Global ETD Search
Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.
Results
Showing 1 to 20 of 25 for “"Kiln Drying"”.
-
Kiln drying optimization for quality hem-fir lumber
… content difference resulting in increased drying defects and decreased lumber quality and factory productivity. In this study, application of green chain moisture-based sorting coupled with drying schedule modifications were considered as ways to improve final moisture content variation …
-
Moisture Gradient Measurement During Kiln Drying of Red Oak
The key to improving drying quality and reducing drying time and energy consumption lies in understanding and controlling moisture movement during drying. As wood dries, strains and stresses develop as a result of restraints imposed by moisture gradients and differential shrinkage in wood. So …
-
Kiln drying using a double duty thermostatic temperature control
Thesis--Michigan Agricultural College, 1914
-
Kiln drying problems and issues in Canada benchmarks and comparison to Europe
Kiln drying represents a vital step in wood products processing. When properly employed, it ensures that subsequent problems with wood applications are minimized and high quality material is produced. Despite the importance of the wood products industry for Canada, scarce information currently …
-
Radio frequency heating pre-treatment of sub-alpine fir to improve kiln drying
… and time combinations as pre-conventional kiln treatment on the drying characteristics and quality of sub-alpine fir lumber. As a consequence of this objective, the study hypothesis was formulated as: “if RF heating improves the permeability of sub-alpine fir, then upon kiln drying, final …
-
A study of the kiln drying of lumber from cottonwood (Populus deltoides Marshall)
Thesis (M.S.)--Michigan State College of Agriculture and Applied Science. Department of Forestry, 1941
-
Internal moisture movement in hem-fir timbers exposed to ambient conditions following kiln drying
… of high-value hem-fir timbers after kiln drying while exposed to two different local outdoors seasonal conditions for a period of time of few weeks. Hem-fir is the most abundant species in coastal British Columbia, Canada, and high-quality thick hem-fir timbers used as construction …
-
The drying of lumber in a fluidized bed of inert solids
The use of fluidized beds of hot inert solids for drying wood is a relatively new concept. Recent investigations on fluidized bed drying of thin veneer (1,2) have shown that more rapid drying can be achieved by this method than by conventional means. In the present work, blocks of Western Hemlock …
-
Evaluation of Methods to Control Mold on Hardwood Pallets
… project were:<br />1.����To compare the drying cost and drying time for oak and poplar pallets for the following mold mitigation strategies for hardwood pallets: air drying, forced air drying (fan shed), kiln drying to 25% moisture content and chemical treatment, and<br …
-
Relationship of bacterial infection and stress wave travel time in red oak lumber
… and develop or aggravate ring failure during drying. It also extends the drying time. Bacterial infection is hard to identify before drying without the use of costly, time- consuming tests. Thus, there is a need for an inexpensive, rapid and accurate method for the identification that can be …
-
Mechanical seed extraction of lodgepole pine
… affect seed extraction by both conventional kiln drying techniques and by mechanical means. This information provided a basis for systematic design of specific processing tools for a portable continuous flow mechanical seed extraction system. Cone scale deflection was characterized and its …
-
Quality control methods for monitoring the variability of moisture content in kiln-dried lumber
… in lumber is a problem of utmost importance in kiln-drying. This thesis focused on determining the distribution of moisture content in lumber, and on the application of statistical process control principles to monitor the drying process through the use of quality control charts. Specific …
-
Development of an in-kiln monitoring system based on acoustic emission rates of wood during the low-temperature drying process
… purpose of this study was to determine if an in-kiln monitoring system based on the acoustic emission rates of wood as it dries could be developed to monitor the traditional kiln drying process. Recording the acoustic emission rates for each of the kiln steps and then analyzing the recorded data …
-
Adhesion Fundamentals in Spotted Gum (Corymbia citriodora)
… not Gympie messmate. This suggests conventional kiln drying appears unsuitable for spotted gum while amenable for Gympie messmate. Spotted gum likely requires non-aqueous, low surface tension adhesives or aqueous adhesives formulated with surface active wetting agents. Water-saturation (followed …
-
Drying and heat treatment process of bamboo strips
… must be dried to moisture contents below 10%. Drying determines both the productivity and quality of laminated bamboo, but is currently very inefficient due to limited understanding of many critical phenomena. This thesis investigates the fundamentals and industrial practice of bamboo strip …
-
Estimating the final moisture content variation in kiln-dried Pacific coast hemlock
Kiln drying is indisputably a significant value-adding step in timber processing where the importance of predicting moisture within a dried batch cannot be overemphasized. Among timber drying quality indices, the uniformity of final moisture content within a drying timber batch is crucial. Lack of …
-
Exploratory study of the effect of oscillation drying on thick hemlock timbers
… aimed at exploring the effect of oscillating the drying temperatures of a drying schedule on the drying characteristics of thick western hemlock timbers. Pacific coast hemlock which is comprised of about 70% western hemlock (Tsuga heterophylla (Raf.) Sarg.) is one of the best quality and most …
-
Impact of juvenile wood on the drying characteristics of Pacific Coast Hemlock structural timber
… wood without including interactions with other drying factors. For that reason, this investigation evaluates the drying quality of the mix of 105 mm square timbers from second-growth western hemlock (Tsuga heterophylla) and amabilis fir (Abies amabilis), commercially known as Pacific Coast …
-
Coniferous tree seed germination with particular reference to the effects of temperature, seed moisture and stratification on germination behaviour of western hemlock seed
… of the extraction process, such as cone storage, kiln drying and dewinging. In the discussion of the germination test procedure the importance of a moist-cold pretreatment or "stratification" is indicated. It is shown, that many species of coniferous seed are subjected to such treatment in nature. …
-
Molecular analysis and physiological roles of subtilases in sapstaining fungi
… of effectiveness desired by the industry. Kiln drying is expensive and not always practical and the rewetting of wood during transport can allow subsequent fungal growth and stain production. Current biological control agents are also unsatisfactory as they are unreliable and do not grow …
Page 1 of 2