Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 471 for “"Energy model"”.

  1. Tyre Library for Vehicle Energy Model

    … fuel consumption motivates research towards energy loss due to tyre components. Performing tyre tests to determine the nature of these losses for every scenario may turn out to be expensive. Magic tyre formula is widely accepted to give comparable results to real world but the model is not …

    chalmers Repository record for Tyre Library for Vehicle Energy Model (opens in a new tab)

  2. An energy model for rock slope stability analysis

    … produce potential failures which cannot be modeled as either plane or wedge slides. In these slopes the sliding of blocks may occur along non-planar surfaces. Standard rock stability analysis methods presently available are not adequate to treat these folded rock slopes. For this reason, a …

    ut-knoxville Repository record for An energy model for rock slope stability analysis (opens in a new tab)

  3. Building Energy Model Calibration for Retrofit Decision Making

    Accommodating the continued increase in energy demand in the face of global climate change has been a worldwide concern. With buildings in the US consuming nearly 40% of national energy, a concerted effort must be given to reduce building energy consumption. As new buildings continue to improve …

    portland-state Repository record for Building Energy Model Calibration for Retrofit Decision Making (opens in a new tab)

  4. A dynamic physical energy model of the United Kingdom

    … and simulation results of a dynamic physical model of the UK energy system. The model traces the hourly flows of energy from energy sources through various energy converters and stores to useful energy demands. Effects such as the temporal and climatic dependence of demands have been accounted …

    the-open-u Download PDF for A dynamic physical energy model of the United Kingdom (opens in a new tab)

  5. DETERMINING MEASUREMENT REQUIREMENTS FOR WHOLE BUILDING ENERGY MODEL CALIBRATION

    Energy retrofits of existing buildings reduce grid requirements for new generation and reduce greenhouse gas emissions. However, it is difficult to estimate energy savings, both at the individual building and entire building stock level, because building energy models are poorly calibrated to …

    maryland Repository record for DETERMINING MEASUREMENT REQUIREMENTS FOR WHOLE BUILDING ENERGY MODEL CALIBRATION (opens in a new tab)

  6. Development and verification of a simplified building energy model

    … a simplified and concise building simulation model suitable for high-level applications such as preliminary design or for embedding into adaptive control systems. An actual complex modern building and its energy system has been monitored. The monitored energy performance of this building has …

    gatech Repository record for Development and verification of a simplified building energy model (opens in a new tab)

  7. A Long-Range Energy Model Aimed to Maximize Utility

    Made available in DSpace on 2017-07-06T18:55:11Z (GMT). No. of bitstreams: 3 Luo_Jianding_MS.pdf: 38517059 bytes, checksum: f30acef3deccbd1e9315466a85aa4750 (MD5) Luo_Jianding_MS_ABS.pdf: 460590 bytes, checksum: d5edbdb7d9ed45d15af3ae6f01de992d (MD5) license.txt: 4813 bytes, checksum: …

    uiuc Repository record for A Long-Range Energy Model Aimed to Maximize Utility (opens in a new tab)

  8. A Reduced Data Dynamic Energy Model of the UK Houses

    … the development of a Reduced Data Dynamic Energy Model (RdDEM) for simulating the energy performance of UK houses. The vast quantity of Energy Performance Certificate (EPC) data stored at the national scale provides an unprecedented data source for energy modelling. The majority of domestic …

    cent-lancashire Download PDF for A Reduced Data Dynamic Energy Model of the UK Houses (opens in a new tab)

  9. An improved instruction-level power and energy model for RISC microprocessors

    Recently, the power and energy consumed by a chip has become a primary design constraint for embedded systems and is largely aaffected by software. Because aims vary with the application domain, the best program is sometimes the most power or energy efficient one rather than the fastest. However, …

    soton Download PDF for An improved instruction-level power and energy model for RISC microprocessors (opens in a new tab)

  10. Building Energy Model Generation Using a Digital Photogrammetry-Based 3D Model

    Buildings consume a large amount of energy and environmental resources. At the same time, current practices for whole-building energy simulation are costly and require skilled labor. As Building Energy Modeling (BEM) and simulations are becoming increasingly important, there is a growing need to …

    tamu Repository record for Building Energy Model Generation Using a Digital Photogrammetry-Based 3D Model (opens in a new tab)

  11. Uncertainty quantification of building energy model that assume ideal temperature control

    … to investigate discrepancies between predicted energy performance of buildings and their actual measured energy use. Based on prior uncertainty quantification studies, there is evidence that there remain unquantified uncertainties related to the HVAC system. Most current studies of HVAC system …

    gatech Repository record for Uncertainty quantification of building energy model that assume ideal temperature control (opens in a new tab)

  12. Hysteresis phenomena of ferromagnetic bodies using the nonlocal exchange energy model

    … ferromagnetic bodies using the nonlocal exchange energy model. We show that the model possesses a wide range of phenomena including hysteresis, hysteresis subloops, Barkhausen effect, and demagnetization. The results are in three parts. First, we examine analytically the problem of a unit sphere …

    vt Repository record for Hysteresis phenomena of ferromagnetic bodies using the nonlocal exchange energy model (opens in a new tab)

  13. An Automated Building Energy Model Calibration Workflow to Improve Indoor Climate Controls

    Calibrating a white-box building energy model (BEM) is time-consuming and prohibitively expensive due to the large number of required model inputs and the limited availability of measurements. Therefore, this research aims to increase the calibration efficiency by proposing an improved workflow to …

    carleton Repository record for An Automated Building Energy Model Calibration Workflow to Improve Indoor Climate Controls (opens in a new tab)

  14. IMPACT OF ELA CALIBRATION METHODS ON BUILDING ENERGY MODEL FIDELITY AND FITNESS

    … is increasingly improved and building energy consumption decreases, a greater percentage of the total energy loss of a building occurs through envelope leakage. This leakage is characterized by the effective leakage area or ELA, which is a proxy parameter to what is essentially a …

    gatech Repository record for IMPACT OF ELA CALIBRATION METHODS ON BUILDING ENERGY MODEL FIDELITY AND FITNESS (opens in a new tab)

  15. Cross layer energy model of IR-UWB for short-range communication systems

    … The Open System Interconnection reference model is devoted to describe the abstraction levels in layers with their components, known as OSI layers. The power profiles of the first and second levels (PHY and MAC) for data communication are among the main concerns of this work. The PHY level …

    brazil-ufrgs Repository record for Cross layer energy model of IR-UWB for short-range communication systems (opens in a new tab)

  16. Development of Multi-Scale City Building Energy Model for Urban Climate Resilience

    … increasing climate change challenges, pollution, energy consumption, and greenhouse gas (GHG) emission. More frequent and more prolonged extreme weather events such as heatwave and cold-wave and urban heat island phenomena are some negative impacts of climate change. The building sector is an …

    concordia Download PDF for Development of Multi-Scale City Building Energy Model for Urban Climate Resilience (opens in a new tab)

  17. Development of a techno-economic energy model for low carbon business parks

    … of greenhouse gas emissions and primary energy consumption and for the integration of renewable energy. Carbon dioxide emissions from fossil fuel combustion in the industry and energy sectors account for a major share of greenhouse gas emissions. Hence, a low carbon shift in industrial …

    ghent Repository record for Development of a techno-economic energy model for low carbon business parks (opens in a new tab)

Page 1 of 24