Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 7 of 7 for “"Four-Point Bend Testing"”.

  1. Thermal spray cladding optimization for steel drill pipe

    … of process parameter voltage was evaluated by four-point bend testing with digital image correlation and Vickers and nano-indentation testing across the coating-substrate interface. It was found that as the voltage increased, the number of defects, primarily oxides, decreased. The decrease in …

    colo-mines Repository record for Thermal spray cladding optimization for steel drill pipe (opens in a new tab)

  2. Preparation, microstructure and properties of silicon carbide-dysprosia composites

    … Flexure strengths were determined using four point bend testing. Fracture toughness was determined by both the three point, single-edge notched beam test and by the microindentation methods.

    uiuc Repository record for Preparation, microstructure and properties of silicon carbide-dysprosia composites (opens in a new tab)

  3. Silicon infiltration of silicon carbide selective laser sintered preforms

    … optical microscopy, density measurements, four point bend testing, hardness testing, and scanning electron microscopy were all performed to characterize the parts. The silicon carbide/silicon parts had little shrinkage, were fully infiltrated, have good flexural strength. Flexural strength …

    texas Repository record for Silicon infiltration of silicon carbide selective laser sintered preforms (opens in a new tab) Restricted access

  4. Buckling and growth of disbonds in honeycomb sandwich structure

    … the failure process was established through four-point bend testing of 56 sandwich specimens. For both types of disbond, failure was found to be governed by buckling-driven disbond growth and, consequently, models of buckling and disbond growth were developed. All of the models decoupled the …

    auckland-ms Repository record for Buckling and growth of disbonds in honeycomb sandwich structure (opens in a new tab)

  5. Analysis of Bimetallic Adhesion and Interfacial Toughness of Kinetic Metallization Coatings

    … J/m2 and 4.55 J/m2, respectively. A modified Four-point bend testing technique was used to experimentally measure GC for Ni-Cu and Ni-Ti specimens produced by KM. These tests yielded mean G­C values of 50.92 J/m2 and 132.68 J/m2 for Ni-Cu and Ni-Ti specimens, respectively. Plastic deformation …

    calpoly Repository record for Analysis of Bimetallic Adhesion and Interfacial Toughness of Kinetic Metallization Coatings (opens in a new tab)

  6. Experimental study of ultra-thin films mechanical integrity by combined nano-indentation and nano-acoustic emission

    … is in good agreement with estimates done by four-point-bend testing on the same material system.</p> <p>The developed experimental protocol may become useful in identifying the prominent failure mechanisms for quick screening of film-substrate, as well as in providing some quantitative …

    iastate Repository record for Experimental study of ultra-thin films mechanical integrity by combined nano-indentation and nano-acoustic emission (opens in a new tab)

  7. Effects of Low Velocity Impact on the Flexural Strength of Composite Sandwich Structures

    … sandwiches under impact loads. Experimental testing can still be unpredictable, however, because low velocity impacts can cause undetectable damage within the composites that weaken their structural integrity. This is an important issue with composite sandwich structures because interlaminar …

    calpoly Repository record for Effects of Low Velocity Impact on the Flexural Strength of Composite Sandwich Structures (opens in a new tab)