Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 57 for “"Intercept point"”.
-
Analysis of Intermodulation Distortion for MESFET Small-signal Amplifiers
… third-order intermodulation distortion power and intercept point for a MESFET small-signal amplifier are derived when its equivalent circuit is bilateral and includes the gate-to-drain capacitance (Cgd) explicitly as a nonlinear element. Previously developed analytical expressions treated Cgd as a …
-
PMODFET and NMOSFET broadband mixer design
… low conversion loss and high input third order intercept point(IIP3), and in order to compare the flicker noise of NMOSFET to PMOSFET. These mixers were designed for wireless applications with RF and IF frequency ranges of I to 3 GHz, and DC to 50 MHz, respectively. The mixer design process as …
-
Automatic test system for characterizing radio frequency amplifiers
… Parameters (S-parameters), 1dB Compression Point (P1dB) and Third-Order Intercept Point (IP3).
-
Σχεδίαση ενεργού CMOS μίκτη σε τεχνολογία 65nm
… εισόδου στο σημείο τομής τρίτης τάξης (Input Intercept Point 3) -1dbm.
-
Nonlinear Analysis and Digital Pre-Distortion of the SC-FDMA Signals in LTE Uplink System
… power efficiency. Working beyond the saturation point is the main reason for power amplifiers having nonlinear properties; 2) In order to obtain adequate capacity, wide bandwidth is applied to the latest communication systems. Since in previous systems the pre-distorter would focus on memory-less …
-
Design of sub-mW RF CMOS low-noise amplifiers
… of 22.7dB, noise figure (NF) of 2.8dB, 3rd-order intercept point (IIP3) of +5.14dBm, and ldB compression point (PldB) of-10dBm, while consuming 943µW from a I V supply. The main contributions of this work include: i) the introduction of a design methodology for power-efficient sub-mW source …
-
A NOVEL CMOS IC SENSOR FOR REMOTE RF SIGNAL SENSING
… were developed to maximize the third-order intercept point, and suppress flicker noise for the LNAs and GCMs, resulting in improved sensing accuracy. The overall system-level evaluation results showed state-of-art angle-of-arrival sensing capability with an upper limit error of 3.447°.
-
CMOS bulk-driven mixers with passive baluns
… a measured input-referred 1-dB compression point (P1dB) of −14 dBm, an input-referred third-order intercept point (IIP3) of −5.2 dBm, a gain of 13.6 dB, a noise figure (NF) of 26 dB, and an LO-to-RF isolation of 50 dB. The overall performance of both mixers is found to be comparable with …
-
AUTONOMOUS GUIDANCE ALGORITHM FOR HETEROGENEOUS UNMANNED SURFACE VESSEL FLOTILLA OPERATIONS
… govern decentralized formation-keeping, threat intercept and flotilla evasion, integrated with target motion analysis and stochastic combat modeling for an organic anti-air (AA) escort. Through 984 Monte Carlo simulation iterations across six distinct tactical scenarios, the research evaluated …
-
Structured LNA Design for Next Generation Mobile Communication
… than 17 dB, input referred P1dB compression point of -10 dBm and input third order intercept point (IIP3) of around 0.015 dBm with 75 mw power consumption. The good agreement between simulated and measured results proved the viability of the design for next generation mobile communication LTE …
-
A low power, high dynamic-range, broadband variable gain amplifier for an ultra wideband receiver
… for the entire range of gain. The 3rd-order intercept point (IIP3) is above -13.6dBm for 1Vpp differential input and output voltages. These low distortion broadband features benefit from the large linear range of the differential pair with source degeneration and the low impedance internal …
-
Hit-to-kill guidance algorithm for the interception of ballistic missiles during the boost phase
… transfer from a surface-launched missile upon interception to a ballistic missile target during the boost phase of flight. Mathematical models of a North Korean Taep'o-dong II (TD-2) medium-range ballistic missile and a Raytheon Standard Missile 6 (SM-6) interceptor are used to demonstrate the …
-
Characterizing and minimizing nonlinearities responsible for intermodulation distortion in high speed and high power photodiodes
… nonlinearity on the photodiode. The third-order intercept point (IP3) was determined to be approximately 27.5 dB, illustrating its slight nonlinearity. For both the frequency and the IMD3 plots, it was shown that modulation bandwidth is predominantly RC-limited and that the stated assumptions …
-
Performance Characterization of USRPs
… such as determination of 1-dB compression point, Third order intercept point helped understand the linearity range of the device under transmitter and receiver operations. The 3rd order input intercept point for USRPN210 device with WBX board with calibration was found to be around 0.25 …
-
Spectrum Regrowth for OFDM-based LTE and WIMAX Systems
… is usually described by IP3 (the third-order intercept point). However, there is need of a clear relationship or expression between the out-of-band power emission level and IP3 for LTE and WiMAX Systems, which helps the RF designers to choose components. This thesis presents the analysis of …
-
Inductorless balun low-noise amplifier (LNA) for RF wideband application to IEEE 802.22
… (with 2.4 dB min figure), an input third-order intercept point (IIP3) > 3.3 dBm (7.6 dBm max.) and an input power reflection coefficient S11 < -16 dB. When optimized for best NF, it achieves a voltage gain > 24.7 dB (power gain > 19.8 dB), a NF < 2 dB over the entire band, an IIP3 > -0.3 dBm and …
-
Design of an automatic landing system for twin rotor vertical take-off and landing unmanned air vehicle
… need for an algorithm to locate an appropriate intercept point on the intended flight profile after a position error is found after navigation system switchover from waypoint mode, using GPS, to the more precise autoland mode, which uses DGPS. With the establishment of concrete target points, a …
-
Power Spectrum Prediction of Amplified Dual-Band LTE-Advanced Signals
… a power amplifier, which means the third order intercept point (IP3) can be measured from the two-tone test. Through the two-tone test, researchers have proposed some formulae to present what the amplified Code Division Multiple Access (CDMA) signal is like. They derived formulae in terms of …
-
Gallium Nitride Phase Shifters
… than 1.03 dB across X-band. The 1 dB compression point was higher than the laboratory equipment was able to measure (>38 dBm) and the phase shifter monolithic microwave integrated circuit (MMIC) exhibited an input-referred third-order intercept point (IIP3) higher than 46 dBm. A K-band phase …
-
Understanding distortion in silicon-germanium transistors, and its application to RF circuits
… linearity is the Input/Output Third Order Intercept Point (IIP3/OIP3), which represents the input/output power level at which the power of fundamental frequency (PFUND) become equal to that of the third-order intermodulation product (P3rd). Clearly, a higher IIP3 number yields improved …
Page 1 of 3