Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 195 for “"Integrated circuits--Design and construction"”.
-
Design of radix 4 divirs using high redundancy in 65 nanometer CMOS technology
… changing, there is a need to explore different design tradeoffs and alternatives. In the old technologies where die area is very important and transistors are slow, it would make sense to avoid an adder for quotient conversion and speed up division by doing on-the-fly conversion – as found in …
-
PHYSICS AND DEVICE DESIGN OF VACUUM INTEGRATED CIRCUITS (CATHODES).
… modeling the fundamental parameters of vacuum integrated circuits (VIC's), a new class of microelectronics devices. A summary of the history of thermionic integrated circuits (TIC's) is presented, along with a discussion of the heater and its effect on device performance. The effects of the …
-
Four input nor gate array for EMCR210
… laboratory project, utilizing a NOR logic array and the existing PMOS process, has been successfully incorporated into the microelectronic engineering curriculum. This paper outlines the structure of this new course. Students are introduced to digital logic and I.C. fabrication by designing a …
-
Symbolic methods in simulation-based verification
… dissertation conducts research in automating the design of digital hard- ware. Specifically we apply symbolic methods in simulation-based functional ver- ification. Simulation, due to its simplicity and close coupling with the electronic design process, has been the prevalent approach to checking …
-
Inverse design and control of thermal systems
This study considers the design of thermal processing systems where the goal is to design a system with the correct geometry and materials, so that together with the necessary energy input from the engineering devices, it would satisfy the needs of the process to be carried out. In some systems, …
-
Design, fabrication, and analysis of enhanced mobility silicon germanium transistors
… based on silicon-germanium were fabricated and measured. PMOSFET with a buried channel of silicon-germanium-carbon was fabricated vii and measured to quantify its characteristics. A new method to calculate hole mobility of a buried channel of silicon-germanium-carbon has been proposed. This …
-
Interconnect-centric design issues in nanometer IC technology
… to increasingly deteriorate signal delay and slew. As a result, in nanometer IC designs, the improvement of interconnect performance has gained significant importance. In interconnect-centric designs, the application of accurate delay models (including interconnect model and gate model) is …
-
Free-Running Ring Oscillators for Crystal-Free Communication Systems: Design, Simulation Challenges, and Frequency Stability Improvements
… clear definitions, conversions methods, and comparative analysis of commonly used figures of merit such as phase noise, Allan deviation, and jitter. The second contribution addresses the challenges of simulating phase noise in free-running ROs. Key techniques including Periodic …
-
Layout Synthesis for Datapath Designs
As datapath chips such as microprocessors and digital signal processors become more complex, efficient CAD tools that preserve the regularity of datapath designs and result in small layout area are required. The standard-cell placement techniques ignore the regularity of datapath designs and hence …
-
A Logic Formulation for the QCA Cell Arrangement Problem
… denser IC's that switch at higher frequencies and run on lower power. QCA's most basic building block, the QCA cell, is inherently binary; digital circuits are implemented by arranging these QCA cells in pre-defined configurations on a two dimensional plane. This paper proposes a logic …
Page 1 of 10