Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 8 of 8 for “"Lift-Fan"”.

  1. Design of a lift fan engine for a heavy lift aircraft

    e lift fan engines. The modification is important because a design that uses current technology is more likely to be brought into service in the near future. This thesis documents the process required to use current technology in a lift fan engine for a heavy lift aircraft. The process uses current …

    nps Repository record for Design of a lift fan engine for a heavy lift aircraft (opens in a new tab)

  2. Refinements of the seal subroutines and fan air flow maps for the XR-3 loads and motion program

    … Loads and Motion computer program are made. New lift fan performance maps are developed and presented. Comparison studies of simulated performance of the original XR-3 model with the old and new fan maps are made under varying sea conditions. Measured roll and pitch transient behavior of the XR-3 …

    nps Repository record for Refinements of the seal subroutines and fan air flow maps for the XR-3 loads and motion program (opens in a new tab)

  3. An analysis of the stick fixed dynamic stability of a typical VTOL aircraft during transition flight out of ground effect

    … simulation. The Ryan Aeronautical Company XV-5A Lift Fan Research Aircraft was used as a basis for the analysis. Wind tunnel tests on a simple 1:24 scale model of the aircraft provided static aerodynamic data throughout the angle-of-attack range -90° < c:>< w +90°. Non-dimensional stability …

    nps Repository record for An analysis of the stick fixed dynamic stability of a typical VTOL aircraft during transition flight out of ground effect (opens in a new tab)

  4. Strut and wall interference on jet-induced ground effects of a STOVL aircraft in hover

    … Cold air jets were used to simulate both the lift fan and the twin rear engines. Nozzle Pressure Ratios were used that closely represented those used on the LSPM tests. The flow visualization data clearly identified a shift in the stagnation line location for both the strut and the wall …

    nps Repository record for Strut and wall interference on jet-induced ground effects of a STOVL aircraft in hover (opens in a new tab)

  5. An experimental investigation of jet-induced ground effects and support strut interference on a STOVL configuration in hover

    … generic jet-powered STOVL aircraft with both the lift fan and the main engine simulated by air jets, with nozzle pressure ratios closely matching those of the large scale tests, was utilized. The flow visualization data clearly identified an aft shift in the stagnation line location for both strut …

    nps Repository record for An experimental investigation of jet-induced ground effects and support strut interference on a STOVL configuration in hover (opens in a new tab)

  6. Viability of Cross-Flow Fan with Helical Blades for Vertical Take-off and Landing Aircraft

    The cross-flow fan (CFF) is a lifting and propulsion device that retains the advantages of a fixed-wing aircraft by using a ducted lift fan. There is no upper limit to the rotor length-to-diameter ratio of a CFF, allowing the device to be installed along the length of the wing or lifting device. …

    nps Repository record for Viability of Cross-Flow Fan with Helical Blades for Vertical Take-off and Landing Aircraft (opens in a new tab)

  7. Conceptual Design Methodology for the Fan-in-Wing VTOL Aircraft

    The Fan-In-Wing (FIW) aircraft concept is one of the most compelling solutions for missions demanding jet-like cruise speeds and Vertical TakeOff and Landing (VTOL) capability. However, despite years of interest and documented improvements in lift-fan technology, there exists little in the way of …

    embry-riddle Repository record for Conceptual Design Methodology for the Fan-in-Wing VTOL Aircraft (opens in a new tab)

  8. Analysis of Spread Multi-Jet VTOL Aircraft in Hover

    An investigation of VTOL aircraft lift losses in hover has been conducted to evaluate a method for a simplified test technique. Three flat plate models were tested to determine their usefulness in predicting hover characteristics by comparing results between plate and three­ dimensional models. …

    odu Repository record for Analysis of Spread Multi-Jet VTOL Aircraft in Hover (opens in a new tab)