Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 43 for “"Integral Length Scale"”.
-
A comprehension and prediction of wings in unsteady conditions
… study focuses on the impact of varying the integral length scale on the aerodynamic performance of wings at moderate Reynolds numbers. Through experimental investigations using hot wire anemometry, force and moment measurements, particle image velocimetry, and digital image correlation, …
-
Experimental investigation of the performance of a fully cooled gas turbine vane with and without mainstream flow and experimental analysis supporting the redesign of a wind tunnel test section
… the cooling performance of a fully cooled, scaled-up model of a C3X turbine vane. The primary objective was to determine the differences in overall effectiveness in the presence and absence of a hot mainstream flowing over the vane. Overall effectiveness was measured using a thermally scaled …
-
INTERMITTENCY EFFECTS ON THE UNIVERSALITY OF LOCAL DISSIPATION SCALES IN TURBULENT BOUNDARY LAYER FLOWS WITH AND WITHOUT FREE-STREAM TURBULENCE
Measurements of the small-scale dissipation statistics of turbulent boundary layer flows with and without free-stream turbulence are reported for Reτ ≈ 1000 (Reθ ≈ 2000). The scaling of the dissipation scale distribution is examined in these two boundary conditions of external wall-bounded flow. …
-
Investigation of Inlet Turbulence Effects on Mixing Characteristics of a Jet in Crossflow
… effects of crossflow turbulence intensity and integral length scale on mixing remains insufficiently understood. This study uses a non-reacting jet in crossflow (JICF) configuration to represent the mixing process between the flare and crossflow interaction. Using computational fluid dynamics …
-
Numerical Simulation of Turbulent Particle Diffusion
… of anisotropy in turbulent kinetic energy, integral time scale, and integral length scale were included.
-
Landing gear wake-leading edge flap interaction noise reduction through the use of porous screens.
… of the screens. The turbulent intensity and integral length scale also increased. Screen self-noise was identified at a relative high frequency range (above 6 kHz). The frame that supports the porous screens generated self-noise in the mid frequency range (between 1 and 6 kHz). The optimum …
-
Measurement of Turbulent Flame Speeds of Hydrogen and Natural Gas Blends (C1-C5 Alkanes) using a Newly Developed Fan-Stirred Vessel
… independently vary the intensity level and the integral length scale was developed. Where the former changed with fan speeds, increasing the blade pitch angle of the impeller decreased the integral length scale. Turbulent flame speeds of fuels that are of topical interest to gas turbines were …
-
Numerical investigation of turbulent combustion regimes on localized forced ignition using stratified combustible mixture
… initial values of turbulent fluctuations and the integral length scale of turbulence have been modified to bring about the change in Ka. The localized forced ignition is accounted by a source term in the energy transport equation which deposits energy over a time interval. It has been found that …
-
Effects of High Intensity, Large-Scale Freestream Combustor Turbulence On Heat Transfer in Transonic Turbine Blades
… modern gas turbine engine. High intensity, large length-scale freestream turbulence was generated using a passive turbulence-generating grid to simulate the turbulence generated in modern combustors after it has passed through the first stage vane row. The grid produced freestream turbulence with …
-
Large Eddy Simulation and Wavelet Analysis of the Flow Field around a Surface Mounted Prism
Unsteady large-scale vortices, formed by the roll-up of free shear layers separating along sharp edges, are the dominant flow characteristics of the turbulent flow over buildings. These vortical structures interact with each other and with the building surface resulting in secondary separation and …
-
The Physical Mechanism of Heat Transfer Augmentation in Stagnating Flows Subject to Freestream Turbulence and Related Studies
… counter-rotating vortex pairs with decreased integral length scale relative to the imposed freestream turbulence. It is hypothesized that the primary mechanism of heat transfer augmentation is the movement of cooler freestream fluid into the heated near-wall region by these coherent …
-
Experimental Investigation of Premixed Turbulent Hydrocarbon/Air Bunsen Flames
… flame stretch factor, mean turbulent Markstein length and number, and mean fuel consumption rate were systematically evaluated from the experimental data. The normalized preheat zone and reaction zone thicknesses decreased with increasing non-dimensional turbulence intensity in ultra-lean …
-
Effect of Blowing Ratio on the Nusselt Number and Film Cooling Effectiveness Distributions of a Showerhead Film Cooled Blade in a Transonic Cascade
… freestream turbulence intensity of 12% , with an integral length scale normalized by blade chord of 0.26 generated by a passive, mesh turbulence grid. The coolant conditions were varied by changing the ratio of coolant to freestream mass flux, blowing ratio, over three values, BR=0.60, 1.0, and …
-
Boundary layer characteristics just above sub-urban roughness
… of mean wind velocity, turbulence intensity and integral length scale parameters (longitudinal, lateral, and vertical) are not exactly the same as those used in ASCE 7, which considers the ideal case of turbulence above open terrain or well above the roughness. To accomplish this, wind tunnel …
-
Measurements and Assessment of Adiabatic Film Cooling Performance on a Gas Turbine Vane Endwall Using PSP Technique
… effectiveness distributions on the endwall of a scaled up mid-range industrial turbine vane geometry. Experiments are performed in a blow-down wind tunnel cascade facility at the isentropic exit Mach number of 0.5 corresponding to Reynolds number of 3.8 x 105 based on inlet conditions and axial …
-
Structure of Turbulent Flow in a Rod Bundle
… of turbulence in the subchannels of a large-scale 60 degree section of a CANDU 37-rod bundle was studied at Reynolds numbers equal to 50,000, 100,000 and 130,000. Measurements were conducted at roughly 33.81 rod diameters from the inlet of the rod bundle using single-point, two-component …
-
"An Experimental Investigation of Showerhead Film Cooling Performance in a Transonic Vane Cascade at Low Freestream Turbulence"
… turbulence intensity of two percent and an integral length scale normalized by vane pitch of 0.05. The showerhead cooling scheme was tested at blowing ratios of 0 (no cooling), 1.5, and 2.0 and a density ratio of 1.35. Midspan Nusselt number and film cooling effectiveness distributions over …
-
Heat Transfer, Friction, and Turbulent Analysis on Single Ribbed-Wall Square Channel
… Nusselt values were determined after x/Dh=8, and scaled by the Dittus-Boelter correlation, Nuo, for smooth ducts to yield a Nusselt augmentation value (Nu/Nuo). Non-heated friction tests were conducted from a Reynolds number range of 6,000 to 180,000. Pressure drop along the channel was recorded, …
-
Behavior of Turbulent Structures within a Mach 5 Mechanically Distorted Boundary Layer
… The distortion and reorientation of the large-scale coherent motions is quantified through the determination of the integral length scale and local structure angle from two-point correlations. Detection of individual vortices through the swirling strength criterion λci allows the population …
-
Experiments on turbulent flows in rough pipes: spectral scaling laws and the spectral link
… turbulent kinetic energy u2 , the longitudinal integral length scale L11 , and the Kolmogorov length scale η in turbulent rough–walled pipe flows. We document in our rough– pipe flows a striking phenomenon recently discovered in smooth–pipe flows: the occurrence of an outer peak in u+2 (y + ), …
Page 1 of 3