied loads. Load-displacement behavior of piles is considered secondary to the axial capacity; displacements are ordinarily overlooked or not calculated if and when the estimated pile capacity is two to three times the design or expected loading. However, in cases, such as long piles or …
-
The influence of state on the capacity of driven piles in sands
… study the influence of state on the capacity of driven piles in sand. The work was prompted by findings of recent laboratory based research on the mechanics of granular soils (Coop & Lee, 1993 and Jovicic & Coop, 1997) which showed that, as for clays, a principal controlling factor of soil …
-
Calibration of Resistance Factors for Driven Piles using Static and Dynamic Tests
… factors, while the level of reliability is driven by the amount of risk an owner is willing to take and is quantified by the reliability index. The load factors are defined through structural design codes, but the resistance factors have uncertainties that can be mitigated through …
-
Full-Scale Testing of Blast-Induced Liquefaction Downdrag on Driven Piles in Sand
Deep foundations such as driven piles are often used to bypass liquefiable layers of soil and bear on more competent strata. When liquefaction occurs, the skin friction around the deep foundation goes to zero in the liquefiable layer. As the pore pressures dissipate, the soil settles. As the soil …
-
Load tests and numerical modeling of CFA and driven piles in marl in Savannah, Georgia
… using load-transfer (t-z and Q-z) method for driven and Continuous Flight Auger (CFA) piles. For CPT-based pile resistance estimations, the accuracy of the original LCPC and Eslami and Fellenius methods was first evaluated. Pile load test results were then used to back-calculate the …
-
Field Instrumentation and Testing to Study Set-up Phenomenon of Driven Piles and Its Implementation in LRFD Design Methodology
… number of twelve prestressed concrete (PSC) test piles were driven in different soil conditions of Louisiana. In addition, dynamic load tests (DLT) and static load tests (SLT) were usually performed to verify the axial resistances of piles at specific times after EOD, as well as to quantify the …
-
Estimation of the Axial and Lateral Capacity of Driven Piles from the Results of Cone Penetration Test and Finite Element Analysis
Piles play an important role in transportation and bridges. They are used to resist axial and lateral loads transferred to them from structures, earth pressures, incline loads, vehicles, etc. In this study, the capacity of piles for axial and lateral loads is investigated. The ultimate axial …
-
Establishment of a suitable dynamic formula for the construction control of driven piles and its calibration for Load and Resistance Factor Design
… factors for the construction control of driven pile foundations via a suitable dynamic pile driving formula.</p> <p>Using data from pile load tests performed in the State of Iowa, which was analyzed for reliability and placed in a newly designed relational database management system …
-
Análise do comportamento carga recalque e metodologias de controle na implantação de estacas cravadas
… for the control in situ of the behavior of the driven piles, as well as the presentation of other procedures which will allow safer and more suitable analyses. First, the fundamentals of the Wave Equation Analysis are presented and the main relevant points of its application to the problem of …
Page 1 of 3