Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 88 for “"Exponent N"”.
-
THE INFLUENCE OF A LAYER OF OXIDE ON ELECTROMIGRATION PERFORMANCE OF AL/CU/SI METAL LINES
… from 0.74eV to 0.76eV while the current density exponent, n ranged from 2.3 to 2.4. These values are consistent with published results. It is found that an oxide layer in between the metal has an intrinsic influence on the median-time-to-failure (MTF). The structure has a 3000Å metal/500 Å …
-
Modeling very low frequency wind-generated ocean noise
… where the two share the same frequency dependent exponent, n. The two coefficients and the exponent were computed empirically from the acoustic and wind speed data. An important observation is that the exponent n increases as frequency decreases and reaches a value above 7 at 10 Hz, which is much …
-
Fatigue life program using strain-life methods
… coefficient (K') and cyclic strain hardening exponent (n') vary during a material's fatigue life, the program is capable of either keeping them constant or varying them as a function of elapsed cycles. The program was then utilized to examine the effects of varying K' and n' on the calculated …
-
Creep of refractory concretes
… creep strain for the ISU-90 is given by stress exponent n to about 0.6 on the first heating and to about 3 on subsequent heating. For ISU-50, the stress exponent n is about 0.8 on first heating and about 2.5 on subsequent heating. The creep strain is dominated by deformation of the cement phase, …
-
Study of Wetting Phenomenon During Cooling of Curved Surfaces Using Impinging Water Jets
… and degree of subcooling on constant "a" and exponent "n" of the power relation are studied. Constant "a" is found to be linear function of jet velocity and degree of sub-cooling. Exponent "n" appears to be independent of jet velocity but weekly dependent on degree of sub-cooling.</p> …
-
The stress and temperature dependence of creep in an Al-2.0wt%Li alloy
… including the value of the stress exponent (n - 5), the shape of the creep curve, and the nature of the creep transient after a temperature change. However, anomalous behavior of the activation energy was observed. Activation energies up to 55 kcal/mole, decreasing to approximately …
-
Algumas soluções do problema de difusão com sumidouro
… capacity of the sink had been given for one exponent "n+1" of the concentration of the substance which diffuses. Finally we obtained the numerical solution when the concentration C = C (x/t) using for that Runge - Kutta's method.
-
One-Dimensional Gravity Sedimentation of Proppant
… to find the best-fit parameters of empirical exponent, n and maximum volume fraction, cm. The algorithm developed here provides a means for validating three-dimensional proppant transport simulators with literature results on 1-D gravity sedimentation of uniform, spherical particles in a …
-
Threshold Velocity and Incubation Period in Water Droplet Erosion
… It is also found that the strain hardening exponent (n) influences the incubation period by controlling the rate at which the fracture of surface fragments is achieved as well as the rate with which mechanical properties change with the increase in number of droplet impingements. It is …
-
The effects of ternary alloying additions on solute-drag creep in Al-Mg alloys
… alloys, but increase the sensitivity of stress exponent, n, to Mg content. Transitions to power-law breakdown in the Al xMg-5Zn materials are discussed. Ternary Fe and Cu additions increases n during solute-drag creep. Ductilities of over 100% are consistently achieved in the Al-xMg-5Zn and …
-
Local illumination models from surface geometry microform
… for bumped surfaces with low specular exponent n. Therefore inter-reflection should be accounted for in the lighting model for these surfaces. Generated cloth images including secondary reflection effects exhibit a higher degree of realism. The computation of secondary reflection …
-
The influence of temperature and composition on the activation energy for creep in binary aluminum lithium alloys
… class II alloy (pure metal class) with a stress exponent, n, approximately equal to 5. In addition, subgrain formation was observed in association with the primary stage of creep. The activation energy for creep of the A1-0.5wt.pct.Li and A1-1.Owt.pct.Li alloys was observed to b essentially the …
-
The effect of R-ratio on the mode II fatigue delamination growth of unidirectional carbon/epoxy composites
… on the observation that the growth rate law exponent, n and constant, A are unique functions of R-ratio. Values for n are surprisingly large and increase with increasing R-ratio whereas values for A decrease with increasing R-ratio. The effect of time-at-load has been considered in an attempt …
-
Studium kinetiky růstu zrn oxidových pokročilých keramických materiálů
… určit aktivační energii růstu zrn QG, růstový exponent n a kinetickou konstantu k0. Aktivační energie růstu zrn byla stanovena na 511±49 kJ/mol u tetragonálního ZrO2, 645±84 kJ/mol u kubického ZrO2 a 428±75 kJ/mol a 606±24 kJ/mol u Al2O3. Porovnání QG s aktivačními energiemi slinování uvedenými …
-
Investigation of indentation derived creep response using constant load and constant strain rate methods
… yielded the corresponding creep stress exponent (n); thus, leading to parallel lines of strain rate versus creep stress on the logarithmic scale. It is evident that the constant indentation strain rate method produced more uniform results. A parametric analysis taking into account a wide …
-
Performance analysis of IEEE 802.11g signals under different operational environments
… outdoor propagation models. A new path loss exponent, n, was also estimated for each case. Based on this exponent, the free space path loss model was properly modified in order to fit the measured path loss results.
-
Creep Resistance and Microstructure in Binary Aluminum Cerium Alloy Produced by Laser Powder Bed Fusion
… to that of cast ternary Al-Ce alloys. The stress exponent, n, was approximately 1 in the low stress regime and 5-7 in the high stress regime. The activation energy was 231kJ/mol. In comparison, both cast binary Al-Ce and AM AlSi10Mg have higher stress exponents and lower activation energies, …
-
Study of small strain stiffness of granular materials by a new developed cubical cell apparatus
… the measured small-strain stiffness power exponents (n) were 0.4829 under isotropic stress conditions and 0.5417 under multiaxial stress conditions. These values fall within the range of 0.480–0.602 reported in the literature for Hostun sand. Similarly, for CNSP-30 sand, the larger-strain …
-
Crystallization of Synthetic Blast Furnace Slags Pertaining to Heat Recovery
… kinetic parameters such as the Avrami exponent (n), rate coefficient (K) and effective activation energy of crystallization (E_A) were found by analysis of data obtained from in-situ observation of glassy to crystalline transformation and image analysis. Also, the dependence of …
-
On the enhancement of air-water constituent transfer by vorticity generated by non-breaking water waves
… with a special focus on the Schmidt number exponent (n). In the laboratory, bulk measurements and boundary layer analyses of microphysical observations of the oxygen transfer in linear wind-wave tank show that n decreases from approximately 2/3 for free wind-forced flat air-water interfaces …
Page 1 of 5