Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 22 for “"Effective friction angle"”.
-
Efeito do teor de finos nos parâmetros de estados críticos de solos transicionais
… For the undrained triaxial tests were performed. Effective compressive stresses of 50 kPa, 100 kPa, and 200 kPa were used for the undrained triaxial tests. It was found that the critical state line was not unique for the tested compounds. The threshold value for the fineness determined using the …
-
NUMERICAL STUDY OF CONE PENETRATION TEST IN CLAYS USING PRESS-REPLACE METHOD
… easy-to-use theoretical relationships for the effective friction angle, overconsolidation ratio, undrained shear strength and horizontal permeability of soft clays are still limited. A simplified numerical technique to model a deep penetration process, the press-replace method (PRM), is used to …
-
GEOTECHNICAL PROPERTIES OF COMPOST AMENDED TOPSOILS FOR USE ON HIGHWAY SLOPES
… Compost addition resulted in an increase in effective friction angle, whereas modest changes were observed in effective cohesion, total cohesion and total friction angle of topsoil. No significant change was observed on factors of safety of highway slopes by compost treatment, under both …
-
Postcyclic behavior of low-plasticity silt
… triaxial tests were conducted to determine the effective friction angle, critical state line, and normalized behavior. Then specimens were subjected to cyclic loading to develop the liquefaction curve. After full liquefaction, excess pore pressure was dissipated until various reconsolidation …
-
Feasibility of Additive Manufactured Materials for Use in Geotechnical Laboratory Testing Applications
… with granular material is known as the effective friction angle (φ’). For a dense granular assemblage, the peak friction angle has been described as being comprised of a dilatant friction angle (φ’d) component and a critical state friction angle (φ’cv) component. While the topic of …
-
Evaluation of SHANSEP parameters and initial-shear-stress induced strength anisotropy of a lagoonal deposit near Keʻehi Interchange, Honolulu, Hawaiʻi
… CKoUDSS in between. If Su = qcosϕ' (where ϕ' = effective friction angle), the CKoUC and CKoUE curves shift downwards, resulting in the CKoUDSS curve almost coinciding with the CKoUC curve. The effective friction angles ϕ' were approximately 40o and 26o for the normally and overconsolidated …
-
Development and verification of a miniature cone penetration test
… The assessment of tip resistance and sleeve friction in the Ottawa sand MCPTs were used to identify a functional depth of penetration whereby the friction sleeve was fully mobilized. Values of tip resistance and sleeve friction obtained from the MCPT at these depths of penetration were taken …
-
Testing and constitutive modeling of cemented soils.
… with the degree of cementation of the soil. The effective friction angles measured for cemented sands with various cementation levels are in the same ranges as the effective friction angle evaluated for uncemented sands. Moreover, failure modes of the material varies from brittle to ductile …
-
Stone Columns in Extremely Soft Soils in Scandinavia
… than the natural soil. This enables them to effectively support the structure or embankment without significantly altering the physical state of the surrounding soil, as well as improve the drainage. The research aims to examine whether stone columns can be used in the soft clays typical to …
-
Effective stress strength of clays evaluated from piezocone and flat dilatometer tests
… strength of clays is really governed by effective stress conditions, specifically the effective stress friction angle (f') which is required for stress path analyses, critical state soil mechanics (CSSM), and the prediction of pore pressures during construction using finite element …
-
Evaluation of Uncertainty for Soil Water Characteristic Curve Measurements and Implications for Predicting the Hydro-mechanical Behavior of Unsaturated Soils
… the use of saturated soil parameters, including effective stress, effective cohesion, and effective friction angle. The use of unsaturated soils in design would be less conservative, but could lead to savings. Unsaturated soil mechanics also involves additional stress state variables net normal …
-
Mechanical behaviour of a type of iron ore fines subjected to distinct effective stress paths under triaxial compression conditions
… the response of an iron ore under different effective stress paths in triaxial compression. The main objective is to characterize the material’s stress-strain behaviour, determine its shear strength parameters and failure envelope, and interpret its response within the framework of Critical …
-
Analysis of Slope Failure on Cochrane Road, Dominica Prior to Hurricane Maria
… that have roads cutting into slopes at the angle of repose. The roads are often buried and damaged by material from slope failures. The selected slope failure sites are located along a ½ mile section of road and share similar climate, associated soil types, and topographic setting. The two …
-
Three-dimensional static and dynamic behavior of kaolin clay with controlled microfabric using combined axial-torsional testing
… with a constant principal stress rotation angle (/J) under undrained conditions. Typical test results for both types of microfabric, such as effective friction angle, undrained shear strength, stress-strain relationship, pore pressure evolution, and stress paths are presented as a function …
-
Interface Behavior of Water Saturated Limestone Rock Joints Using Hollow Cylinder Testing and A Case History Regarding Mine Roof Stability: Fort Hartford Mine Superfund Site
… fluid pressures of 0.14 MPa to 0.55 MPa and effective joint normal stresses of 0.16 MPa to 0.65 MPa. Mohr-Coulomb failure criterion was used to interpret a joint effective friction angle for the Holston Limestone and the results were within the range of friction angle values given in …
-
Time-dependent slope stability of temporary excavations in soft clay: A numerical study of the undrained to drained transition using combined analysis
… which a combined analysis should be applied. The effective friction angle was identified as the most critical parameter for stability throughout the consolidation period, while the Young’s modulus and permeability governs the rate of transition. The results further show that a traditional combined …
-
Undrained, monotonic shear strength of loose, saturated sand treated with a thixotropic bentonite suspension for soil improvement
… order to determine its feasibility for use as an effective method for liquefaction mitigation. The permeation of engineered bentonite suspensions is proposed as a passive site remediation technique. Thus, the suspensions were delivered to loose Ottawa sand specimens in the laboratory by permeation …
-
Η συμπεριφορά των μαργαϊκών γεωυλικών και των υλικών του αποδομημένου φλύσχη στην εκδήλωση εκτεταμένων κατολισθήσεων
… showed (a) a significant reduction of the effective friction angle with an increase of moisture content, (b) a significant effect of density on the shear strength in wet and dry conditions, (c) dilatancy effects in the dense state, (d) almost identical values of the effective angle in …
-
A constitutive model for fiber-reinforced soils
… fiber-reinforced soils. Results showed that the effective friction angle and cohesion intercept increased significantly in consolidated undrained CU) and consolidated-drained (CD) triaxial compression tests for both fiber-reinforced silty sand and Ottawa sand. The shear strength parameters of …
-
Identification of the Microfabric of Kaolin Clay and its Impact on the Shear Strength Behavior
… significantly higher values of shear strength, effective friction angle, volumetric deformation, and axial strain at failure conditions in comparison to the corresponding values obtained for the poor and intermediate drainage conditions. Using improved drainage conditions, a series of triaxial …
Page 1 of 2