Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 44 for “"Hall probe"”.
-
Study of a ferromagnetic semiconductor by the scanning Hall probe microscope
… goal of my dissertation was to build a Scanning Hall Probe Microscope (SHPM) for studying the domain structure of a ferromagnetic semiconductor (Ga[subscript 0.94]Mn[subscript 0.06]). This new semiconductor may be used in the emerging field of spintronics, where both the charge and spin of an …
-
Magnetic flux dynamics in superconducting films studied by scanning Hall probe microscopy
… geometry. In our experiments we used scanning Hall probe microscopy to investigate the magnetic field profile above the samples' surface. In the first experiment, Vortex Nucleation in Narrow Thin-Film Strips, we studied the magnetic flux nucleation in type-II superconducting thin-film strips of …
-
Application Of Scanning Hall Probe Microscopy For High Throughput Characterization Of Combinatorial Magnetic Materials
A Scanning Hall Probe Microscope (SHPM) with a submicron Hall probe (HP) was used for high efficiency characterization of magnetic materials at high magnetic fields. Specifically, we have studied phase diagrams of Co-Fe-Ni binary and ternary alloys, as well as weak itinerant ferromagnet MnSi. The …
-
Magnetic imaging of fluxoid behavior in superconductors and spin-polarization effects in chiral materials
… the utilization of a custom-built scanning Hall-probe microscopy system to image a range of superconducting and magnetic phenomena. Our system offers approximately 1 μm2 spatial and 10 mG field resolution (depending greatly on the conditions of the scan), serving as a powerful tool for …
-
The application of Hall effect device for the measurement of low magnetic field.
An indium antimonide Hall element is prepared, operated at liquid nitrogen temperature in combination with 5 inch long mumetal concentrator. The polycrystalline indium antimonide Hall probe provides an overall sensitivity of 12500 Volts/ampere-kilo gauss. The device is capable of measuring down to …
-
Optical properties of 50 CM Browne-Buechner spectrograph
… several levels of excitation, using both a NMR probe and a Hall probe. First, the field was measured by a NMR probe at 2.5, 5 and 10 kG, and second, the field was re-measured using a Hall probe at 5.0 and 10.0 kG. The field maps were used as data for the ray tracing programme to obtain the …
-
Surveys in preparation for the commissioning of the TRIUMF magnet
… magnet was determined. A 1/10 scale model Triple Hall Probe was constructed and precisely calibrated. Its performance was tested and surveys made in the model. Finally the characteristics of the trim coils to be used in the cyclotron were measured.
-
Graphene Devices for Sensing and Electrical Control of Magnetic Phenomena
… graphene as a material for highly sensitive Hall-effect sensors. These devices are promising for the development of a scanning Hall probe microscope operational over a range of temperatures and magnetic fields not previously accessible with a single sensor. I then discuss calculations …
-
Batch-fabrication of novel nanoprobes for SPM
… sensors to be defined on the atomic force probes, with little additional development beyond that of : sensors themselves. This flexibility has enabled very different sensors meant for very different scanning probe microscopy techniques to be designed without significant redevelopment of the …
-
Magnetic Imaging of Micrometer and Nanometer-size Magnetic Structures and Their Flux-Pinning Effects on Superconducting Thin Films
… switch) is proposed. In addition, scanning Hall probe microscopy (SHPM) and other imaging techniques were used to characterize the magnetic properties of the systems mentioned. The SHPM was also used to acquire B-H and M-H curves. An additional sharp magnetic needle and electromagnetic coil …
-
On the magnetic properties of drilled bulk high-temperature superconductors containing an artifical array of holes
… linearly varying applied magnetic field, and we probe the magnetic field in the volume of drilled samples with the help of microcoils inserted inside the holes. The thesis starts with an introductory chapter that describes the general concept of high-temperature superconductivity and particularly …
-
Hydromagnetic turbulent instability in liquid sodium experiments
… Earth's core. We describe the development of a Hall probe array that measures the field at 30 points outside the sphere and is used to perform a spherical harmonic decomposition (up to l=4) of the induced field. We present measurements taken with this array, along with measurements of torque …
-
Stoichiometry control mechanisms of bias sputtered zinc oxide films
… optical and structural properties using Hall probe,. X-ray diffraction, electron microscope, and visible and infrared spectroscopy techniques. Films deposited at low substrate bias (0 to -50V) were found to have a large Zn excess (15%) resulting in low electron mobilities (1 cm²/Vs), high …
-
Vortex matter, dynamics and pinning in superconducting materials
… study of vortex matter and dynamics by Scanning Hall Probe Microscopy; and (vi) science and technology of vortex pinning, including through self-assembling nanotechnology of pinning centres. There are a small number of publications that do not fall in the above-mentioned areas, but they are also …
-
Quantum transport in spatially modulated two-dimensional electron and hole systems
… magnetic field (300mK/12T) scanning Hall probe microscope (SHPM) technique for measuring small local magnetic fields at low temperature and an algorithm for calculating the current density from measured magnetic fields based on Fourier transformation technique. Integration of SHPM and …
-
MOSFET transistor fabrication on AFM tip
… sensor devices on Atomic Force Microscopy (AFM) probes and their characterization. The devices use the principle of the Hall effect (based on the Lorentz force) to sense the magnetic properties of a magnetized specimen. In the past Hall bar sensors have been fabricated using semimetals such as …
-
Novel coil designs for different neurological disorders in transcranial magnetic stimulation
… built by Jali Medicals with the help of an axial Hall probe and a gaussmeter. Furthermore, seven different coils for small animals were presented in this dissertation. These coils had varying electric field with the Slinky coil having the minimum area of stimulation and lowest electric field below …
-
Low temperature magnetic structure studies of La₂₋₂xSr₁₊₂xMn₂O₇ using scanning probe microscopy
… this reason, as part of this project a scanning Hall probe microscope (SHPM), a magnetic imaging technique complementary to MFM that uses a Hall sensor that provides a magnetically non-invasive calibrated measurement of the stray fields at the surface of a sample with good resolution (~ 1 …
-
Integrated Platform for 2D Reel-to-Reel Characterization of 2G-HTS Superconductors
… at (77 K, 0 T) (Tapestar and/or R2R Scanning Hall Probe Microscopy, SHPM) or as data points at relevant fields and temperatures (B, T) using Vibrating Sample Magnetometry (VSM). This work demonstrates that residual strain, inferred from tape curvature, is proportional to the density of …
-
Design and demonstration of a mouse-specific Transcranial Magnetic Stimulation coil in-vitro
… densities of these coils were measured with a Hall probe at the base of the coils and 2 mm above the Hall sensor. The induced electric field strengths of these coils were measured with a wire loop at 50 V power supply. The heating in coils were measured at 50 V supply with thermocouple probe. I …
Page 1 of 3