Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 65 for “"Hopkinson bar"”.
-
Advancements in the Split Hopkinson Bar Test
The split Hopkinson bar test is the most commonly used method for determining material properties at high rates of strain. The theory governing the specifics of Hopkinson bar testing has been around for decades. It has only been the last decade or so, however, that significant data processing …
-
Split Hopkinson bar method of rock testing, The
Includes bibliographical references.
-
Spectral Analysis of Wave Propagation Through a Polymeric Hopkinson Bar
… so a new test method was developed. A polymeric Hopkinson bar was developed enabling non-metallic materials, such as polycarbonate and rubber, to be tested at strain rates from 500 s^-1 to 4000 s^-1. Conventional Hopkinson bar analysis is invalid due to the viscoelastic nature of the polymeric …
-
Design of a Split Hopkinson Bar Apparatus for use with Fiber Reinforced Composite Materials
… the dynamic response of materials is the Split Hopkinson bar. The main focus of this work was to design a Split Hopkinson Bar apparatus to determine the dynamic compressive behavior of fiber reinforced composite materials. Graphite epoxy laminated composites have compressive failure strengths of …
-
Investigation of Blast–related Fluid Cavitation using a Novel Polymeric Hopkinson Bar–Confinement Chamber Apparatus
… and Polymethyl methacrylate (PMMA) incident bar. Numerical models were developed and validated to model the PMMA incident bar with and without the PMMA chamber using 24 independent tests for strain and end velocity using iv varying striker geometry (cross–correlation: 0.970–0.997). …
-
Experimental determination of material properties for materials subjected to high compressive strain rates
The design, fabrication and operation of a split Hopkinson bar apparatus is described. The theoretical basis for the experimental determination of material properties for materials subjected to high compressive strain rates using the split Hopkinson bar is discussed along with the assumptions made …
-
An investigation of Von Mises flow criterion at high rates of strain
… at a strain rate of 1000 s−1 using a Split Hopkinson Bar and at quasi-static strain rate using an Instron machine. Shear data was collected at a shear strain rate of 1750 s−1 using a Torsional Hopkinson Bar. The Mechanical Threshold Stress constitutive equations determined from the Von Mises …
-
INNOVATIVE CHARACTERIZATION AND ELASTOPLASTIC MODELLING OF METALS UNDER STATIC AND DYNAMIC CONDITIONS
… of the error levels in the characterization via Hopkinson bar tensile tests, ran according to the classical strain-gauge-based experimental procedure and to the enhanced high-speed-camera-assisted procedure. In addition, the effect of the specimen slenderness is investigated for checking the …
-
Metamaterial Applications for Vibration and Wave Propagation in 1D Elastic Rods
… use of phononic materials for pulse shaping in Hopkinson bar tests. Various base isolation techniques have been developed for heavy machinery. This dissertation looks at the problem of a vibrating electric generator and how phononic material concepts could be applied to mitigate vibrations. Two …
-
Implementation of viscoelastic Hopkinson bars
… soft or low impedance materials using metallic bars in a split Hopkinson pressure bar setup, poor signal to noise ratios and impedance mismatching occur. One solution is to use polymeric Hopkinson bars. In this dissertation, Polycarbonate, Polymethyl Methacrylate and Nylon are considered for use …
-
Numerical Simulation of a High Strain Rate Biaxial Compression Apparatus
… s-1). Those that are capable, such as the Split Hopkinson Bar, Taylor Anvil and Plate Impact suffer from instability and are generally limited to one dimensional wave propagation. Of particular interest is material response under biaxial compression, similar to that seen in inertial confinement …
-
Describing Large Deformation of Polymers at Quasi-static and High Strain Rates
… rate compressive and tensile loading using Split Hopkinson Bar devices, and they exhibit a temperature increase, which induces phase transition at the glass transition temperature.
-
Response of yarn systems to impact loading
… polymeric fibres based on the tensile split Hopkinson bar method and the transverse impact method, to obtain the dynamic mechanical response of Spectra 900 yarn and Spectra Shield flexible laminated composite. The responses obtained enable the establishment of accurate rate-dependent, …
-
Constitutive Behavior of Aluminum Alloy Sheet At High Strain Rates
… between ambient and 300°C, using a tensile split Hopkinson bar (TSHB) apparatus. As part of this research, the apparatus was modified in order to provide an improved means of gripping the sheet specimens. Quasi-static experiments also were conducted using an Instron machine. <br /><br /> The …
-
High strain properties of advanced high strength spot welded steels
… strength spot welded steels, using the split Hopkinson pressure bar or the Kolsky bar apparatus. The high strain rates properties of weldments are needed to evaluate the mechanical response of a spot welded structure, such as an automobile body, when subjected to dynamic loads during a crash …
-
An investigation into the failure of aluminum alloys
… tests, dynamic tension tests, and split pressure Hopkinson bar tests. The macroscopic strains of the quasi-static and dynamic tension tests were measured after failure within the uniform region and the necked region using high-resolution images and edge detection. The study continued with an …
-
High strain rate-induced failure in steels at high shear strains
… 4140 steel was tested using a torsional split Hopkinson bar at three different strain rates and the impact of strain rate on the material behaviour was examined. The influence of material hardness on failure mechanisms was also investigated by producing different tempers of 4140 steel with …
-
Deformation and fracture of concrete under uniaxial impact loading
… with a computer numerical analysis of the bar-geometry axial-impact loading. The critical normal fracture strain energy U and mechanical energy W criteria are proposed for the spatial and time dependence explanation of spallation in concrete. The energy criteria are special cases of a more …
-
Dynamic strength and fragmentation of silicon carbide
… dynamic rates of 102 s-1, using a Kolsky (split-Hopkinson) bar. The loading and failure have been investigated using high-speed imaging and Digital Image Correlation (DIC). Fragmentation has been shown to be an important factor in understanding the performance of advanced ceramics. Consequently, …
Page 1 of 4