Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 20 of 141 for “"Hot-wire Anemometry"”.

  1. HOT WIRE ANEMOMETRY IN COLD MACH 4 FLOW

    … for estimating turbulence intensity using hot-wire anemometry in cold, constant-Mach supersonic wind tunnels.

    nps Repository record for HOT WIRE ANEMOMETRY IN COLD MACH 4 FLOW (opens in a new tab)

  2. Effect of an oil fog upon hot-wire anemometry response

    Thesis (M.S.)--Michigan State University. Department of Mechanical Engineering, 1982

    msu Repository record for Effect of an oil fog upon hot-wire anemometry response (opens in a new tab)

  3. Constant Voltage Hot-Wire Anemometry for the Boundary Layer Data System

    … Layer Data System (BLDS), a constant voltage hot-wire anemometer (CVA) is implemented into the BLDS for flight-testing. The hot-wire anemometer was chosen as an alternative to the traditional pressure probe because of the ability to measure both average velocity and fluctuating velocity within …

    calpoly Repository record for Constant Voltage Hot-Wire Anemometry for the Boundary Layer Data System (opens in a new tab)

  4. The use of hot-wire anemometry in studying supersonic slot injection into a supersonic flow

    … air stream (M = 2.91) was studied with a dual hot wire probe. This probe was used to simultaneously determine total temperature and mass flux. Mean profiles across the entire flow field at three axial stations (x/h = 4, 10, 20) were obtained, as well as the temperature and mass flux turbulence …

    vt Repository record for The use of hot-wire anemometry in studying supersonic slot injection into a supersonic flow (opens in a new tab)

  5. Wind Tunnel renovation, flow verification and flapping wing analysis.

    … field produced in the tunnel was analyzed with hot wire anemometry. The turbulence intensity ranged from .7% to .5% for freestream velocities of 2 m/s to 5 m/s. The velocity variation across the test section ranged from .251% to .125%. A model of the NPS MAV was placed in the test section and …

    nps Repository record for Wind Tunnel renovation, flow verification and flapping wing analysis. (opens in a new tab)

  6. Point Doppler velocimetry measurements in circular jets

    … technique with capabilities that are similar to hot wire anemometry, but without inserting a probe into the flow. The insertion of a probe into a flow can affect the flow, resulting in inaccurate measurements.;PDV measurements for 1 inch diameter standard, swirling, and annular jets have been …

    wvu Repository record for Point Doppler velocimetry measurements in circular jets (opens in a new tab)

  7. Investigation of Airfoil Noise Generation Mechanisms at Low-to-Moderate Reynolds Number and Low Angles of Attack

    … microphone measurements, acoustic beamforming, hot-wire anemometry and surface flow visualisation techniques. Single microphone measurements revealed that a strong primary tone was present with several weaker secondary tones, superimposed on a broadband spectrum. Acoustic beamforming was used to …

    adelaide Repository record for Investigation of Airfoil Noise Generation Mechanisms at Low-to-Moderate Reynolds Number and Low Angles of Attack (opens in a new tab)

  8. Characterization of Inertial Particles in the Turbulent Wake of a Porous Disk

    … are compared to sub-inertial tracer particles. Hot-wire anemometry, phase Doppler interferometry and particle image velocimetry were implemented in the near and far wake regions to study the complex dynamics of the particles. Turbulence statistics and particle size distributions are presented …

    portland-state Repository record for Characterization of Inertial Particles in the Turbulent Wake of a Porous Disk (opens in a new tab)

  9. Coherent unsteadiness in film cooling

    … inlet. Particle Image Velocimetry, high speed photography and Hot Wire Anemometry have been used to investigate the jet downstream of both cooling holes. The impact of crossflow at the hole inlet upon the flowfield inside both cooling holes has been investigated using Hot Wire Anemometry and a …

    oxford Repository record for Coherent unsteadiness in film cooling (opens in a new tab)

  10. A Review of Flow Diagnostic Methods and Applications

    … velocimetry techniques such as pitot tubes and hot wire anemometry are discussed along with unintrusive techniques such as Laser Doppler Velocimetry and Particle Image Velocimetry. Density, pressure, and temperature diagnostic methods are also examined, in particular shadowgraph/schlieren …

    ndsu Repository record for A Review of Flow Diagnostic Methods and Applications (opens in a new tab)

  11. Measurements of small-scale statistics and probability density functions in passively heated shear flow.

    … and structure functions, measured with hot wire anemometry for turbulence Reynolds numbers, Relambda, in the range between 140 and 660. The streamwise derivative skewness and flatness agreed with previously reported results in that they increased with increasing Relambda with the …

    ottawa-retro Repository record for Measurements of small-scale statistics and probability density functions in passively heated shear flow. (opens in a new tab)

  12. The measurement of wind tunnel flow quality at transonic speeds

    … obtained in the free stream. Traditionally hot wire anemometry and fluctuating pressure techniques have been used to quantify the unsteady characteristics of a wind tunnel. This research focuses on the application of these devices to the transonic flow regime. Utilizing hot wire anemometry, …

    vt Repository record for The measurement of wind tunnel flow quality at transonic speeds (opens in a new tab)

  13. Multi-Row Film Cooling Boundary Layers

    … including: particle image velocimetry, hot wire anemometry, pressure sensitive paint and discrete gas sampling.

    ucf Repository record for Multi-Row Film Cooling Boundary Layers (opens in a new tab)

  14. Experimental investigation into airfoil self-noise, blade-tower interaction noise and wind farm noise character

    … out in an anechoic wind tunnel (AWT) using hot-wire anemometry and acoustic measurements were conducted in an anechoic room and in the AWT with point microphones and microphone arrays. With hot-wire anemometry, the state of the boundary layer in the wake of trailing edge was determined and …

    unsw Repository record for Experimental investigation into airfoil self-noise, blade-tower interaction noise and wind farm noise character (opens in a new tab)

  15. PRE-SET COUNTER-ROTATING STREAMWISE VORTICES IN WAVY CHANNEL

    … experimentally investigated by means of smoke-wire flow visualization technique and Particle Image Velocimetry (PIV) as well as Hot-Wire Anemometry. The counter-rotating vortices are induced by a zig-zag pattern carved at the leading edge of the wavy surface in order to pre-set uniform size …

    nus Repository record for PRE-SET COUNTER-ROTATING STREAMWISE VORTICES IN WAVY CHANNEL (opens in a new tab) Download file for PRE-SET COUNTER-ROTATING STREAMWISE VORTICES IN WAVY CHANNEL (opens in a new tab)

Page 1 of 8