Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 80 for “"Excess air"”.
-
Development of Cookstove Emissions and Performance Testing Suite with Time-resolved Particulate Matter Analysis and Excess Air Estimation
… million premature deaths annually due to indoor air pollution, and contributes significantly to global greenhouse gas emissions and deforestation. The majority of biomass combustion for cooking and heating is done with rudimentary stoves which are inefficient and produce harmful emissions. …
-
A mathematical investigation of the effect of tube spacing, excess air, and bridgewall and stack temperatures upon pipe still design
Thesis (M.S.)--Michigan State University of Agriculture and Applied Science. Dept. of Chemical Engineering, 1961
-
Improving heating plant emissions using flue gas carbon monoxide monitoring : a thesis presented in partial fulfilment of the requirements for the degree of Masters of Engineering in Automation and Control at Massey University
… plants and their control systems. In these the excess air (above the stoichiometric ratio) for combustion is a process variable and its setpoint is determined using a look-up table. RCR aims to improve the efficiency of wood-fired, thermal-oil heating plants by using a combination of carbon …
-
Optimisation of Co-Firing of High Moisture Biomass with Coal in a Bubbling Fluidised Bed Combustor
… of water into the bed on the reduction of excess air to get a stable bed temperature. Although this thesis is focused on increasing the throughput of the HGG, the study has a broad application and can be beneficial in utilising relatively cheap, poor quality,<br/>unprepared biomass …
-
Co-combustion of biomass fuels with coal in a fluidised bed combustor.
… coal mass fraction, fluidising velocity, excess air and bed temperature. The smaller particle size and lower particle density of the fuels (i.e. coal/chicken waste, coal/rice husk and coal/wood powder), the higher carbon combustion efficiency obtained in the range of 86-90%, 83-88%, …
-
The effect of steam addition on sulphur trioxide formation during the combustion of liquid fuels
… quartz tube combuster. The effects of excess air, residence time, gas temperature, and steam injection on the level of SO₃produced have been investigated. A non-catalytic quartz tube combuster was built with the required safety precautions. Provisions for maintaining near isothermal …
-
Design and operational characteristics of a gasification-combustion process: flammability model
… conclusions were made: (1) Flammability of gas-air mixture is largely determined by the amount of heat loss prior to combustion, (2) At equivalence ratios greater than 1.25, CO appears in the combustion products, (3) Adiabatic Flame Temperatures are largely influenced by moisture and excess air, …
-
A simplified model for understanding natural convection driven biomass cooking stoves
… programs have the potential to impact indoor air quality, deforestation, climate change, and quality of life on a global scale. The majority of these cooking stoves operate in a natural convection mode (being driven by chimney effect buoyant fluid forces). Simplified theories for understanding …
-
Stability limits and combustion measurements in low calorific value gas flames
… operating conditions by varying swirl, secondary air temperature and excess air levels while maintaining the burner momentum constant. Addition of swirl up to a limit of O~ 69 generally improved stability. Preheating secondary air alone was beneficial only if the temperature was raised to at least …
-
Experiments on the effects of dilution and fuel composition on ignition of gasoline and alternative fuels in a rapid compression machine
… the first part of this work, ignition of methane-air mixtures under excess air dilution is studied. When excess air is used in SI engine operation, thermal efficiency is increased due to increase in compression ratio together with reduced pumping and heat loses. However, stable operation with …
-
Parametric Energy Efficiency Impact Analysis for Industrial Process Heating Furnaces Using MEASUR
… the parameters pertinent to charge materials, excess air, combustion air, flue gas, fixtures, furnace surfaces, openings, furnace draft, and cooling system. The fractional factorial design experiment was developed with two-level parameter values, considering the feasible and practical …
-
Improving the Efficiency of Gas Engines using Pre-chamber Ignition
… a marginal extension in the dilution limit with excess air and EGR; and hence no significant fuel efficiency improvements. Following these observations, a literature survey was conducted and it was soon realized that additional fueling to the pre-chamber will help scavenge the pre-chamber at the …
-
Gas Fired Fluidized Beds
… (5 cm deep), CO emissions are very small with excess air levels of not less than five percent.
-
The determination of the optimum CO₂ for operating number 6 boiler
… usually be maintained by the supply of fuel and air, regardless of the combustion efficiency; however, to achieve the desired efficiency the burning of the fuel must take place with a minimum amount of excess air. Thus the criterion for boiler operation becomes percent co. in the flue gas. With a …
-
Analysis of gases in ice from regions of northern Canada
… originate as dissolved gas with alteration by excess air addition and/or mixing with snow pack. In the ground ice sampled, low oxygen concentrations and high delta 18O values, indicate respiration prior to formation.
-
NO[sub x] and N2O emissions from circulating fluidized bed combustion
… The effects of fuel properties, temperature, excess air (0₂%) and limestone addition on the N[sub x]O and N₂O emissions were investigated with an emphasis on reducing both species simultaneously. Both axial and lateral O₂, NO[sub x] and N₂O concentration gradients existed in a CFBC riser, …
-
Incineration of industrial organic wastes in a circulating fluidized bed combustor
… of key operating parameters, i.e. temperature, excess air, primary-to-secondary air split ratio, suspension density and superficial gas velocity, on incineration performance of these wastes in a circulating fluidized bed incinerator. The fundamental study investigated the destruction of selected …
Page 1 of 4