Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 52 for “"IR-drop"”.
-
Power grid verification and optimization
IR-drop is the voltage drop that is caused by the impedance of power grid and devices' switchings. It is important to verify voltage values of nodes on power grids. To make the circuit work reliably, it is preferable to reduce the voltage drops. Nowadays, power grids are usually in large size, …
-
Power Distribution in Gigascale Integration (GSI)
… in distributing power in a chip are voltage drop and electromigration-induced reliability failures. The voltage drop on the power distribution network is due to IR-drop and simultaneous switching noise. IR-drop is the voltage drop due to current passing through the resistances of the power …
-
Overcoming Device Level Challenges to Enable Compute In-Memory with Emerging Non-Volatile Memory
… properties such as device variation, IR-drop, high write power, and low endurance will persist due to the physical limitations of the devices. As a result, circuit and system level designs must overcome these challenges to enable CIM with eNVM. In this thesis, we characterize these …
-
The role of galvanic coupling effect in determining crevice corrosion morphology
… The concept of a uniform anode/cathodic pair with IR-drop is developed. It is shown that the galvanic coupling effect may play a significant role in crevice corrosion. For a uniform anode/cathode pair with IR-drop, the coupled potential/current relationship is a function of the kinetics on …
-
Design-Technology Co-Optimization of Ferroelectric Devices for Capacitive In-Memory Computing and On-Chip Buffers
… arrays suffer from high static power, serious IR drop, and sneak-path issues. To overcome these challenges, ferroelectric “capacitive” crossbar arrays are proposed in this thesis since the capacitive approach (1) only consumes dynamic power, (2) has no DC sneak paths, (3) avoids IR drop along …
-
Physical design methodologies for monolithic 3D ICs
… 3D ICs is one of the last challenges facing their commercialization. First, a pre-bond testable 3D scan chain construction technique is developed. Next, a transition-delay-fault test architecture is presented, along with a study on how to mitigate IR-drop. Finally, to facilitate partitioning, a …
-
Χωροθέτηση ολοκληρωμένων κυκλωμάτων με παραμέτρους αξιοπιστίας
… μία νέα ιδέα για την υλοποίηση ενός IR-Drop Driven re-Placement μιας σχεδίασης με απώτερο στόχο την βελτίωση του χρονισμού της. Τέλος, στο σημείο αυτό πρέπει να αναφέρουμε πως το προκείμενο εργαλείο εντάσσεται και εναρμονίζεται πλήρως με τις υπάρχουσες ροές σχεδίασης ψηφιακών …
-
Εργαλεία CAD για τον υπολογισμό ισχύος και αξιοπιστίας κυκλωμάτων VLSI
… is also a method for inserting power supply IR-drop effect in this logic level analysis of the digital design. Another chapter deals with power optimization using circuit re-synthesis for leakage power reduction. Finally, a technique is present for soft error rate estimation through …
-
Removal of Kelvin Contactor with soft compensation
… for some of the critical test using this IR drop.
-
Reactions and morphology of silver electrodes oxidized in alkaline solutions and oxidation of model-pore electrodes
Wire, foil, and sintered silver electrodes were oxidized potentiostatically and galvanostatically in aklaline solutions. The experimental data reported here strongly support the dissolution-precipitation mechanism for Ag_2O formation. Many of the oxidized electrodes were examined using a scanning …
-
Power supply noise analysis for 3D ICs using through-silicon-vias
… work also looks into an existing commercial IR drop analysis tool and presents a way to modify it with the aim of handling 3D designs containing TSVs.
-
Fabrication and Evaluation of Boron-Doped CVD Diamond Microelectrodes
… diamond films were grown on etched tungsten wires and were subsequently sealed in glass capillary tubes, The electroactive diamond was exposed either by mechanical polishing or by chemical etching of the glass. The resulting electrodes are referred to as diamond microelectrodes and …
-
Intelligent Circuit Design and Implementation with Machine Learning
… applied at early steps cannot well judge if their solutions may eventually lead to satisfactory designs, inevitably leading to over-pessimistic design or significantly longer turnaround time. While existing challenges have long been unsolved, the ever-increasing complexity of integrated circuits …
-
Interconnect-centric design issues in nanometer IC technology
… of interconnects is towards unfavorable direction. The reduction of wire width causes the resistive effect of interconnects to increasingly deteriorate signal delay and slew. As a result, in nanometer IC designs, the improvement of interconnect performance has gained significant …
-
Electrocapillary Studies Of Reversible Charge Transfer V(Iii)/V(Ii) Electrode
… of Current-time relationship of a single drop, a fast response potentiostat was built by using transistorized chopped stabilized operational amplifiers and precision components in the circuitry with proper compensation for IR-drop in the cell and the electrical double layer capacity. The …
-
Multiphysics modeling and simulation for large-scale integrated circuits
… related to the design of modern integrated circuits (ICs): the ever increasing couplings among the multiphysics and the large problem size arising from the escalating complexity of the designs. A multiphysics-based computer-aided design methodology is proposed and realized to address multiple …
-
Design, layout and placement of on-chip decoupling capacitors in IP blocks
… concerns is power supply noise in the form of IR drop and Ldi/dt effects as clock frequency continues to increase. As supply voltages scale down with technology, and the level of current and its rate of change increases, the noise levels on the supply are increasing to detrimental effect. Power …
-
Methodologies for Modeling and Optimization of 2.5-D and 3-D Integration Architectures for Compute-In-Memory Applications
… for compute-in-memory (CIM) applications. First, design trade-offs in the PDN of bridge-chip based 2.5-D heterogeneous platforms are investigated. It is demonstrated that including a PDN in the bridge-chip can provide significant reduction in DC-IR drop, Ldi/dt noise, and high-frequency …
-
Power distribution network modeling and microfluidic cooling for high-performance computing systems
… simulations. Compared to the conventional air cooling, significant reductions in system temperature and thermal coupling are achieved with the proposed platform. Moreover, the signaling performance is improved due to the reduced temperature, especially for long interconnects on the silicon …
-
Moving Beyond Worst-Case Power Design in Datacenters - Distributed UPS and Dynamic Voltage Scaling for FPGAs
… in datacenters have a poor efficiency due to their back-to-back architecture, especially at light-load. A novel distributed UPS architecture and control scheme are proposed to provide granular local energy backup and increase the system efficiency. Lithium-Ion Capacitors (LIC) and a …
Page 1 of 3