Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 14 of 14 for “"Geometry Factor"”.
-
Experimental study of rock fragmentation with an Actuated Undercutting Disc
… parameters. The result indicated that the geometry factor and actuation factor of actuated disc cutting contribute more than the penetration rate. Statistical modelling was conducted to simulate the accumulation of force drop and fragment size. Results indicated both force drop events and …
-
Using a Nondispersive Wave Propagation for Measuring Dynamic Fracture Initiation Toughness of Materials: Experimental and Numerical Based Study
… fracture parameters such as Stress Intensity Factor (SIF), J-integral, and Crack-Tip Opening Displacement (CTOD) have been developed and used to characterize the fracture properties of most engineering materials under quasi-static loading condition. Usually, these properties are obtained …
-
Finite element stress analysis of a generic spur gear tooth
… when designing spur gear systems. The tooth geometry is such that stress risers exist which must be accounted for when determining stresses. In addition, variables affecting the exact load point on the tooth and the direction of the applied load are critical. The presented study attempts to …
-
The Effect of High Rotational Speed on the Performance of Straight-through Labyrinth Seals for Compressible and Incompressible Flow
… through Labyrinth seals. The effect of seal geometry on discharge coefficient, carry over coefficient and expansion factor is studied by varying clearance, pitch, tooth height, tooth width ,Reynolds number and rotor speed. Derived quantities Such as carry over coefficient, coefficient of …
-
Understanding And Predicting Bagging Performance Through The Use Of CFD And DEM Simulations
… chute. The most problematic weather related factors are dew and rain, with the former being the most severe. Conditions creating this problem typically occur during the spring months and when the grass is at its healthiest state. Field research and data have been collected to gain a better …
-
Spatial Modeling of Formation of Gel
… it was seen that the permeability and the geometry factor of the simulated and experimental structures were relatively similar.
-
Modelling the Electromagnetic Properties of Conductive Nonwoven Fabrics
… contact resistance of Rj = 8.6kΩ, and a measured geometry factor of Φx = 0.727, Φy = 0.273. Analytic models of the material are derived from first principles enabling the rapid calculation of the sheet conductance, whilst also providing an understanding between the key parametric relationships. …
-
Abundances of Ultra-Heavy Cosmic Ray Nuclei with CALET
… an energy determination in exchange for a larger geometry factor, which gives higher statistics. For this an event-by-event angle dependent rigidity cutoff is used to select events above an equivalent minimum energy. This is done in two ways, a quick Størmer approximation and a fourth order …
-
Neutron dosimetry, moderated energy spectrum, and neutron capture therapy for ²⁵{45}R²Cf medical sources
… dependance of dosimetry on the source geometry factor as there was no significant neutron attenuation within the source or encapsulation. Gold foils and TLDs were used to measure the thermal flux in the vicinity of 252Cf AT sources to compare with the results calculated using MCNP. As …
-
Space charge measurement in polymer insulated power cables using the PEA method
… principle of space charge measurement in cable geometry with the new system is fully obtained. To remove the influences of the geometry factor, the acoustic propagation attenuation and dispersion through the polymer material, a compensation algorithm has been developed to improve the measurement …
-
Image Reconstruction Method to Separate Simultaneous Encoded Slices with In-Plane and Through-Plane Acceleration in FMRI
… in the design matrix, and the influence of the geometry factor (g-factor) increases. To manually increase the distance and the difference in coil sensitivity information between the aliased images, the Controlled Aliasing in Parallel Imaging (CAIPI) and view angle tilting (VAT) techniques …
-
Light Scattering Study on Single Wall Carbon Nanotube (SWNT) Dispersions
… related with its anisotropic structure and geometry factor. Characterization of carbon nanotube length is critical for understanding their behavior in solutions as well as in polymer composites. Microscopy, particularly atomic force microscopy, has been used for their length measurement. …
-
Descriptive, interpretive, and quantitative study of the coarse clastics of the Middle Ordovician Tellico Formation in the vicinity of South Holston Dam, Tennessee
… regularity in their probability matrices.</p><p>Factor analysis is used to objectively specify the common factors explaining variation in properties (R-mode) and beds (Q-mode). An iterative R-mode factor analysis disclosed five factors: a turbulence factor, a scale or parameter factor, a bed …
-
A Numerical Based Determination of Stress Intensity Factors for Partially Cracked Flexural I-shaped Cross-sections
… crack tip is by calculating the Stress Intensity Factor (SIF) around the crack tip. Finding SIFs for a cracked geometry may help an engineer to determine the fracture potential based on crack dimensions found during the inspection. Rolled I-beam and steel plate girders are extensively used as …