Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 8 of 8 for “"End slip"”.

  1. An investigation of the variables affecting the transfer length of prestressed concrete members

    … stress, surface condition of the strand, initial end slip of the strand, concrete strength, and concrete consolidation around the strand was investigated. Relationships were then developed and compared with prediction equations from previous research.</p> <p>The major contributing factors …

    ut-knoxville Repository record for An investigation of the variables affecting the transfer length of prestressed concrete members (opens in a new tab)

  2. Development length of prestressing strand

    … beams were tested for transfer length and strand end slip at transfer and for development length in static destructive tests. Additionally, transfer length in prestressed concrete prisms and pullout behavior of non-prestressed strands in concrete prisms were obtained. A comprehensive review of …

    utk-theses Repository record for Development length of prestressing strand (opens in a new tab)

  3. The time-dependent response of concrete bond to steel under high sustained loads

    … RC beams tested in flexure showed the beams' tendency to increase in deflection with time--more than the expected creep deflection. This extra deflection occurring at high sustained loading may be accounted for by slippage between the reinforcing bar and the concrete. In order to isolate and …

    missouri Repository record for The time-dependent response of concrete bond to steel under high sustained loads (opens in a new tab)

  4. Measurement of Transfer and Development Lengths of 0.7 in. Strands on Pretensioned Concrete Elements

    … Average Maximum Strain method. Initial strand end-slips were also measured for predicting transfer length at release using an empirical formula. The development lengths were determined by conducting bending tests with different embedment lengths. Experimental results indicated ACI 318 and …

    arkansas Repository record for Measurement of Transfer and Development Lengths of 0.7 in. Strands on Pretensioned Concrete Elements (opens in a new tab)

  5. An investigation of bond-slip behavior of reinforcing steel subjected to inelastic strains

    <p>Longitudinal bar slip resulting from strain penetration at the end of flexural concrete members will result in a member end rotation and additional lateral deformations in members such as walls, columns and beams. The contribution of these member end rotations can account for as much as 35 …

    iastate Repository record for An investigation of bond-slip behavior of reinforcing steel subjected to inelastic strains (opens in a new tab)

  6. Evaluation of Different Techniques for Repair of Shear-span Corrosion-Damaged RC Beams

    … ratio, the degree of corrosion and the anchorage end condition and repair schemes. Two span to depth (a/d) ratios were considered: a/d=3.4 with one-point loading and a/d=2.4 with two-point loading. Two anchorage end-conditions were used: bonded or un-bonded reinforcement in the an-chorage zone. …

    waterloo Repository record for Evaluation of Different Techniques for Repair of Shear-span Corrosion-Damaged RC Beams (opens in a new tab)

  7. Confined concrete behavior in hollow columns

    … relationship between strand stress and loaded-end slip was developed and several design recommendations have been made regarding the use of unstressed strands for connection reinforcement of precast concrete members.</p>

    iastate Repository record for Confined concrete behavior in hollow columns (opens in a new tab)

  8. Structural behaviour of CLT-concrete composite floors under service conditions

    … These results were achieved through 4-point bending tests on CLT strips, 48-hour compressive creep tests on CLT prisms, oven-dry tests on CLT blocks, tensile tests on reinforcing steel bars, as well as compression and splitting tests on concrete cylinders. The moisture gauge was calibrated by …

    unsw Repository record for Structural behaviour of CLT-concrete composite floors under service conditions (opens in a new tab)