Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 16 of 16 for “"Hot Wires"”.
-
Turbulence measurements with a nano-scale thermal anemometry probe
… has working principles similar to conventional hot-wire anemometry, at the same time having greatly improved spatial and temporal resolution. Fabrication of NSTAP has been conducted, using several semiconductor and MEMS (microelectromechanical system) techniques. Sensing element of NSTAP is a …
-
Direct measurements of stress and spectra of turbulence in the boundary layer over the sea
… components of air velocity were made using hot wires in an X-array, in order to study the spectra of the fluctuations, and their co-spectrum over a range of mean wind speeds from 140 – 1000 cm./sec. in the boundary layer over the sea. In order to use the X-wire probe properly in the field, …
-
Hot-Wire Anemometer for the Boundary Layer Data System
Hot-wire anemometry has been routinely employed for laboratory measurements of turbulence for decades. This thesis presents a hot-wire anemometer suitable for use with the Boundary Layer Data System (BLDS). BLDS provides a unique platform for in- flight measurements because of its small, …
-
Study of isotropic structure in atmospheric boundary layer turbulence
… of z = 2 m. above a flat land surface. Four hot wire anemometers were mounted in a three dimensional array to collect data on the downwind turbulent velocity fluctuations. Cross spectra were computed from the observed data between three pairs of hot wires having the same spacing in different …
-
Effects of turbulence on wind induced vibrations of bluff cylinders
… and the measurements of its properties, with hot wires, gave results in good agreement with those of other experimenters. Then, dynamic and static models of rectangular section with H/d=0.5, 1.0, 2.0 and of D-shape, were exposed to different intensities and to different scales of turbulence. A …
-
Effects of Initial Conditions on Turbulence Length Scale and Energy Distributions in the Near to Intermediate Field of a Round Free Jet
… plane x/D = 0.03. Both stationary and flying hot wires were used to investigate the jet flow field. The results showed a considerable reduction in the jet spread rate and turbulence intensity using the passive rings. The reduction in the velocity decay rate was more obvious in the case of Rsl …
-
Pseudo Euler-Lagrange and Piecewise Affine Control Applied to Surge and Stall in Axial Compressors
… is to install various types of pressure sensors, hot wires and velocity probes. The inception of the rotating stall and surge is recognized by the presence of pressure fluctuation and velocity disturbances in the gas stream that are obtained through sensors. The necessary measure is then taken by …
-
Flowfield Downstream of a Compressor Cascade with Tip Leakage
… of the cascade was measured using four sensor hot-wire anemometers, from which the mean velocity field , the turbulence stress field and velocity spectra were obtained. Oil flow visualizations were done on the endwall underneath the blade row. Also studied were the effects of tip gap height, …
-
Accurate measurement of the thermal conductivity of phase changing materials (PCM) in the solid and liquid phase
… measurements using the Transient Hot-Wire Technique, without the influence of contact resistance, by employing a new category of materials known as Phase Changing Materials (PCMs). In the following chapters, the motivation for this work, the selected technique and materials, and …
-
INTERACTION OF TWO PLANE PARALLEL TURBULENT JETS
… velocity components using single and cross hot-wires at several streamwise locations in the converging, merging and combined regions of two interacting plane parallel turbulent jets. The results obtained for mean velocity and turbulent intensities distributions, shear stress profiles, …
-
Measurements of entropy-layer instabilities over cone-ogive-cylinders at Mach 6
… (BAM6QT) using surface pressure transducers and hot-wire anemometry. A long cone-ogive-cylinder model with interchangeable cone-ogive noses was used to generate the shock curvature that resulted in an entropy layer conducive to instability growth. The nosetip angles of the cone-ogive range from …
-
Development of an Autonomous Single-Point Calibration for a Constant Voltage Hot-Wire Anemometer
… of turbulence has been conducted using hot-wire anemometry. This thesis presents the implementation of a constant voltage hot-wire anemometer for use with the Boundary Layer Data System (BLDS). A hot-wire calibration apparatus has been developed that is capable of operation inside a …
-
The Later Stages of Transition over a NACA0018 Airfoil at a Low Reynolds Number
… tools, including a rake of six boundary-layer hot-wire anemometers, were used to perform measurements over the model. Novel high-speed flow visualization performed with a smoke-wire placed within the separated shear layer showed that roll-up vortices are shed within separation bubbles forming …
-
Sound Scattering by Lattices of Heated Wires
… Starting with the simplest case of two hot wires in air the study extends over periodic structures known as Sonic Crystals (SCs). The Finite Elements Method (FEM) has been employed to perform numerical simulations in order to demonstrate collimation and focusing effect of acoustic waves …
-
Modification of flow structures associated with broadband trailing edge noise
… 5° angle of attack were used as the baseline. Hot-wire anemometry with two traversing hot-wires were used as the main sensor for unsteady velocity measurements. Spanwise and streamwise correlations were obtained at different depths in the fully turbulent BL near the trailing edge of the …
-
Análise experimental e numérica de escoamentos turbulentos em canais compostos empregando simulação de grandes escalas e método dos elementos finitos
Este trabalho apresenta um estudo experimental e numérico de escoamentos em canais compostos. Simulação de grandes escalas e método dos elementos finitos, em paralelo com medições utilizando anemômetros de fio quente em um canal aerodinâmico são realizadas. Canais compostos estão presentes em …