Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 98 for “"Fault currents"”.
-
Impact Of Fault Current Limiters And Demand Response On Electric Utility Asset Management Programs
Over-currents are known to be the dominant cause of power system component failures or deterioration from full functionality. Some of these effects may remain unknown and could later result in catastrophic failures of the entire or large portions of the system. There are plenty of devices/methods …
-
Clearing of single phase to ground faults
… selective clearing of single phase to ground faults. Actual fault currents are sometimes lower than calculated, and directional relays sometimes determine the wrong direction. Considering lower than calculated fault currents, the paper proposes several adaptions to present fault calculations …
-
Operating strategies to preserve the adequacy of power systems circuit breakers
… results in increased short-circuit or fault currents levels. As fault currents increase, they will eventually exceed circuit breaker ratings. Circuit breakers exposed to fault currents in excess of their ratings are said to be overstressed, underrated, or inadequate. Insufficient …
-
AN INTEGRATED OF CONTROL AND PROTECTION SCHEME FOR AC MICROGRIDS
… effective in protecting the microgrid against fault currents, either in grid–connected or islanded mode. In microgrid framework, distributed generation (DG) based RES require an interface of power electronic converters to regulate their output voltage, current, and frequency as well as to share …
-
Contribuição ao melhoramento da operação durante afundamentos de tensão de geradores de indução duplamente alimentados baseados em conversores modulares multinível
… a fundamental challenge which is to provide fault support. Given this problem’s relevance, this thesis proposes improving DFIG supportability to a voltage sag in the grid through a recent multilevel converter topology, the Modular Multilevel Converter (MMC). The inherent MMC arm impedance and …
-
Power System - Fault Clearance with Limited Fault Current
… technical challenges, particularly in fault current management. This thesis explores the evolving challenges and solutions in power system protection as the share of converter interfaced generators continues to grow in response to global ambitions for reducing greenhouse gas emissions. …
-
Simulation of power station protection equipment
… relays for radial power systems under estimated fault current conditions. The grading curves for these protection devices can be produced on a graphics terminal and a hard copy can be obtained. Additional programs have also been developed which could be used to assess the validity of relay …
-
The application of artificial neural networks to transformer protection
… Networks to identify the magnetizing inrush currents that may occur in transformers is developed in this thesis. It is based on the fact that the magnetizing inrush current has large harmonic components. A feed-forward neural network (FFNN) has been trained using the back-propagation …
-
Time-Domain Line Protection in Presence of Renewables
… into the power grid. However, their unique fault characteristics, significantly different from synchronous generators (SGs), present several challenges for existing line protection schemes at both transmission and distribution levels. These schemes, reliant on distance and directional relays …
-
Studies of fault current limiters for power systems protection : a project report submitted in partial fulfilment of the requirements for the degree of Master of Engineering in Information and Telecommunication Engineering, Institute of Information Sciences and Technology, Massey University, Palmerston North, New Zealand
… energy leads to increase in the system fault levels. It is not possible to change the rating of the equipment and devices in the system or circuits to accommodate the increasing fault currents. The devices in electronic and electrical circuits are sensitive to disturbance and any …
-
A three phase short circuit analysis of the Naval Weapons Laboratory electrical distribution system
… and a complete tabular presentation of maximum fault currents available at all critical locations is given. The study also includes one-line reactance diagrams for the entire system.
-
Investigation of disintegration and arcing in electric fuses
… of the fuse elements when subjected to excessive fault currents. The basis of the study involved experimental observation of disintegration of fuse elements and the analysis of the dynamic responses of current-carrying conductors, which precipitate disintegration. The experimental techniques …
-
Sequence Components Based Detection and Classification of Faults in an Islanded Distribution System with 100% Inverter Based Resources
… reclosers fail to coordinate for bidirectional fault currents flowing in such a system, jeopardizing the selectivity of protection. When these resources are Inverter Based Resources (IBRs), even detection and classification of faults becomes an issue due to lack of negative and zero sequence …
-
Specification, Placement, and Control of Fault Current Limiters In Power Systems
This dissertation focuses on the application of fault current limiters (FCLs) in power systems. The formula for the maximum first-peak fault current is derived to assist in specifying inductive FCLs. The specification process can be used to design and select proper FCL devices in a particular power …
-
Adaptive Protection Scheme for a Real-World Microgrid with 100% Inverter-Based Resources
… challenges due to bi-directional power flow and fault currents, lower fault current due to the inverter-based resources, and wide range of fault currents during different modes of operation. This work offers an insight into the issues involved, by taking a case study of a real-world feeder …
-
Testing of Current-Only Directional Relay Algorithm in a Realistic Distribution Network Testbed
… a novel proposal that detects the direction of fault currents without the need for new devices, but instead upgrades the software logic of existing devices, making it a cost-effective solution. This work provides a complete description of how to implement a hardware testbed to review the CODR …
-
Computerized Distribution System Protection Program
… by man, nature, and material defects. Large currents flowing through devices and lines which are· not designed to carry these currents for long periods of time cause electrical damage. The distribution system must be protected from the product it delivers, electric energy, in magnitudes …
-
Grounded HVDC grid line fault protection using rate of change of voltage and hybrid DC breakers
… di/dt limiting inductors to contain the rise of fault currents within the capacity of current hybrid DC breakers is demonstrated. The impact of different inductor sizes on current rise was studied. A fault detection and localization scheme using the rate of change of voltage (ROCOV) measured at …
-
Alternate Fault testing on a Bus on a Dynamic Position Vessel
Direct fault testing onboard Dynamic Position Vessels is a requirement to maintain the ships classification and ensure redundancy of the power system onboard to maintain position. The most vulnerable part of the ship when testing occurs is when a three phase fault is placed on a main bus. This puts …
Page 1 of 5