Global ETD Search

Search theses and dissertations gathered from participating repositories worldwide. Every result links back to the library that holds it. No account is needed.

Results

Showing 1 to 19 of 19 for “"Lifted Flames"”.

  1. Flow characterization of lifted flames in swirling, reacting flows

    … swirl combustion aerodynamically stabilized flames are sometimes observed and desirable as they potentially reduce hardware heat loadings. However, their understanding is largely phenomenological and geometry specific. First, aerodynamically stabilized flames are subject to flow perturbations …

    gatech Repository record for Flow characterization of lifted flames in swirling, reacting flows (opens in a new tab)

  2. Direct numerical simulation of lifted flames in diesel engine conditions

    … configuration of two-dimensional laminar lifted flame is considered first. The response of the flames to inlet velocity and scalar dissipation rate is studied. The flames transition from attached, to lifted propagation stabilised to lifted ignition stabilised upon increasing the inlet …

    unsw Repository record for Direct numerical simulation of lifted flames in diesel engine conditions (opens in a new tab)

  3. Investigation of Ozone Initiated Ethylene Oxidation at Room Temperature: Chemistry and Flame Dynamics

    … laminar flame dynamics is studied. Stable C2H4 lifted flames are established with oxygen/nitrogen co-flow at reduced oxygen content conditions. By adding certain amounts of O3 into the oxidizer co-flow, non-monotonic flame dynamic behaviors are recorded. Depending on the initial value of the …

    gatech Repository record for Investigation of Ozone Initiated Ethylene Oxidation at Room Temperature: Chemistry and Flame Dynamics (opens in a new tab)

  4. Characterization of the Reacting Jet of a High-Pressure Axially Staged Combustor

    … for a non-premixed configuration, the flame is lifted further downstream and burns at its core compared to the fully premixed configuration. The results also demonstrate these highly lifted flames provide a significant improvement in NOx formation of the axial stage. For conditions where the …

    ucf Repository record for Characterization of the Reacting Jet of a High-Pressure Axially Staged Combustor (opens in a new tab)

  5. In Situ Flame Structure Imaging of Composite Propellants using High-Speed Planar Laser-Induced Fluorescence

    … propellants burning at 1 atm display jet-like flames above individual coarse AP crystals. If the coarse AP concentration is high enough, group diffusion flames are seen where many coarse AP particles burn with one diffusion flame. At elevated pressures lifted arched diffusion flames are often …

    purdue-thes Repository record for In Situ Flame Structure Imaging of Composite Propellants using High-Speed Planar Laser-Induced Fluorescence (opens in a new tab)

  6. Investigation of Conditional Source-Term Estimation Approach for Turbulent Partially Premixed Combustion Modelling

    … well documented turbulent partially premixed flames. The canonical example of partially premixed flames is represented by turbulent lifted flames. A series of lifted turbulent jet flames is investigated in RANS by using DCSE. The DCSE calculations are successful in predicting the lift-off …

    waterloo Repository record for Investigation of Conditional Source-Term Estimation Approach for Turbulent Partially Premixed Combustion Modelling (opens in a new tab)

  7. On the stability of low-swirl non-premixed biogas flame: effects of burner geometry and oxygen enrichment

    … the stabilization of non-premixed biogas flames in a low-swirl burner, focusing on the combined effects of oxygen enrichment and burner geometry. Controlled experiments were performed using bluff-body (BB) and nonbluff- body burner configurations (NBB) with both ambient-air and …

    manitoba Repository record for On the stability of low-swirl non-premixed biogas flame: effects of burner geometry and oxygen enrichment (opens in a new tab)

  8. On the stability of a turbulent non-premixed biogas flame: effect of swirl strength and fuel nozzle geometry

    … and its stability limits for both attached and lifted flames. The experimental results revealed that at low swirl strength the attached flame lifts off and stabilizes at a distance above the burner, while at high swirl strength the flame remains attached but shortens and burns blue. Overall, the …

    manitoba Repository record for On the stability of a turbulent non-premixed biogas flame: effect of swirl strength and fuel nozzle geometry (opens in a new tab)

  9. Fuel flexible clean combustion of liquid fuels by a novel twin fluid atomization

    … Increase in pressure also produced less lifted flames with increased yellow zones. Finally, combustion performance of VO is investigated at elevated pressures. Compared to diesel, VO produced larger flames exhibiting more distributed combustion and lower NOx emissions. At high pressures …

    alabama Repository record for Fuel flexible clean combustion of liquid fuels by a novel twin fluid atomization (opens in a new tab)

  10. Spray Flame and Exhaust Jet Characteristics of a Pressurized Swirl Combustor

    … describes an investigation of swirl-stabilized flames, created in a combustor featuring co-annular swirling airflows, under unenclosed, enclosed, and submerged conditions. A centrally-located fuel nozzle, which uses air-assist atomization, creates a methanol fuel spray. This approach provides …

    maryland Repository record for Spray Flame and Exhaust Jet Characteristics of a Pressurized Swirl Combustor (opens in a new tab)

  11. Determination of flame characteristics in a low swirl burner at gas turbine conditions through reaction zone imaging

    … parameters on the location and shape of lifted flames in a Low Swirl Burner (LSB). In addition, it details the development and analysis of a CH PLIF imaging system for visualizing flames in lean combustion systems. The LSB is studied at atmospheric pressure using LDV and CH PLIF. CH* …

    gatech Repository record for Determination of flame characteristics in a low swirl burner at gas turbine conditions through reaction zone imaging (opens in a new tab)

  12. Investigation of Mixing Models and Finite Volume Conditional Moment Closure Applied to Autoignition of Hydrogen Jets

    … coupled, allowing for simulations of steady flames or flame development after the occurrence of autoignition. Through testing of a steady jet flame, it is observed that the flowfield calculations follow typical k − epsilon model trends, with an overprediction of spreading and an …

    waterloo Repository record for Investigation of Mixing Models and Finite Volume Conditional Moment Closure Applied to Autoignition of Hydrogen Jets (opens in a new tab)

  13. Large Eddy Simulation of Partially Premixed Flames using Doubly Conditional Source-term Estimation

    … is applied on a series of methane turbulent lifted flames. The predictions show very good agreement with the experimental data, and the qualitative analysis is consistent with triple flame characteristics. A series of methane-piloted partially premixed flames is investigated in LES by using …

    waterloo Repository record for Large Eddy Simulation of Partially Premixed Flames using Doubly Conditional Source-term Estimation (opens in a new tab)

  14. Hydrogen-Diesel Dual-Fuel Combustion in Compression-Ignition Conditions

    … interaction to achieve H2 ignition, with a lifted flame observed under the lowest ambient O2 condition of 10 vol.%. The lift-off response is influenced by the relative injection duration of the fuels, likely from the interaction between the incoming H2 jet and diesel combustion products. …

    unsw Repository record for Hydrogen-Diesel Dual-Fuel Combustion in Compression-Ignition Conditions (opens in a new tab)

  15. Application of Multilateral Jet for Partial Pre-Mixing

    … jet mixing to produce partially premixed flames is studied in this thesis. Partially premixed flames are ubiquitous in many practical combustion systems, whilst controlled partially premixed flames are more stable and resilient towards extinction. It is hypothesized that, better control of …

    adelaide Repository record for Application of Multilateral Jet for Partial Pre-Mixing (opens in a new tab)

  16. Flame Stabilisation in the Transition to MILD Combustion

    … in premixed reactors and non-premixed flames. In this study, definitions of MILD combustion are compared and contrasted, with the phenomenological premixed description of MILD combustion extended to describe non-premixed flames. A simple criterion is derived analytically which offers …

    adelaide Repository record for Flame Stabilisation in the Transition to MILD Combustion (opens in a new tab)

  17. Effect of Hydrogen Blending in Industrial Flames

    … was shown to reduce radiant heat transfer from flames and increase NOx emissions. The overall visibility of the flames decreased as hydrogen was added and the typical lifted flames became reattached to the burner. Compared with natural gas, the results with hydrogen showed a 33% reduction in the …

    adelaide Repository record for Effect of Hydrogen Blending in Industrial Flames (opens in a new tab)

  18. Conditional Moment Closure Methods for Turbulent Combustion Modelling

    … of high-pressure fuel jets, and to piloted and lifted turbulent jet flames using classical and advanced CMC submodels. A Doubly-Conditional Moment Closure (DCMC) formulation is further proposed. In the first study, CMC is applied to investigate the impact of C₂H₆, H₂ and N₂ additives on the …

    waterloo Repository record for Conditional Moment Closure Methods for Turbulent Combustion Modelling (opens in a new tab)