Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 13 of 13 for “"Electromagnetic Shaker"”.

  1. Damage accumulation of bovine bone under variable amplitude loads.

    … is predictive of fatigue failure in bone. An electromagnetic shaker apparatus was constructed to conduct cyclic and variable amplitude tests on bovine bone specimens. Three distinct damage regimes were observed following fracture. Fractures appeared ductile from low cyclic amplitude (< 4,000 …

    baylor Repository record for Damage accumulation of bovine bone under variable amplitude loads. (opens in a new tab)

  2. Experimental investigation of nonlinear coupled vibrations of columns

    … using a vibration control generator and an electromagnetic shaker. The experimental results were in good agreement with the theoretical predictions. Coupled longitudinal vibrations exhibiting a frequency ratio of 1:2 were observed. Coupled flexural oscillations were also observed, though a …

    ubc Repository record for Experimental investigation of nonlinear coupled vibrations of columns (opens in a new tab) Download PDF for Experimental investigation of nonlinear coupled vibrations of columns (opens in a new tab)

  3. Infrared measurements of surface temperatures during oscillating/fretting contact with ceramics

    … against a vibrating sapphire disk driven by an electromagnetic shaker. Ceramic materials including zirconium oxide, sapphire, aluminum oxide, and tungsten carbide were used as test specimens since they are inert in air, and generate high surface temperatures when used in the oscillating contact …

    vt Repository record for Infrared measurements of surface temperatures during oscillating/fretting contact with ceramics (opens in a new tab)

  4. Reduction of void content in laminated composites by mechanical vibrations

    … these observations. After initial stage where electromagnetic shaker was introduced to the curing system, special apparatus (based on the Quickstep method) was built to 'explore suitable frequency range of vibrations for curing at elevated temperatures, supported with vacuum pump. Numerous …

    anu Repository record for Reduction of void content in laminated composites by mechanical vibrations (opens in a new tab)

  5. Experimental identification of structural force coefficients in a bump-type foil bearing

    … a rigid shaft support structure and a suspended electromagnetic shaker. Dynamic load (from 13 N to 31 N) test results show that the test foil bearing stiffness increases by as much as 50% with amplitude of dynamic load above a lightly loaded region, nearly doubles with frequency up to 200 Hz, and …

    tamu Repository record for Experimental identification of structural force coefficients in a bump-type foil bearing (opens in a new tab)

  6. Vibration Suppression Using Smart Materials in the Presence of Temperature Changes

    … can be excited in various frequencies with an electromagnetic shaker. To simulate temperature fluctuations the temperature on the panel can be increased up to 65°C (150°F). Smart material based sensors and actuators are used to interface the mechanical system with the electronic controller. The …

    vt Repository record for Vibration Suppression Using Smart Materials in the Presence of Temperature Changes (opens in a new tab)

  7. Fundamental studies of the tribological behavior of thin polymeric coatings in fretting contact using infrared and photo/video techniques

    … against a vibrating sapphire disk driven by an electromagnetic shaker. Surface temperatures generated by frictional heating were measured during fretting contact using an infrared microscope. A photo/video technique was developed to view the fretting contact interface during an experiment and to …

    vt Repository record for Fundamental studies of the tribological behavior of thin polymeric coatings in fretting contact using infrared and photo/video techniques (opens in a new tab)

  8. A Comprehensive Experimental Evaluation of Actively Controlled Piezoceramics with Positive Posistion Feedback for Structural Damping

    … the plate in various frequency ranges with an electromagnetic shaker. For each test, a data acquisition system was used to acquire the data to evaluate the performance of each PPF controller. Once the data was obtained, a comparison was made between active damping with PPF and passive damping …

    vt Repository record for A Comprehensive Experimental Evaluation of Actively Controlled Piezoceramics with Positive Posistion Feedback for Structural Damping (opens in a new tab)

  9. The contribution of non-structrual components to the overall dynamic behaviour of concrete floor slabs

    … slab is described. Testing was performed using electromagnetic shaker, instrumented hammer, heeldrop, and walking excitations, to determine full floor dynamic characteristics. The tests investigated the effect on vibration performance of the level of prestress, and of various non-structural …

    oxford Repository record for The contribution of non-structrual components to the overall dynamic behaviour of concrete floor slabs (opens in a new tab)

  10. Active vibration control for a free piston stirling engine with linear alternator FPSE/LA

    … and the suitable control strategies using an electromagnetic actuator, namely a linear voice coil motor (VCM). Starting with a validated vibration model of the engine based on two degrees of freedom system (2-DOF), two control techniques, Feedforward/Zero-Placement control with …

    northampton Repository record for Active vibration control for a free piston stirling engine with linear alternator FPSE/LA (opens in a new tab) Download PDF for Active vibration control for a free piston stirling engine with linear alternator FPSE/LA (opens in a new tab)

  11. An experimental method to observe repetitive bubble jet collapse

    … up uses an acrylic test chamber mounted on an electromagnetic shaker with variable driving frequency near 60 Hz and amplitude of up to 2 mm peak. The atmospheric pressure in the test chamber is reduced between -26 and -30 in.-hg with a vacuum pump to decouple shape and volume oscillations of …

    bu Repository record for An experimental method to observe repetitive bubble jet collapse (opens in a new tab)

  12. Návrh elektromagnetického laboratorního vibrátoru

    Ve svojí diplomové práci řeším návrh elektromagnetického laboratorního vibrátoru, který bude sloužit pro testování vibračních mikrogenerátorů. V první části práce se je vypracována rešerše vybraných vibračních zařízení. Dále je zde vypracován vlastní návrh rozměrů a naladění požadovaných vlastností …

    brno-tech Repository record for Návrh elektromagnetického laboratorního vibrátoru (opens in a new tab)

  13. Pipe detection and remote condition monitoring using an in-pipe excitation technique

    … between a standard electroacoustic device, an electromagnetic shaker, and the pneumatic ones is made. From the previous work on characterization of wave propagation along plastic water filled pipes, it is known that at below 100 Hz, among all kinds of waves, the axisymmetric fluid borne wave …

    soton Download PDF for Pipe detection and remote condition monitoring using an in-pipe excitation technique (opens in a new tab)