Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 76 for “"High Isolation"”.

  1. High-Isolation Antenna Technique for CubeSat-Borne, Continuous-Waveform Radar

    … separating the antennas helps provide the isolation required for continuous-waveform radar, but is limited by the small size of the CubeSat. Isolation can be further increased by designing the antennas with opposite circular polarizations. The interfering signal traveling directly between …

    utahstate Repository record for High-Isolation Antenna Technique for CubeSat-Borne, Continuous-Waveform Radar (opens in a new tab)

  2. High Gain Millimeter-wave Antenna Array Design with High Isolation

    Millimetre wave (mm-wave) antenna arrays with high gain are explored to meet the user requirements of high throughput, with a very close distance between the antenna elements, which enables miniaturisation. However, high-gain antenna array design at mm-wave bands has been a growing concern among …

    concordia Download PDF for High Gain Millimeter-wave Antenna Array Design with High Isolation (opens in a new tab)

  3. Design of high-isolation and wideband RF switches in SiGe BiCMOS technology for radar applications

    … lies in the proposed new topology of an ultrahigh-isolation single-pole, single-throw (SPST) and a single pole, four-throw (SP4T) nMOS based switch for multiband microwave radar systems. The analysis of cryogenic temperature effects on these circuits and devices are discussed in this work. The …

    gatech Repository record for Design of high-isolation and wideband RF switches in SiGe BiCMOS technology for radar applications (opens in a new tab)

  4. High-Isolation Low-Power Active Quasi-Circulator for 44GHz Transceiver with Power and Noise Optimization in 0.18 Micrometer BICMOS

    … circuits. Active circulators provide a compact high isolation solution for low power application with smaller size and less cost with compatibility with modern IC. Previous works are majorly working at low frequency and paid little attention to power and noise requirement of active …

    tamu Repository record for High-Isolation Low-Power Active Quasi-Circulator for 44GHz Transceiver with Power and Noise Optimization in 0.18 Micrometer BICMOS (opens in a new tab)

  5. Reflectarray Antenna based FMCW Radar System Development: High Isolation Radar Antenna Design and Feasibility of Affordable Switched-Beam for the UAV Detection

    … cost of current anti-drone radars is extremelyhigh, thus there is a need for cost-effective radars that protect critical infrastructures. The goal of our research is to develop a high gain, low power (potentially battery operated), lightweight, cost-effective, large field of view (FoV), and …

    unr Repository record for Reflectarray Antenna based FMCW Radar System Development: High Isolation Radar Antenna Design and Feasibility of Affordable Switched-Beam for the UAV Detection (opens in a new tab)

  6. Simulação e projeto de antenas MIMO para aplicações nas tecnologias UWB, 5G e em smartphones

    … proposed MIMO antenna has compact dimensions, high isolation between ports and can be used for wireless local area network (WLAN) applications; the second proposed MIMO antenna is a miniaturized MIMO antenna, with high isolation between the ports and which can be used in ultra-wideband (UWB) …

    brazil-ufrn Repository record for Simulação e projeto de antenas MIMO para aplicações nas tecnologias UWB, 5G e em smartphones (opens in a new tab)

  7. A Voltage Controlled Oscillator for a Phase-Locked Loop Frequency Synthesizer in a Silicon-on-Sapphire Process

    … an fully integrated VCO core circuit and a high-isolation buffer amplifier. The high-isolation buffer amplifier was designed to provide 16 dB of gain for 2200-3495 MHz as well as 60 dB of isolation for the oscillator core to provide immunity to frequency pulling due to RF load mismatch. …

    ku Repository record for A Voltage Controlled Oscillator for a Phase-Locked Loop Frequency Synthesizer in a Silicon-on-Sapphire Process (opens in a new tab)

  8. Self-Interference Cancellation for Simultaneous Transmit and Receive (STAR) Applications

    … For a STAR system to be effective, high isolation (in excess of 90 dB) between transmit and receive channels is required to avoid self-interference. A lack of isolation will result in a significant reduction in the receiver sensitivity and dynamic range, reducing its ability to …

    cape-town Repository record for Self-Interference Cancellation for Simultaneous Transmit and Receive (STAR) Applications (opens in a new tab)

  9. High-Efficiency Passive and Active Phased Arrays and Array Feeds for Satellite Communications

    … lower cost than full aperture phased arrays and higher tracking speed and accuracy than mechanical-only steering.Multiple high efficiency passive patch array feeds were designed, fabricated, and measured, including a 2x2 MSA array, a stacked shorted annular patch antenna, and an SIW-fed hexagonal …

    byu Repository record for High-Efficiency Passive and Active Phased Arrays and Array Feeds for Satellite Communications (opens in a new tab) Download PDF for High-Efficiency Passive and Active Phased Arrays and Array Feeds for Satellite Communications (opens in a new tab)

  10. The design and analysis of an optoelectronic broadband matrix switch

    … Their broad fre­quency bandwidth capabilities, high isolation on/off ratio and low crosstalk in the input and output distribution lines read­ily lead to the construction of large dimension matrix switches. This thesis presents the design and analysis of a 2 x 4 broad­band optoelectronic matrix …

    uvic Repository record for The design and analysis of an optoelectronic broadband matrix switch (opens in a new tab)

  11. Dual-band Microwave Components And Their Applications

    … (letting two lines to cross each other with very high isolation) and its dual-band application is the subject of chapter 3. A dual-frequency cloak based on lumped LC-circuits is introduced in chapter 4. In chapter 5, a dual-band RF device to detect dielectric constant changes of liquids in …

    unt Repository record for Dual-band Microwave Components And Their Applications (opens in a new tab)

  12. Multi-Band Small Antennas for Mobile Terminals

    … technique is proposed for wideband/multiband isolation enhancement in compact volume. Although decoupling techniques have been researched for many years, multimode decoupling technique remains a great challenge for mobile terminals. One difficulty in achieving multi decoupling modes is that …

    kent Download PDF for Multi-Band Small Antennas for Mobile Terminals (opens in a new tab)

  13. Design of a reconfigurable low-noise amplifier in a silicon-germanium process for radar applications

    … switch is optimized for low insertion loss and high isolation. A narrowband (non-switchable) LNA is developed as a basis of comparison for reconfigurable designs. The optimized switch is incorporated into different switchable transistor core architectures. These architectures are investigated to …

    gatech Repository record for Design of a reconfigurable low-noise amplifier in a silicon-germanium process for radar applications (opens in a new tab)

  14. Millimeter-Wave Reconfigurable CMOS-MEMS Integrated Devices

    … fabrication of miniaturized, low insertion loss, high isolation RF-MEMS switches implemented in CMOS chips through the use of a post-processing technique. Several CMOS-MEMS switches operating at 60 GHz and 77 GHz are demonstrated. Prototype units for SPST, SP3T switches and a distributed MEMS …

    waterloo Repository record for Millimeter-Wave Reconfigurable CMOS-MEMS Integrated Devices (opens in a new tab)

  15. Multibeam Communication with Digital Sparse Arrays

    … to achieve maximum beam orthogonality and isolation. The proposed method is compared against three different configurations, namely purely random, random with jitter, and the Van Der Corput sequence (a low-discrepancy sampling approach). Simulated results demonstrate that the genetic …

    calpoly Repository record for Multibeam Communication with Digital Sparse Arrays (opens in a new tab)

  16. High speed bus analysis Field bus and real time communication in high levels of EMI

    In this report, high speed bus communication alternatives in high levels of EMI are investigated. The intended target is a weld system consisting of several parts where one is a power source. Weld power sources are subject to safety regulations regarding electrical safety. Therefore electronic …

    chalmers Repository record for High speed bus analysis Field bus and real time communication in high levels of EMI (opens in a new tab)

  17. Study of the electromechanic aspects of RF MEM devices with particular emphasis on the dynamic behavior for the case of RF MEM switches and tuneable capacitors

    … outstanding advantages like low insertion loss, high isolation and linearity, but they suer from some drawbacks like low switching speed and lack of reliability. In the near future for many applications, like mobile phones and communication systems, reliable switches with higher commutation speed …

    trento Repository record for Study of the electromechanic aspects of RF MEM devices with particular emphasis on the dynamic behavior for the case of RF MEM switches and tuneable capacitors (opens in a new tab)

  18. Millimeter-Wave Concurrent Dual-Band BiCMOS RFIC Transmitter for Radar and Communication Systems

    … dual-band transmitter for short-range, high-resolution radar and high-rate communication systems. A new type of low-power active balun consisting of a common emitter amplifier with degenerative inductor and a common collector amplifier is proposed. The parasitic neutralization and …

    tamu Repository record for Millimeter-Wave Concurrent Dual-Band BiCMOS RFIC Transmitter for Radar and Communication Systems (opens in a new tab)

  19. Computer aided design of a broadband microwave power divider

    … to increase the bandwidth while maintaining high isolation and good match conditions at individual ports. Resistors placed between the quarter wave sections served to increase isolation. The values of required components were determined using odd and even mode analysis. In this work, the …

    njit Repository record for Computer aided design of a broadband microwave power divider (opens in a new tab)

  20. Design and realisation of filters on MHMIC and MMIC fabrication processes for duplexers realisation

    … filters and duplexers with low losses and high isolation. This thesis presents a miniaturised topology based on a topological miniaturisation technique using computer aided design and analysis. The filters designed in this work are suitable for manufacturing on any planar fabrication …

    ets-quebec Download PDF for Design and realisation of filters on MHMIC and MMIC fabrication processes for duplexers realisation (opens in a new tab)

Page 1 of 4